氧化还原介体催化强化污染物厌氧降解研究进展

 由于厌氧生物处理技术具有产生剩余污泥少、可回收能源等优点而被广泛用于处理各种有机污染物，尤其在有毒、有害、难降解污染物的去除方面取得了良好的效果。然而，厌氧生物法的处理速率通常比较低，而氧化还原介体可通过自身不断的氧化和还原来传递电子，提高电子在氧化还原反应过程中的传递速率，从而促进污染物高效厌氧降解。醌类物质和腐殖酸是应用较多的氧化还原介体，在催化难降解污染物降解方面取得了一定效果。讨论了氧化还原介体的特点、作用机制，并总结了其对偶氮染料厌氧脱色、反硝化和多氯联苯厌氧降解的强化作用，提出了氧化还原介体未来的研究方向。     

Effect of heat treatment on microstructures and properties of a novel Al-Zn-Mg-Cu alloy for oil drilling

In view of the special requirements for strength, heat resistance and corrosion resistance of Al-Zn-Mg-Cu alloy for oil drilling, the Al-6.2 Zn-2.5 Mg-1.6 Cu alloy was prepared by increasing Cu content on basis of Russian Series 1953 alloy. The effect of heat treatment on the microstructures and properties of the alloy was characterized by optical microscope(OM), scanning electron microscope(SEM) and transmission electron microscope(TEM), and investigated by tensile test at room temperature, thermal exposure test and corrosion test. The results show that the strength after T6 aging treatment exhibit a decrease trend as an increase of the solution temperature from465 °C to 480 °C. After the solution treated by the rate of 470 °C/1 h, second phases dissolve into the matrix very well and the strength property reaches optimum. The alloy has better comprehensive properties treated by a solution treatment of 470 °C/1 h and then followed by an aging treatment of 120 °C/24 h + 170 °C/1 h + 120 °C/24 h. Under the aging state, the precipitated phases inside the grains are suitable in size, while on the grain boundary distribute discontinuously and the precipitate-free zone is obvious. Besides, the alloy still maintain high tensile properties. The yield strength, tensile strength and elongation are 650 MPa, 686 MPa,12.0%, respectively. The yield strength retention after heat exposure is 92%. The alloy has good corrosion resistance and the exfoliation corrosion degree. The average corrosion rate in the H_2S and CO_2 environment is 0.0024 mm/a, which is far less than the required 0.12 mm/a. It is insensitive to H_2S and CO_2 environments.     

丙酸盐对厌氧氨氧化除氮性能及群落结构的影响

为了探究有机碳对厌氧氨氧化的长期影响, 向厌氧氨氧化膜生物反应器中添加不同浓度的丙酸钠, 研究对反应器的除氮效能以及微生物的种群结构和功能变化。结果表明: 反应器主要的脱氮过程由CandidatusBrocadia完成, 当丙酸钠浓度为100 mg/L时, 反应器中由于异养细菌的生长, 可实现碳氮的同步去除, 平均总氮去除率可达91.9%。当丙酸钠浓度为200 mg/L 时, 对Candidatus Brocadia的抑制作用导致反应器除氮性能下降, Candidatus Brocadia的丰度降至41.2%, 总氮去除率降至 78.8%。在有机碳抑制作用解除后, 反应器的除氮性能恢复为86.8%, Candidatus Brocadia丰度增加到54.0%, 但群落多样性下降, 属水平的微生物组成有较大的改变。     

凋亡抑制蛋白与肿瘤关系的研究

凋亡抑制蛋白(inhibitor of apoptosis proteins,IAPs)可以作为癌症诊断和治疗的靶点,在肿瘤研究方面备受关注,就凋亡抑制蛋白的结构、功能、在肿瘤中的表达与肿瘤的关系等研究进展作一综述,为凋亡抑制蛋白的研究提供信息和思路.     

不良地质条件下管道基础处理与施工

管道输送是一种较为安全的运输手段，但在不同的地质条件下的管道设计与施工有着不同的技术要求。文章介绍了在湿陷性黄土地区基处理的几种方法以及灰土及砂垫层处理方法。     

Pilot Study on Nanofiltration Combined with Ozonation and GAC for Advanced Drinking Water Treatment

IntroductionThe conventional process for surface water treatment,which consists of flocculation, sedimentation and filtrationcurrently, had been applied inproducingdrinkingwater formany years. Although this process can remove turbidityand bacteria in surface water effectively, only about from20% to 30% of natural organic matter ( NOM) can beeliminated. When the purified water is disinfected bychlorination, these NOMs may react with chlorine. As aresult some dis…     

建筑物地基处理的设计与施工探讨

以具体工程为例，介绍了建筑物地基处理的设计、施工中遵循的原则，施工中遇到特殊情况时采取的处理方法和必要的检测方法，对几种桩基的设计要求、施工工艺及过程、质量控制等情况进行了简单阐述。     

给水处理系统高效经济运行的生产性评价

研究给水处理系统的高效经济运行技术 ,是保证水厂高效、安全、经济供水的重要措施 .生产运行实践证明 ,采用高效经济方式运行的确可以节约可变费用 .尤其是在冬季低温低浊水的净化中 ,可变费用的节约程度最高可达 2 0 %以上     

传染病医院污水处理工艺选择案例

文章通过对临汾市传染病医院拟建的传染病区污水的来源、排放量、污染物的分析,结合污水处理原则,提出了具体的污水处理工艺。并根据污染物去除率预测了污染物浓度,与污染物排放标准进行对比分析,结果表明所选工艺处理后的污染物浓度能够达标,污水处理工艺是可行的。     

40Cr大轴断裂分析

对冶金矿山某产品的40Cr材料制作的大轴热处理后发生断裂现象，进行了理化检验及综合分析，找出了造成大轴断裂原因－首先是由于存在淬火应力，而未得到及时回火，其次是原材料中存在严重的冶金缺陷。