共价有机骨架/碳纳米管复合材料中锂离子吸附与传输特性的分子模拟

利用分子模拟方法对共价有机骨架 (covalent organic framework, COF)/碳纳米管(carbon nanotube, CNT) 复合材料 COF@CNT 中锂离子 (Li$^{+})$ 的吸附与传输特性开展研究, 明确了 Li$^{+}$ 的吸附位点与吸附顺序, 得到了相应的吸附能, 并观察 COF@CNT 的表观形貌变化. 当达到饱和吸附状态时, COF@CNT 的体积变化率仅为 0.25, 平均电压保持在 2.00 V 以上, 而理论容量则高达 1 402.47 mAh/g. 此外, Li$^{+}$ 在 COF@CNT 内部的电导率大于其在单纯 CNT 中电导率的实测值. 模拟结果可为此类体系的实际应用提供理论基础.     

安全视角下动态共乘匹配成功率的仿真

研究在安全视角下，动态共乘系统对于出行个体的匹配建模与仿真结果分析。构建动态共乘匹配模型框架，并分别建立乘客安全信任演化模型、政策导向影响模型、平台安全投入影响模型和安全事件影响模型，通过系统仿真的方式获得运行数据，以此评价政策宣传密集度和强度、平台安全投入强度、司机对安全投入敏感度和高危安全事件发生概率等因素对司乘匹配成功率的影响。研究结果表明，政府主导的监管模式相对于平台主导模式而言更能显著提升司乘匹配成功率，而政府和共享乘车平台的双重监管模式对司乘匹配率的提升最为有效。同时，政府政策导向宣传作用和平台安全投入作用均存在一定的衰减效应，政府与平台需要把控监管的时机和度量问题。特别地，平台可以重点关注对安全投入敏感度更高的司机，这类司机更容易在受监管的情况下规范自身行为，使得平台的安全投入更加行之有效。     

螺栓连接大变形梁非线性振动特性的实验研究

柔性机械臂、大型可展开天线等机械结构的动作精度受运动过程中大变形几何非线性和连接处接触非线性的影响十分显著。以含螺栓连接结构的大变形梁作为研究对象，针对动力学建模和振动特性开展了实验研究，通过数值计算验证了实验发现的非线性振动特性。搭建了含螺栓连接柔性大变形梁的实验台架，开展了敲击和正弦激振的实验测试。实验结果表明，螺栓连接的柔性梁较连续梁的（无螺栓连接）模态频率降低，阻尼增加，反映出随着激励能量增大，模态频率降低的非线性模态特征。改变螺栓连接位置会显著影响结构的模态频率，其变化规律可由求解线性矩阵特征值定性反映。     

基于超网络的舆论演化动态模型

针对舆论演化过程中的复杂动力学问题,提出了超网络视觉下的舆论演化动态模型,该模型包括节点的添加、重新连接链路、超边的添加以及节点的老化4个过程,其中节点代表关键词,超边代表关键词所构成的话题。其次,利用非均匀网络的演化机制,分别对该动态演化模型的超度、节点自身关注度与节点间影响力两个因素的超度进行了详细的理论分析,分析结果表明节点超度完全符合幂律分布。最后,通过Matlab仿真模拟,分析了不同参数对节点超度分布变化的影响,并进一步验证了结果是遵循幂律分布的。     

基于40Cr高温动态力学性能的磨削表面动态再结晶行为

通过分离式霍普金森压杆(SHPB)实验得到了40Cr合金钢在高温高应变率下真应力-真应变曲线，据此确定了材料发生动态再结晶的临界条件.采用解析法和实验法分别求解了磨削强化层的温度场和塑性应变场分布.结果表明，磨削强化层在磨削深度方向具有较大的温度和塑性应变梯度;150μm强化层内会发生奥氏体转变;磨削表面最高温度可达1060℃.在磨削亚表面60μm内会产生剧烈的塑性变形，达到了再结晶的临界条件.较大的磨削深度使磨削强化层塑性应变增大，再结晶现象越充分，微观组织细化程度越高.     

联合功率域SPMA协议的动态阈值算法

针对基于优先级概率统计的多址接入(statistic priority-based multiple access, SPMA)模式协议在高负载情况下战术信息的碰撞概率十分严重, 网络性能无法满足协同攻击要求的问题, 本文借鉴非正交多址接入技术在功率域上区分同时同频信号的思想, 改进SPMA协议信号发送机制与多优先级检测机制, 在原有的时域、频域基础上引入功率域, 提出一种联合功率域的SPMA协议性能改进策略。并针对各优先级数据包到达率的动态变化场景, 设计动态阈值算法, 以达到降低碰撞概率, 提升网络吞吐量的目的。仿真结果表明, 采用该改进策略与动态阈值算法可以使网络承载更大的业务流量, 提高网络吞吐量。     

Molecular and morphological identification of two new African species of Dugesia (Platyhelminthes,Tricladida, Dugesiidae) from Cameroon

The paper describes two new Dugesia species collected from the rivers Messassi and Ntsetsensooh in Cameroon, representing the first planarian flatworms documented from this country. Based on morphological data, the new species Dugesia bijuga Harrath & Sluys, sp. nov. is characterized mainly by the presence of two diaphragms, a barrel-shaped penis that is traversed by numerous ducts of penis glands and is provided with a short nozzle, and the presence of two atrial folds. The other new species, Dugesia pustulata Harrath & Sluys, sp. nov., is characterized mainly by absence of a penis bulb, presence of a large, elongated and weakly muscular seminal vesicle, and by the ventroposterior section of the bursal canal being thrown into distinct folds. The phylogenetic position of the two new species was determined through a molecular phylogenetic tree, based on a mitochondrial and a nuclear gene, including species from the major geographical range of distribution of the genus Dugesia. The phylogenetic tree revealed that the Cameroon lineage does not constitute a monophyletic group with the other Afrotropical species; it also showed that the African continent may house a great diversity of Dugesia species that still remains to be discovered.

urn:lsid:zoobank.org:pub:007441A5-F037-4950-9F5B-AD6ED12A40ED     

关于悬臂梁受重锤冲击时的动载荷系数分析

研究了悬臂梁受重锤的冲击问题,建立了重锤的运动方程及悬臂梁的振动控制方程,并利用Galerkin原理求得重锤对悬臂梁的冲击力表达式.研究结果表明:重锤质量大于悬臂梁质量时,冲击力的近似解以及有限元解与实验结果之间的误差较大;重锤质量小于悬臂梁质量时,冲击力的近似解与有限元解与实验结果之间的误差小于5%.     

Dynamic Fault Tree Analysis for Explosive Logic Network with Two-Input-One-Output

The explosive logic network( ELN) with two-input-oneoutput was designed with three explosive logic gap null gates. The time window of the output of the ELN was given,after which the dynamic fault tree analysis was implemented. Two dynamic failure modes of the ELN were obtained,and then their own Markov transition processes were established. After that,the probability of failure was calculated from the corresponding state transition diagram. The reliability of the ELN which was in different length of time under the ambient incentive was then analyzed. Based on the above processing,the reliability of the ELN can be improved.     

Dynamic Model Averaging and CPI Inflation Forecasts: A Comparison between the Euro Area and the United States

The paper forecasts consumer price inflation in the euro area (EA) and in the USA between 1980:Q1 and 2012:Q4 based on a large set of predictors, with dynamic model averaging (DMA) and dynamic model selection (DMS). DMA/DMS allows not solely for coefficients to change over time, but also for changes in the entire forecasting model over time. DMA/DMS provides on average the best inflation forecasts with regard to alternative approaches (such as the random walk). DMS outperforms DMA. These results are robust for different sample periods and for various forecast horizons. The paper highlights common features between the USA and the EA. First, two groups of predictors forecast inflation: temporary fundamentals that have a frequent impact on inflation but only for short time periods; and persistent fundamentals whose switches are less frequent over time. Second, the importance of some variables (particularly international food commodity prices, house prices and oil prices) as predictors for consumer price index inflation increases when such variables experience large shocks. The paper also shows that significant differences prevail in the forecasting models between the USA and the EA. Such differences can be explained by the structure of these respective economies. Copyright © 2015 John Wiley & Sons, Ltd.