产絮凝剂双菌复合发酵体系的研究以及在水处理中的应用

从土壤和活性污泥中筛选到三株絮凝剂产生菌,将其进行双菌混合培养的正交试验,构建出了比单一菌所产絮凝剂絮凝活性更高的复合菌群LH,通过16SrRNA序列分析,初步判定二菌分别为Micrococcus sp.和Paenibacill usvelaei菌.对其性质的初步研究发现,复合菌LH所产絮凝剂MBF-LH为胞外代谢产物,其热稳定性好.LH产絮凝剂的最适碳源、最适培养温度、最适pH值和通气量分别为蔗糖、30℃、pH8和120r/min恒温振荡培养.培养基中添加KCl、CaSO4、K2HPO4能明显提高发酵液絮凝率.絮凝剂MBF-LH处理废水时具有用量少、絮凝率高的特点.     

YCH抑尘剂抑制露天矿路面扬尘的实验研究

矿山采场路面喷洒YCH抑尘剂后,逐日测定了路面粉尘含湿量、路面粉尘粒径分布、汽车行驶后瞬时扬尘浓度.路面喷洒抑尘剂10d后,瞬时扬尘浓度仅为4.9mg.m-3,降尘效率可达98.4%.与矿山路面每天喷洒4次水相比,路面喷洒YCH抑尘剂时节水率98%,降尘成本降低31%.     

SPV490钢板直接淬火回火工艺的研究

针对SPV490钢控轧后的直接淬火回火工艺进行研究.结果表明,采用再结晶区控轧后结合直接淬火回火工艺时,实验钢的强度大幅度提高,但韧性下降;采用在奥氏体再结晶区变形44%,然后在未再结晶区变形的两阶段控轧工艺后结合直接淬火回火工艺时,由于在细化晶粒的基础上增加晶粒内部变形带数量及位错密度,从而获得细小、均匀的组织,实验钢的综合力学性能良好.     

钢冷轧乳化液稳定性及对冷轧润滑的影响

研究了影响不同类型乳化液稳定性的因素,包括乳化剂的比例和总含量对阴离子乳化油稳定性的影响,乳化剂的HLB值(Hydrophile Lipophile Balance)和总量对非离子乳化油稳定性的影响.研究发现乳化剂的比例和乳化剂的HLB值对乳化油和乳化液的稳定性影响明显.通过研究不同浓度下乳化液的稳定性对其吸附性和摩擦系数的影响发现:乳化液的稳定性在一定范围内时,其润滑效果可达到最佳.在冷轧实验中也发现:应根据冷轧的实际规程和要求来选择乳化液的稳定性和合适的含量,以便使冷轧高效正常地进行.     

热轧带钢横向温度研究方法及测量分析

对目前带钢横向温度分布的研究方法和结论进行了分析;对1800热连轧机精轧出口带钢的横向温度进行测量,针对典型的分布规律,提出了描述参数,并用该参数就其分布规律以及分布与带钢宽度、纵向温度的关系进行了讨论,为建立热连轧带钢横向温度控制模型提供了依据.     

一株耐盐芽孢杆菌的分离与鉴定

从校园草坪土壤中分离得到一株能够在20%NaCl的高盐条件下生长的耐盐细菌,经过形态观察、生理特征分析及16SrDNA序列分析,鉴定为一株芽孢杆菌(Bacillussp.),并在GenBank中完成该菌株16SrDNA序列的注册,登录号为EU167738.     

Coverability of Wireless Sensor Networks

The coverability of Wireless Sensor Networks (WSNs) is essentially a Quality of Service (QoS) problem that measures how well the monitored area is covered by one or more sensor nodes.The coverability of WSNs was examined by combining existing computational geometry techniques such as the Voronoi diagram and Delaunay triangulation with graph theoretical algorithmic techniques.Three new evaluation algorithms,known as CRM (Comprehensive Risk Minimization),TWS (Threshold Weight Shortest path),and CSM (Comprehen...     

Distributed Dynamic Navigation for Sensor Networks

Navigation with sensor networks has shown many advantages and great potential in many scenarios.Previous works have mainly focused on selecting the shortest path to navigate an internal user out of an emergency field.However,they did not consider variations of the dangerous areas which usually occur in practical applications.This paper presents an efficient dynamic routing algorithm to successfully guide users to the destination exit.The navigation goal is looking for a safe and short path to enable the user to escape from a dangerous area as fast as possible.Without knowing the locations of the nodes,the user is guided by a sequence of sensor nodes to pass through the dangerous areas.The algorithm ensures the navigation path security by predicting the dynamic changes affecting the navigation path.The performance of this approach is evaluated using extensive simulations to validate its effectiveness.Simulations show that the approach is scalable and performs well in various settings.     

监控光带宽对真空蒸镀窄带滤光片的影响

分析了监控光带宽对薄膜淀积时膜厚极值点的影响，建立了模拟薄膜实际淀积过程的计算机模拟程序，通过对几种窄带滤光片膜系结构的模拟分析，得到了这些膜系对监控光带宽的基本要求。     

An Asynchronous 32×8-Bit Multiplier Based on LDCVSPG Logic

An asynchronous high-speed pipelined 32×8-bit array multiplier based on latched differential cascode voltage switch with pass-gate (LDCVSPG) logic is presented. The multiplier is based on 4-phase dual-rail protocol. HSPICE analysis using device parameters of Central Semiconductor Manufacturing Corporation (CSMC's) 0.6 μm CMOS technology is also given, and the result shows that the average data throughput of the multiplier is 375 MHz.