| 手机信号采集与传输技术设计与实现 |
| |
| 引用本文： | 田增山,苟举,何维.手机信号采集与传输技术设计与实现[J].重庆邮电大学学报(自然科学版),2011,23(2):178-182. |
| |
| 作者姓名： | 田增山 苟举 何维 |
| |
| 作者单位： | 重庆邮电大学 无线定位与空间测量研究所，重庆 400065 |
| |
| 基金项目： | 重庆市科技攻关项目(CSTC,2009AA2037) |
| |
| 摘 要： | 嵌入式平台上,3G手机的信号采集和传输由于数据速率过高,在实现上存在较大的难度,设计了一种由射频芯片、FPGA和CY7C68013构成的手机信号采集和传输方案.以TD-SCDMA信号为例,设计了系统的硬件架构和软件部分,包括FPGA中的软件及USB固件程序.最后提出验证方案,结果表明,该方案能使高达102.4 Mbit...
|
| 关 键 词： | TD-SCDMA FPGA CY7C68013 SLAVE FIFO |
| 收稿时间： | 2010/11/23 0:00:00 |
Mobile data acquisition and transmission of technical design and implementation |
| |
| TIAN Zeng-shan,GOU Ju,HE Wei.Mobile data acquisition and transmission of technical design and implementation[J].Journal of Chongqing University of Posts and Telecommunications,2011,23(2):178-182. |
| |
| Authors: | TIAN Zeng-shan GOU Ju HE Wei |
| |
| Abstract: | Embedded platforms, 3G mobile phone signal acquisition and transmission of the data rate is too high, there is a big difficulty to achieve, we design a chip from the RF, FPGA and cell phone signals pose CY7C68013 acquisition and transmission program. Thesis, TD-SCDMA signals, for example, designed the system hardware architecture and software components, including the software and USB FPGA firmware. Finally, authentication schemes, the results show that the scheme can make up to 102.4 Mbit/s the TD-SCDMA data stream to achieve accurate collection and transmission. |
| |
| Keywords: | TD-SCDMA FPGA CY7C68013 SLAVE FIFO |
|
| 点击此处可从《重庆邮电大学学报(自然科学版)》浏览原始摘要信息 |
| 点击此处可从《重庆邮电大学学报(自然科学版)》下载免费的PDF全文 |
|
