不同热解温度生物炭改良铅和镉污染土壤的研究

 为了探究热解温度对生物炭修复重金属污染土壤的影响,将300℃、500℃和700℃下制备的生物炭加入铅（Pb）和镉（Cd）污染土壤进行培养,检测重金属形态的变化。结果表明,加入生物炭培养60d后,Pb和Cd污染土壤pH值较对照上升0.35—0.86单位值,土壤中重金属的酸可提取态含量下降,残渣态含量上升,对目标重金属生物有效性降低的改良效果700℃>500℃>300℃;在生物炭添加量相同的情况下,复合污染土壤中Pb的残渣态含量比对应单一污染高50.60%—72.79%,而复合污染土壤中Cd的酸可提取态含量较对应单一污染高7.53%—12.99%;热解温度影响生物炭的表面特征和吸附重金属机制,进而影响生物炭改良土壤中目标重金属形态分布。     

维生素C-磷脂复合体抑制LPS诱导小鼠腹腔巨噬细胞氧化应激的研究

 为了比较维生素C-磷脂复合体（VitC-PC）和VitC体外抑制小鼠腹腔巨噬细胞氧化应激的活性,本研究提取小鼠腹腔巨噬细胞,在体外培养,用沙门氏菌脂多糖（LPS）诱导氧化应激,分别用不同浓度VitC和VitC-PC进行处理,测定培养液一氧化氮（NO）、乳酸脱氢酶（LDH）、丙二醛（MDA）和细胞内诱导性NO合成酶（iNOS）,以评价细胞炎性反应、细胞膜完整性和脂质过氧化程度。同时静息态腹腔巨噬细胞与不同浓度的VitC或VitC-PC共孵育,测定细胞内VitC浓度,以评价细胞摄取VitC或VitC-PC的效率。结果发现,在高浓度添加VitC时,巨噬细胞摄取VitC-PC的效率高于VitC（P<0.05）,VitC-PC抑制LPS诱导巨噬细胞释放NO、发生脂质过氧化（产生MDA）和细胞膜损伤（LDH泄露）的效率显著高于VitC（P<0.05）。因此,本研究证明VitC-PC比VitC更易进入细胞内部发挥抗氧化作用。     

CdS,ZnO1-xSx电子结构和光学特性的第一性原理研究

 采用基于密度泛函理论(DFT)框架下广义梯度近似(GGA)的PBE平面波超软赝势方法,研究了闪锌矿型CdS和ZnO_1-xS_x(x=0,0.25,0.5,0.75,1)的电子结构和光学特性.计算并分析了闪锌矿型CdS和ZnO_1-xS_x的复介电函数、光电导率、吸收系数和损失函数.研究结果表明,闪锌矿型CdS和ZnO_1-xS_x(x=0,0.25,0.5,0.75,1)均为直接带隙半导体材料.ZnO中一定浓度的硫掺杂,导致带隙宽度变窄,而晶格常数随掺杂基本呈线性变化.就目前制备铜铟镓硒(CIGS)薄膜太阳能电池普遍使用CdS缓冲层而言,ZnO_1-xS_x具有与CdS类似的电子结构,但光学特性上高频特性有明显改善.这些特性对于改善电池吸收层表面性能和光吸收特性、制备高效CIGS薄膜太阳能电池非常有利.     

航空成像光谱的蚀变信息提取技术

 根据成像光谱仪CASI/SASI的影像特点,制定了高光谱影像的处理方法流程,介绍了各步骤的内容和需要注意的事项.阐述了噪声和坏波段去除、大气校正的过程,并提出了一些经验性的处理方法.在成像光谱岩石蚀变提取算法中,根据经验对已有方法进行了改进;在基于特定算法的矿物填图方法中,依据柯坪地区CASI影像中富含二价铁的辉绿岩脉的光谱特征,提出了富二价铁岩石提取算法.经过实地验证,富二价铁岩石的提取对铀矿勘探具有较好的指导作用.通过提取的信息结果与已经矿区或矿点的空间叠加分析发现,富二价铁岩石空间分布与铀异常点分布有很强的相关性.根据富二价铁与铀矿的空间分布规律,提出了断裂+富二价铁岩石的成矿模式.红色砂岩提供铀源,岩脉提取铀成为存储容器.富二价铁岩石提供铀沉淀催化剂的作用,且线性的富二价铁岩石分布区域对成矿更有利.通过富二价铁岩石的提取,在柯坪南部地区新发现了3条铀异常带.     

一种解决调频连续测距中测距模糊方法

通过对锯齿调频连续测距系统的差频信号分析可知,由于观测时间的随机性导致同一距离上对应两个不同的差频频率。对差频信号进行时域和频域分析发现,利用两次混频的方法能够解决这种测距模糊问题,使信号处理单元的输出信号频率和距离一一对应。利用仿真软件,得到信号处理过程中的时频关系曲线,验证了这种信号处理方法的有效性。     

Photonic integrated technology for multi-wavelength laser emission

We summarized the design, fabrication challenges and important technologies for multi-wavelength laser transmitting photonic integration. Technologies discussed include multi-wavelength laser arrays, monolithic integration and modularizing coupling and packaging. Fabrication technique requirements have significantly declined with the rise of reconstruction-equivalent-chirp and second nanoimprint mask technologies. The monolithic integration problem between active and passive waveguides can be overcome with Butt-joint and InP array waveguide grating technologies. The dynamic characteristics of multi-factors will be simultaneously measured with multi-port analyzing modules. The performance of photonic integration chips is significantly improved with the autoecious factors compensation packaging technique.     

Serum levels of perfluorinated compounds in the general population in Shenzhen, China

Perfluorinated compounds (PFCs) have been detected in many environmental matrices, biota, and nonoccupationally exposed populations in China recently. However, little is known about the distribution and levels of various PFCs in the general population living in areas where there is PFC exposure. In the present study, the levels and prevalence of ten target PFCs were determined in 227 serum samples from a population of nonoccupationally exposed individuals in Shenzhen, China. Results indicated that human exposure to PFCs was prevalent in Shenzhen. Perfluorooctanoate (PFOA) was the dominant PFC contaminant in the serum samples, with a median concentration of 6.72 ng/mL, followed by perfluorooctane sulfonate (PFOS) with a median concentration of 2.07 ng/mL. Other PFCs were detected at much lower concentrations, with median concentrations ranging from 0.02 to 0.87 ng/mL. Statistically, no significant (P>0.05) gender differences were observed for any of the PFCs. Significant (P<0.01) positive correlations were found between age and serum concentrations of the target PFCs, except for perfluorobutane sulfonate (R = 0.16, P = 0.01), perfluorohexanoic acid (R = 0.08, P = 0.22), and perfluoroheptanoic acid (R = 0.11, P = 0.10). Based on the one-compartment pharmacokinetic model, the total daily intakes of PFOA and PFOS for the general population in Shenzhen were calculated as 0.63 and 0.20 ng/kg body weight/day, respectively.     

Rolling-induced microstructure change in Zr_(65)Al_(7.5)Ni_(10)Cu_(12.5)Ag_5 bulk metallic glass

The microstructures and free-volume evolutions of as-cast and pre-annealed Zr65Al7.5Ni10Cu12.5Ag5 bulk metallic glasses during rolling deformation have been investigated. No phase transformation is detected in the as-cast/rolled specimen. However,the structural stability of the glass against plastic deformation is worse after pre-annealing,indicated by nanocrystallization in preannealed/rolled specimens with large deformation degrees. Moreover,with increasing deformation degree,the free-volume content in a ...     

A comparison of optimization theories for energy conservation in heat exchanger groups

In general,thermal processes can be classified into two categories: heat-work conversion processes and heat transfer processes. Correspondingly,the optimization of thermal processes has to have two different criteria:the well known entropy generation minimization method and the recently proposed entransy dissipation maximization method. This study analyzes the thermal issues in a heat exchanger group,and optimizes the unit arrangements under different constraints based on a suitable optimization crite-rion. The result indicates that the principle of minimum entropy generation rate is valid for optimizing heat exchangers in a ther-modynamic cycle with given boundary temperatures. In contrast,the entransy dissipation maximization is more suitable in heat exchanger optimizations involving only heat transfer processes. Furthermore,the entropy generation rate induced by dumping used streams into ambient surroundings has to be taken into account,except for that originating from the hot and cold-ends of heat exchangers,when using the entropy generation minimization to optimize heat exchangers undergoing a thermodynamic cycle.     

Forced response of atmospheric oscillations during the last millennium simulated by a climate system model

Variations in global atmospheric oscillations during the last millennium are simulated using the climate system model FGOALS_gl. The model was driven by reconstructions of both natural forcing (solar variability and volcanic aerosol) and anthropogenic forcing (greenhouse gases and sulfate aerosol). The model results are compared against proxy reconstruction data. The reconstructed North Atlantic Oscillation (NAO) was out of phase with the Pacific Decadal Oscillation (PDO) in the last millennium. During the ...