Tribological behavior of CrN-coated Cr-Mo-V steels used as die materials

DIN 1.2343 and 1.2367 steels are commonly used as die materials in aluminum extrusion, and single/duplex/multi-coatings enhance their surface properties. The design of an appropriate substrate/coating system is important for improving the tribological performance of these steels under service conditions because the load-carrying capacity of the system can be increased by decreasing the plastic deformation of the substrate. In this study, the tribological behavior of CrN-coated Cr-Mo-V steels (DIN 1.2343, 1.2367, and 1.2999 grades) was investigated using different setups and tribological pairs at room and elevated temperatures. The aim of this study was to reveal the wear resistance of a suggested system (1.2999/CrN) not yet studied and to understand both the wear and the failure characteristics of coated systems. The results showed that (i) among the steels studied, the DIN 1.2999 grade steel exhibited the lowest friction coefficient because it had the highest load-carrying capacity as a result of secondary hardening at elevated temperatures; (ii) at room temperature, both abrasive tracks and adhesive layers were observed on the worn surfaces; and (iii) a combination of chemical reactions and progressive oxidation caused aluminum adhesion on the worn surface, and the detachment of droplets and microcracking were the characteristic damage mechanisms at high temperatures.     

Formation mechanism of ferromagnetic minerals in loess of China： TEM investigation

The results of TEM investigation indicate that magnetite and maghemite are the major ferromagnetic minerals in loess-paleosol sequences. Primary magnetite has the similar morphology and surface characteristics as eolian detrital particles. The magnetite can be classified into two categories, high-titaninm and low-titanium, which may be the indicators of magmatic rocks and metamorphic rocks,respectively. TEM investigation at nanometer scale shows that primary detrital magnetite of micron scale had been partially weathered to magnetite of 5-20 nanometer during the pedogenic process, which maintain the pseudomorphism of the aeolian debris. Some chlorite particles were also weathered to nanometer scale magnetite or maghemite in the pedogenic process. So weathering of the two minerals leads to formation of superparamagnetism, which may be the important mechanism of magnelic-susceptibnlty increase in paleosols. The mgnelite or maghhemite resulting from the weathering of chlorite contains a small amount of P and S,which is the signal of microbe-mineral interaction, and indicates that microbes may play a certain role in chlorite weathering and formation of Superparamagnetic particles.     

^40Ar／^39Ar geochronological constraints on syn-orogenic strike-slip movement of Tan-Lu fault zone

Two phases of sinistral strike-slip ductile shear belts occur on the eastern margin of the Dabie orogenic belt. A muscovite ~(40)Ar/~(39)Ar plateau age of 128 Ma was obtained from mylonite in the later ductile shear zone. Three muscovite samples separated from mylonites of 3 localities in the earlier ductile shear belts yield ~(40)Ar/~(39)Ar plateau ages of 192.5±0.7 Ma, 189.7±0.6 Ma and 188.7±0.7 Ma, respectively. They are interpreted as cooling ages of the earlier sinistral strike-slip deformation. It is suggested that left-lateral displacement of the Tan-Lu fault zone started in a late stage of the collision orogeny in the Dabie-Sulu orogenic belt between the North and South China plates. Therefore, the earlier Tan-Lu fault zone was syn-orogenic strike-slip tectonics. The fault zone was used again for sinistral displacement during tectonic activities of peri-Pacific regime in Early Cretaceous. It is proposed that the fault zone occurred as a transform fault during the orogenic process.     

New finding of micro-diamonds in eclogites from Dabie-Sulu region in central-eastern China

Micro-diamonds were only found ten years ago in eclogite associated with marble at Xindian in the Dabie Mountains. This paper reports our new finding of micro-diamonds not only in eclogites at Maobei in the Sulu region and at Xindian and Laoyoufang in the south part of the Dabie Mountains (South Dabie), but also in eclogites at Baizhangya and Huangweihe in the northern part of the Dabie Mountains (North Dabie) that has usually been considered not to experience ultrahigh pressure metamorphism.Except the micro-diamond at Huangweihe that was found from the artificial heavy sands of zircons used for isotopic dating, the micro-diamonds from other localities were identified in thin sections of the eclogites. Besides a few interstitial grains, most of the micro-diamond grains in thin sections occur as inclusion in garnet. Three crystals of microdiamond at Maobei in the Sulu region are sized in 120, 60 and 30 lira, respectively. Crystal forms look like octahedron and the composite of octahedron and hexahedron. The largest micro-diamond crystal comes from Xindian, which is measured to be 180 lira in diameter with distinct zonal structure and inclusions. The zonal structure occurs as an inclined octahedron inside rounded by an incomplete hexagonal girdle. A smaller micro-diamond inclusion occurs inside the central octahedron, and a larger graphite inclusion is within the outer zone. The Laoyoufang micro-diamond is partially retrograded to graphite. Micro-diamond from the Baizhangya eclogite in the ultramafic rock belt of North Dabie is an aggregate of 70 lira X 90 lira in size. All the micro-diamonds are confirmed by the Raman spectrum analysis. The occurrence of the micro-diamonds from the eclogites in the ultramafic rock belt of North Dabie demonstrates that this region was also subjected to ultrahigh pressure metamorphism as well as the South Dabie did.