基于径向基函数神经网络的滚动轴承故障模式的识别

The impacts of different groove shapes, numbers, and angle of friction dish on transmitting torque, speed, push pressure in wet speeding clutch are discussed in this paper. Since the wet speeed governing clutch works within hydrodynamic lubrication mixture lubrication. boundary, lubrication and contact situation, the oils combining with a-hydrocarbon or polyester are getting widely used as lubricant.The power-law fluid model with Patir-Cheng average flow model, GT asperity contact model and oil film inertia are applied for average Reynolds equation setting, In order to investigate the relationship between average push pressure within hydrodynamic lubrication and mixture lubrication, average transmitting torque and output speed, the numeral calculation and analysis are presented. According to calculation, it is found that the groove shape, groove angle and groove numbers affect the average transfer torque and push pressure with the speed rate.     

Geochemical study and significance of sequential extraction in reservoir rocks of Turpan-Hamin Basin

Seven samples collected from the Turpan-Hamin Basin were treated by sequential extraction method. Analytical results indicate that the free oils, inclusion oils (oil-bearing fluid inclusions) and clay-adsorbed oils vary significantly. The geochemical characteristics of inclusion and clay-adsorbed oils correlate well with the lacustrine mudstones. The characteristics are as follows: (i) with higher Ph/nC18 ratio and lower Pr/Ph ratio; (ii) with higher values of C26 tricyclic/C24 tetracyclic terpane, C23 tricyclic ter-pane/(C23 tricyclic terpane+C3017α(H) hopane), C21/(C21+C29) sterane, Ts/Tm and C29Ts/C29l7α(H) norhopane and lower value of C19/C21 tricyclic terpane; (iii) with relatively high content of C27 and C28 sterane and lower abundance of C29 sterane and diasterane. They indicate that the early charged oils are derived from the pre-Jurassic lacustrine mudstones and the later charged oils are from the Jurassic coal-bearing strata or coals.     

海上M稠油油田吞吐后续转驱开发方案研究

针对目前渤海地下原油黏度大于350 mPa·s的非常规稠油水驱采收率较低,且考虑到吞吐轮次及平台寿命的问题,开展吞吐后续转驱开发方式研究。以海上M稠油油田为例,利用油藏数值模拟方法对蒸汽吞吐转蒸汽驱、热水驱及多元热流体吞吐转多元热流体驱、热水驱等4种转驱方式的转驱时机及注采参数进行优化设计及对比分析。结果表明,蒸汽吞吐转蒸汽驱开发效果最好,多元热流体吞吐转多元热流体驱略差。蒸汽驱最优注入参数为：转驱压力5 MPa左右,采注比1.3,井底蒸汽干度0.4,注入温度340℃,注汽速度240 m³/d。     

钻井液在致密砂岩中裂缝的侵入深度模型

克深井区储层的孔隙结构与裂缝特征造成钻井过程中钻井液大量漏失,其中的固相颗粒会堵塞裂缝,使得部分生产井在完井后产量偏低甚至无产量,现场主要是通过酸压来解决这类问题。对于裂缝性气藏的酸压而言,需要知道钻井液在裂缝中的侵入深度变化,以便于设计施工参数,评价酸压效果。针对这一问题,根据牛顿流体在裂缝中的流动机理,裂缝宽度的变化以及裂缝壁面的滤失等,建立了钻井液在单一裂缝中的漏失动力模型,根据裂缝内钻井液压力的分布来定量描述钻井液的侵入深度,考虑并分析了该模型的侵入深度与侵入时间,压差和裂缝宽度之间的相互关系。最后,利用该模型计算了克深井区获得增产效果的酸压井中钻井液的侵入深度和酸液的侵入深度,通过增产井中二者之间的关系,从而间接证明了该模型。     

假塑性流体液滴撞击壁面上的铺展的格子Boltzmann模拟

流体液滴在壁面上的铺展与沉积在工业应用中存在广泛应用,研究非牛顿流体特性对液滴铺展的影响具有重要的实际意义。基于相场法建立了非牛顿幂律流体与牛顿流体的两相流格子Boltzmann模型,引入包括接触角影响的边界条件,模拟了假塑性流体在幂律指数（n）0.5~1.0以及韦伯数（We）5~45时液滴撞击壁面的铺展过程。结果表明：相对于牛顿流体,幂律流体的非牛顿特性会抑制液滴的铺展,且n越小,越有利于液滴沉积。此外,韦伯数越大,液滴越快地达到稳定。     

一种内旁通道阀式磁流变液悬置结构原理与试验研究

理想的动力总成悬置在低频高幅值激励下应具有大刚度大阻尼、在高频低幅值激励下小刚度小阻尼特性.针对现有磁流变液悬置的动刚度可控范围低、零场动刚度大及工作行程有限等问题,本文提出并实现了一种在全工作频率范围内具有较大动刚度范围、较小零场动刚度和最大化工作行程的磁流变液悬置,即内旁通道阀式磁流变液悬置.利用有限元仿真软件对该磁流变液悬置进行了电磁场仿真分析.建立了该磁流变液悬置的可控阻尼力数学模型,并基于搭建的伺服液压作动系统进行了磁流变液悬置阻尼力可控性能试验.     

呼叫中心人力资源配置鲁棒规划模型

针对现实呼叫中心中顾客到达不确定的问题,建立了基于排队论的离散流体模型,解决了考虑鲁棒性呼叫中心的人力资源配置问题.通过区间数据来表示顾客到达的不确定集,利用可调整鲁棒优化方法的思想,分析了鲁棒优化模型与确定性优化模型的关系.数值试验表明,使用可调整鲁棒参数的鲁棒优化方法减小了呼叫中心到达率不确定性给呼叫中心系统带来的影响;到达率越大,对应的最优的鲁棒参数越大,模型越保守.     

含位形权重的磁流变液孤立链流变剪应力模型

为降低采用标准孤立链理论模型计算高体积分数磁流变液流变剪应力时的计算误差,提出一种通过距离权重系数评价磁链间相互作用的流变模型.编写Monte Carlo仿真程序计算颗粒位置与磁矩方向矢量、同时输出与系统颗粒间距有关的距离权重系数.按标准和距离权重这两种链结构模型计算磁流变液剪切应力数值,并和4种磁流变液(30.58%~44.79%)的流变仪剪应力测试数据进行比较,结果显示,权重模型在磁场全范围内具有更高的计算精度,并且和流变试验实际结果基本符合,证实了磁链微观结构间的相互作用力是影响磁流变液流变特性的主要因素之一.     

燃气轮机火焰筒肋化壁面逆流气膜冷却的数值模拟

针对燃气轮机火焰筒肋化壁面逆流气膜冷却的问题,建立了火焰筒内壁面冷却传热的流固耦合数学模型.考虑湍流切应力的传播,近壁利用k-ω模型的鲁棒性,捕捉黏性底层的流动.主流区域利用k-ε模型避免k-ω模型对入口湍流参数过于敏感的劣势.SST k-ω模型是用混合函数将k-ω模型和k-ε模型结合互补所取得的更适合本问题的湍流模型.数值分析结果清晰展示了计算域流体的流场、温度场及火焰筒肋化壁面的温度场分布,并与文献中的实验结果符合良好.     

Effect of updating training on fluid intelligence in children

Recent studies have indicated that working memory (WM) training can improve fluid intelligence.However,these earlier studies confused the impact of WM storage and central executive function on the effects of training.The current study used the running memory task to train the updating ability of 9-11 year-old children using a double-blind controlled design.The results revealed that children’s fluid intelligence was significantly improved by memory-updating training.Overall,our findings suggest that the increase in fluid intelligence achieved with WM training is related to improving central executive function.