Effect of heat treatment on microstructures and properties of a novel Al-Zn-Mg-Cu alloy for oil drilling

In view of the special requirements for strength, heat resistance and corrosion resistance of Al-Zn-Mg-Cu alloy for oil drilling, the Al-6.2 Zn-2.5 Mg-1.6 Cu alloy was prepared by increasing Cu content on basis of Russian Series 1953 alloy. The effect of heat treatment on the microstructures and properties of the alloy was characterized by optical microscope(OM), scanning electron microscope(SEM) and transmission electron microscope(TEM), and investigated by tensile test at room temperature, thermal exposure test and corrosion test. The results show that the strength after T6 aging treatment exhibit a decrease trend as an increase of the solution temperature from465 °C to 480 °C. After the solution treated by the rate of 470 °C/1 h, second phases dissolve into the matrix very well and the strength property reaches optimum. The alloy has better comprehensive properties treated by a solution treatment of 470 °C/1 h and then followed by an aging treatment of 120 °C/24 h + 170 °C/1 h + 120 °C/24 h. Under the aging state, the precipitated phases inside the grains are suitable in size, while on the grain boundary distribute discontinuously and the precipitate-free zone is obvious. Besides, the alloy still maintain high tensile properties. The yield strength, tensile strength and elongation are 650 MPa, 686 MPa,12.0%, respectively. The yield strength retention after heat exposure is 92%. The alloy has good corrosion resistance and the exfoliation corrosion degree. The average corrosion rate in the H_2S and CO_2 environment is 0.0024 mm/a, which is far less than the required 0.12 mm/a. It is insensitive to H_2S and CO_2 environments.     

丙酸盐对厌氧氨氧化除氮性能及群落结构的影响

为了探究有机碳对厌氧氨氧化的长期影响, 向厌氧氨氧化膜生物反应器中添加不同浓度的丙酸钠, 研究对反应器的除氮效能以及微生物的种群结构和功能变化。结果表明: 反应器主要的脱氮过程由CandidatusBrocadia完成, 当丙酸钠浓度为100 mg/L时, 反应器中由于异养细菌的生长, 可实现碳氮的同步去除, 平均总氮去除率可达91.9%。当丙酸钠浓度为200 mg/L 时, 对Candidatus Brocadia的抑制作用导致反应器除氮性能下降, Candidatus Brocadia的丰度降至41.2%, 总氮去除率降至 78.8%。在有机碳抑制作用解除后, 反应器的除氮性能恢复为86.8%, Candidatus Brocadia丰度增加到54.0%, 但群落多样性下降, 属水平的微生物组成有较大的改变。     

Seismites(地震岩)等术语的概念与名称

seismites,按其字面意思理应翻译成地震岩,即与地震有成因联系或受发震断裂改造、变形的岩石。按发震时地质材料的固结程度与力学性质,地震岩可分为震积岩(地震时尚未固结成岩的含水沙土层,即软沉积物)和脆性断层岩(地震时已经固结成岩的沉积岩、岩浆岩和变质岩)。脆性断层岩包括断层角砾岩、碎裂岩、超碎裂岩、假熔岩和断层泥等。发育由沙土液化形成的软沉积物变形构造的沉积岩,统称为“沙土液化岩”(liquefactites),但是长期以来一直被误译为seismites。大量的研究表明,并不是所有的沙土液化和软沉积物变形都是由地震造成的,也并不是所有地震都能导致沙土液化。只有那些所在区域存在重要发震断层、真正由地震引起的区域性的沙土液化造成的软沉积物发育变形构造的岩层才能称之为震积岩(seismic liquefactites)。震积岩不应再翻译成seismites。零星出现的软沉积物变形构造与沙土液化构造(例如:砂涌丘)不足以作为古地震的证据。     

凋亡抑制蛋白与肿瘤关系的研究

凋亡抑制蛋白(inhibitor of apoptosis proteins,IAPs)可以作为癌症诊断和治疗的靶点,在肿瘤研究方面备受关注,就凋亡抑制蛋白的结构、功能、在肿瘤中的表达与肿瘤的关系等研究进展作一综述,为凋亡抑制蛋白的研究提供信息和思路.     

水溶性La_(0.88)Sr_(0.12)MnO_3纳米粒子的非水相合成

采用纳米微乳液法,以三嵌段共聚物聚氧乙烯-聚氧丙烯-聚氧乙烯(PEO-PPO-PEO)为表面活性剂,乙酰丙酮镧(III),乙酰丙酮锰(III)和乙酰丙酮锶(II)为前驱体,1,2-十六烷二醇为还原剂成功合成了水溶性La0.88Sr0.12MnO3纳米粒子.FT-IR分析证实该纳米粒子表面存在PEO-PPO-PEO分子,XRD和TEM分析表明该纳米粒子基本上呈球形、粒径分布窄、结晶度高,VSM测试表明该纳米粒子室温下显示软铁磁性.纳米粒子在水中快速和高效的分散收集过程,表明该纳米粒子具有良好的水溶性和磁操控性.     

不良地质条件下管道基础处理与施工

管道输送是一种较为安全的运输手段，但在不同的地质条件下的管道设计与施工有着不同的技术要求。文章介绍了在湿陷性黄土地区基处理的几种方法以及灰土及砂垫层处理方法。     

Pilot Study on Nanofiltration Combined with Ozonation and GAC for Advanced Drinking Water Treatment

IntroductionThe conventional process for surface water treatment,which consists of flocculation, sedimentation and filtrationcurrently, had been applied inproducingdrinkingwater formany years. Although this process can remove turbidityand bacteria in surface water effectively, only about from20% to 30% of natural organic matter ( NOM) can beeliminated. When the purified water is disinfected bychlorination, these NOMs may react with chlorine. As aresult some dis…     

建筑物地基处理的设计与施工探讨

以具体工程为例，介绍了建筑物地基处理的设计、施工中遵循的原则，施工中遇到特殊情况时采取的处理方法和必要的检测方法，对几种桩基的设计要求、施工工艺及过程、质量控制等情况进行了简单阐述。     

给水处理系统高效经济运行的生产性评价

研究给水处理系统的高效经济运行技术 ,是保证水厂高效、安全、经济供水的重要措施 .生产运行实践证明 ,采用高效经济方式运行的确可以节约可变费用 .尤其是在冬季低温低浊水的净化中 ,可变费用的节约程度最高可达 2 0 %以上     

传染病医院污水处理工艺选择案例

文章通过对临汾市传染病医院拟建的传染病区污水的来源、排放量、污染物的分析,结合污水处理原则,提出了具体的污水处理工艺。并根据污染物去除率预测了污染物浓度,与污染物排放标准进行对比分析,结果表明所选工艺处理后的污染物浓度能够达标,污水处理工艺是可行的。