取向电工钢加工过程中第二相粒子的析出行为

利用场发射扫描电镜观察了以MnS为主要抑制剂的普通取向电工钢加工过程中第二相粒子的分布状态,统计了粒子面密度、平均尺寸以及相应的尺寸分布.结果显示,热轧加工造成了大量第二相粒子弥散、细小地析出,同时基体仍保持过饱和状态.冷轧变形会造成第二相粒子的回溶行为,而基体的过饱和状态会减弱回溶现象.中间退火与脱碳退火过程中会同时存在新粒子的形核及已析出粒子的粗化两个过程,而在最终二次再结晶升温阶段则以第二相粒子明显粗化为主.     

Characteristics of strontium isotopes and their implications in the Qixing Cave of Guizhou,China

The strontium isotopic compositions (87Sr/86Sr) of samples including soils, bedrock, soil waters, drip waters and their corresponding speleothems in the Qixing Cave (QXC), Guizhou Province, China, were systemically measured and analyzed. The results indicate that there are significant Sr isotopic differences among samples. The mean 87Sr/86Sr ratios in drip water for the samples 1#, 4# and 9# were 0.709568, 0.709139 and 0.708761, respectively, which possibly result from different flow paths, residence times, and other hydrogeological processes in the unsaturated zone overlying QXC. Meanwhile, levels of 40.8%, 57.6% and 72.4% of Sr in drip waters for 1#, 4# and 9#, respectively, were derived from bedrock dissolution, which was calculated by the mixture model of the two end-members (soil and bedrock). There is, however, no positive correlation between the relative proportion from bedrock dissolution (δ13C value is 1.8‰) and drip water δ13CDIC values. The mean drip water δ13CDIC value in 1# is the heaviest (–4.5‰) with the lowest contribution rate of bedrock dissolution, whereas the value in 9# is the lightest (–9.3‰) with the highest contribution rate of bedrock dissolution. The proportion from host rock dissolution in 4# is higher than that in 1# and lower than that in 9#, while its mean drip water δ13CDIC value (–8.6‰) is higher than that of 9# and lower than that for 1#. This suggests that the prior calcite precipitation (PCP) processes in the unsaturated zone overlying the cave are responsible for the δ13CDIC value differences between different drip waters, and not bedrock dissolution. Furthermore, this study also demonstrates that the 87Sr/86Sr ratios of speleothems in the 1# and 4# mainly reflect the variation in the relative proportions from the soil system (soil water) and bedrock dissolution overlying the cave. It is, therefore, feasible to use the strontium isotopic signals of speleothems as an indicator for soil chemical weathering intensity, and consequently as a monsoon proxy in the study area.     

均匀沉淀（尿素水解）法合成CO32-型MgAl-LDH

采用均匀沉淀法(尿素水解法)合成了高结晶度的CO32-型MgAl-LDH,探索了温度和时间对产物的影响.研究发现,n(Mg)/n(Al)进料比为2时,较低反应温度(如100℃)下很难得到n(Mg)/n(Al)=2的LDH.这可能与Mg(OH)2溶解度较高,Mg2+难以与Al3+一同沉淀有关.为提高产物n(Mg)/n(Al),我们采用提高n(Mg)/n(Al)投料比(如3∶1,4∶1,5∶1)的方法.研究发现,反应时间较短时,可得较纯的LDH相,但产物的n(Mg)/n(Al)远低于进料比;若反应时间延长,会出现水菱镁矿(hydromagnesite)和菱镁矿(magnesite,MgCO3)的杂相.由此推断,为得到高n(Mg)/n(Al)的LDH,不能单纯增加n(Mg)/n(Al)进料比,其他条件如尿素浓度,尤其是反应温度等也需改变.     

珠三角地区近38年冬半年降水量变化特征及干旱成因分析

 根据1970-2008年珠江三角洲地区22个气象观测站逐月降水量资料,利用滑动平均、EOF分析和小波分析等方法分析该地区冬半年降水量的变化特征,并从大气环流场角度分析其干旱成因。结论显示：珠三角地区冬半年降水量变化分布具有很高的同步性以及明显的6～7年周期变化特征,并且在未来一段时间内冬半年降水量可能仍继续偏少;从大气环流场来看,极涡偏弱,欧洲槽偏强,巴尔喀什湖附近高压脊偏强,冷空气活跃,而中纬度西风带扰动不足,南支槽活动偏弱,冷暖空气对峙少,是造成珠三角地区冬半年干旱的主要原因。     

钱塘江流域极端气温和最大降水事件的时空变化

基于1951-2008年钱塘江流域内外15个气象站月极端高温、月极端低温和月最大降水量资料,采用Mann-Kendall趋势分析方法和协克里金插值方法分析了不同区域、不同季节的极端气温和最大降水量的空间分布及变化趋势特征.结果表明:钱塘江流域最大降水量总体呈缓慢减少的状态,而极端气温都有上升的趋势;季节分布上,夏季最大...     

超纯铁素体不锈钢热变形过程中的析出行为

利用热力模拟实验机及试验轧机研究了添加Ti,V的超纯中铬铁素体不锈钢热变形过程中的析出行为变化特点,并采用热动力学计算及透射电子显微镜观察来表征析出相特征.结果表明:热变形过程中形成的析出相主要为TiC,这与热动力学分析一致.这些析出相的特征与变形温度密切相关,随着变形温度的降低,析出相TiC尺寸更加细小且分布更加弥散.这主要是由于变形温度降低时扩散速率相对较低,不利于析出相长大,而晶体缺陷增加,形变诱导析出的有效形核位置增加.这一热变形过程中的析出行为变化规律在中试试验条件下得到了验证.     

汾河流域降水量及蒸发量的空间变异性分析研究

借助于地质统计学方法对汾河流域的多年平均降雨量和蒸发量的空间变异性进行了分析,揭示了多年平均降水量和蒸发量的空间变异特征,并应用Kriging方法进行空间插值.分析结果表明,汾河流域多年平均降水量和蒸发量在不同的分割距离范围内有不同的空间相关性,多年平均降水量具有比较明显的地带性,蒸发量分布变化地带性不强.     

Microstructure evolution of T91 heat-resistant steels after long-time aging

To investigate the evolution of microstructure damage degree and the precipitated phases of heat-resistant metal in power plant under high temperature and stress environment, the high-temperature aging tests were conducted to investigate the aging behavior of T91 steel at different temperatures and stress. The optical microscopy, scanning electron microscopy, and transmission electron microscopy were used to investigate the structure and precipitated phases, the results showed that the orientation characteristics of tempered martensite was dispersed, and the grain size is obviously increased. The density of dislocation decreased with increasing temperature and stress. The important strengthening phase of M23C6 (M=Fe, Cr) was coarsened by the diffusion of main alloying elements Cr, while the smaller size MX (M=Nb,V; X=C, N) phase distributed in the grain is relatively stable in the aging.     

含Nb钢变形后长时间等温对析出的影响

运用热模拟技术,通过硬度测量及透射电镜(TEM)观察,分析了含Nb微合金钢奥氏体变形后长时间等温对低温(525℃)回火组织及析出行为的影响.结果表明:回火1 200 min时组织几乎保持不变.硬度值在回火初期一直下降,到120 min后,开始缓慢回升,到1 200 min基本保持不变.应变诱导析出颗粒粗化后即使长时间回火,颗粒并没有明显长大.回火后期的硬度值上升是由于Nb在α湘中进一步形核长大造成的.     

Real‐Time Forecasts of Inflation: The Role of Financial Variables

We present a mixed‐frequency model for daily forecasts of euro area inflation. The model combines a monthly index of core inflation with daily data from financial markets; estimates are carried out with the MIDAS regression approach. The forecasting ability of the model in real time is compared with that of standard VARs and of daily quotes of economic derivatives on euro area inflation. We find that the inclusion of daily variables helps to reduce forecast errors with respect to models that consider only monthly variables. The mixed‐frequency model also displays superior predictive performance with respect to forecasts solely based on economic derivatives. Copyright © 2012 John Wiley & Sons, Ltd.