反应性抗菌整理剂的合成及其抗菌性能研究

本文以2,4,4′-三氯-2′-羟基二苯醚以及其磺化产物SDP为抗菌有效组分,合成了含一氯均三嗪活性基的反应性抗菌整理剂;并作了波谱分析(UV,IR,MS)和元素分析。这类抗菌整理剂可方便地用于纤维素纤维的抗菌整理,且整理后的织物具有优异的抗菌性能和耐洗坚牢度。例如:按AATCC-100法,经反应性抗菌整理剂2RSDP整理后的织物对金黄色葡萄球菌、大肠杆菌和绿脓杆菌的减菌率分别达到98.5％,98.86％和96.67％;经60℃、100次以上皂洗其减菌率仍保持在90％左右。因而,具有实际应用、开发的价值。同时,本文也初步探讨了所合成的反应性抗菌整理剂的结构与抗菌性能关系。     

2,6-二甲基-3,5-二氯-4-吡啶醇的合成及其抗球虫作用的研究

以双乙烯酮为原料,经二聚合反应,得脱氢醋酸。再由脱氢醋酸分别经水解、氨化、氯化反应(总收率26.97%)或高压氨化、氯化反应(总收率39.52%)制得文题化合物(m.p.345℃)。药理试验表明其毒性较低(LD_(50)>10g/kg)。用作饲料添加剂可明显提高鸡的增重率,降低死亡率,防治球虫病。     

一氯片呐酮与1,2,4—三唑缩合条件的研究

对—氯片呐酮与1,2,4—三唑缩合为1—(1,2,4—三唑基—1) —片呐酮时的分子比、溶剂、缚酸剂、反应时间等条件进行了研究,得到一种适合放大应用于工业生产的以乙醇为溶剂的最佳缩合条件。     

Reactions Between Humic Acid Solutions and Excessive ClO2 or Cl2

Reactions between humic acid solutions and excessive ClO2 or Cl2 have been investigated. Under various experimental conditions, the removal efficiency of TOC, UV254 and A140 from humic acid solutions were examined. The relationship between the removal efficiency and the consumption of ClO2 or Cl2 was discussed. The results showed that the maximum demand of ClO2 was 2.19 mg/mg TOC for the humic acid solution under the experimental conditions, and that of Cl2 was 1.88 mg/mg TOC. The variation tendency of ClO2 consumption was similar to that of Cl2. TOC of humic acid solutions decreased 15.2% and 15.6% after the reaction with ClO2 or Cl2 respectively. Under the experimental conditions, 21.4% of unsaturated bonds and 52.8% of humic acid color were removed by ClO2 in 168 h. As for Cl2, removal efficiency of unsaturated bonds and humic acid color were 16.8% and 41.7% respectively. Larger molecules from humic acid were oxidized to smaller molecules by ClO2 and Cl2. Higher oxidation potential of ClO2 than that of Cl2 was also indicated by variation of UV254/A410 ratios. The similar tendency, that exhibited faster variation in the initial 24 h, existed for all the research factors.     

(R)-(-)-3-氯-1,2-丙二醇合成(R)-(-)-3-氯-2-羟丙基对甲苯磺酸酯的研究

以(R)-(-)-3-氯-1,2-丙二醇为原料合成了医药中间体(R)-(-)-3-氯-2-羟丙基对甲苯磺酸酯,探讨了反应温度、反应时间、溶剂种类及用量、催化剂种类及用量,以及原料配比等因素对反应的影响.通过正交试验确定了适宜的合成工艺条件:反应温度0℃;反应时间6 h;对甲苯磺酰氯与(R)-(-)-3-氯-1,2-丙二醇摩尔比为1.2∶1;催化剂NaOH与(R)-(-)-3-氯-1,2-丙二醇的摩尔比为1.2∶1;以乙酸乙酯为溶剂,(R)-(-)-3-氯-1,2-丙二醇浓度为125 g/L.在此工艺条件下产物得率大于85%.     

三聚氰胺改性脲醛树脂化学结构及反应过程的13C-NMR研究

通过13C-NMR可以很好地解析采用传统工艺(碱-酸-碱工艺)合成三聚氰胺改性脲醛树脂反应过程中的结构变化,并可推测其发生的反应.结构分析表明:在保温反应开始阶段,尿素与甲醛之间的反应主要为加成反应,产物以一羟甲脲和二羟甲脲为主,并有少量三羟甲脲生成;三聚氰胺与甲醛的加成反应产物为一羟甲基三聚氰胺和二羟甲基三聚羟胺;缩聚反应已经发生,一羟甲脲,一羟甲基三聚氰胺,一羟甲脲与一羟甲基三聚氰胺间的缩聚反应已经开始,分子间以醚键和次甲基键连接为主.保温反应结束直到整个反应结束,缩聚反应为主要反应类型,三聚氯胺改性脲醛树脂中存在着3种反应体系:尿素甲醛的反应体系、三聚氰胺甲醛反应体系和三聚氯铵尿素甲醛共缩合反应体系.     

荧光试剂衍生化液相色谱分析生物检材中的氟乙酸钠

建立了使用新的荧光衍生试剂9-氯甲基蒽(CA)衍生化生物检材中的氟乙酸钠,并通过薄层色谱和荧光检测的高效液相色谱(HPLC)分析的方法。合成得到氟乙酸钠的荧光衍生物——氟乙酸-9-亚甲基蒽酯(MA-MFA),纯度达到98%以上,通过红外光谱、核磁共振、元素分析和质谱对其进行结构表征。薄层色谱中展开剂为石油醚/乙酸乙酯(体积比为95∶5),检测限为5×10-8g(TLC)。高效液相色谱用AgilentHypersilODS反相色谱柱,以乙腈/水(体积比为85∶15)为流动相,荧光检测波长λex为256 nm,λem为412 nm。方法在2.5×10-9~125×10-9mol/mL浓度范围内呈良好的线性关系,线性相关系数为0.9988,生物样品空白添加实验的回收率为83%~90%,最低检测限为2×10-10g(S/N=3),日内、日间RSD均小于4%。该方法用于中毒死亡者的血液样品及其他检材的测定,效果良好。     

Preparation of Zn-doped TiO2 nanotubes electrode and its application in pentachlorophenol photoelectrocatalytic degradation

Zn-doped titanium oxide （TiO2） nanotubes electrode was prepared on a titanium plate by direct anodic oxidation and immersing method in sequence. Field emission scanning electron microscopy （FESEM） showed that the Zn-doped TiO2 nanotubes were well aligned and organized into high density uniform arrays with diameter ranging from 50 to 90 nm. The length and the thickness were about 200 and 15 nm respectively. TiO2 anatase phase was identified by X-ray diffraction （XRD）. X-ray photoelectronspectroscopy （XPS） indicated that Zn ions were mainly located on the surface of TiO2 nanotubes in form of ZnO clusters. Compared with TiO2 nanotubes electrode, about 20 nm red shift in the spectrum of UV-vis absorption was observed. The degradation of pentachlorophenol （PCP） in aqueous solution under the same condition （initial concentration of PCP： 20 mg/L; concentration of Na2SO4：0.01 mol/L and pH： 7.03） was carried out using Zn-doped TiO2 nanotubes electrode and TiO2 nanotubes electrode. The degradation rates of PCP using Zn-doped TiO2 nanotubes electrode were found to be twice and 5.8 times as high as that using TiO2 nanotubes electrode by UV radiation （400 μw/cm^2） and visible light radiation （4500 μw/cm^2）, respectively. 73.5% of PCP was removed using Zn-doped TiO2 nanotubes electrode against 45.5% removed using TiO2 nanotubes electrode in 120 min under UV radiation. While under visible light radiation, the degradation efficiency of PCP was 18.4% using Zn-doped TiO2 nanotubes electrode against 3.2% using TiO2 nanotubes electrode in 120 min. The optimum concentration of Zn doping was found to be 0.909%. The PCP degradation efficiencies of the 10 repeated experiments by Zn-doped TiO2 nanotubes electrode were rather stable with the deviation within 3.0%.     

氯化亚铜-三乙醇胺催化合成1,1,1,3,3-五氯丙烷

以四氯化碳和氯乙烯为原料,在催化剂氯化亚铜和助催化剂三乙醇胺作用下,通过自由基加成反应合成出1,1,1,3,3-五氯丙烷.考察了溶剂、催化剂和助催化剂对合成反应的影响,以及催化剂和助催化剂的相互作用后发现,助催化剂三乙醇胺的使用使反应得率提高了14%以上.用紫外吸收分光光度法检测加入三乙醇胺的Cu2Cl2乙腈溶液,发现波长向紫外方向移动,且随着三乙醇胺加入量的增加,吸光度(ABS值)也随着增加,且吸收最大波长稳定在204 nm;三乙醇胺的加入量与吸光度(ABS)成正比,符合朗伯-比尔定律.研究证实了Cu2Cl2和三乙醇胺络合物的形成.络合物的形成,使溶液中Cu2Cl2的浓度提高,催化活性中心增加,有效的提高了产物得率.     

油/水两相水解精制六氯环三磷腈的研究

提出了油/水两相水解法精制六氯环三磷腈工艺。将4 g粗六氯环三磷腈溶于30 mL石油醚(90~120℃)中,按1∶2(mL/mL)的油水比加入蒸馏水,温度60℃下剧烈搅拌8 h,5℃水中结晶,精制六氯环三磷腈纯度达98.3%,收率76.1%。