基于故障状态检测的惯性/卫星信息融合技术

为了提高惯性/卫星组合导航系统的可靠性及导航信息的精度,设计了SINS/GPS/Galileo/RDSS组合导航多信息融合方案,采用基于概率分布的残差χ2故障检测方法提高组合导航系统的容错性和可靠性.在此基础上采用了基于故障状态检测的新型自适应信息分配算法,并建立导航系统的数学模型,给出其状态方程、测量方程.最后将新算...     

联邦滤波信息分配方法及其在传递对准中的应用

针对高动态导航环境中固定信息分配策略不能满足应用需求的问题,根据联邦滤波公式定量分析了信息分配系数的选择对各子滤波器精度、鲁棒性及计算稳定性的影响.考虑通过提高无故障子滤波器的鲁棒性来提高联邦滤波器的快速重构能力,同时兼顾子滤波器的精度和计算稳定性,提出了基于模糊规则表的信息分配策略,给出了实现该策略的具体方法,并将其用于某导航系统的快速传递对准中.理论分析与仿真结果表明,该方法可以有效提高无故障子系统对系统故障的抗干扰能力,并可保证系统的计算稳定性.     

TiO2覆膜PTFE滤料光催化甲醛特性的实验研究

用纳米TiO2作为光催化剂覆膜于工业中普遍使用的PTFE滤料,得到了一种新型滤料。设计搭建了仿真空气净化系统的光催化实验台,分析了初始浓度、净化风速、紫外光强度、温度和相对湿度对甲醛光催化降解效率的影响。实验结果发现,在实验区间内,降解效率随初始浓度和紫外光强度的增加而提高;净化风速和温度对降解效率有双重影响;低的相对湿度对应了较高的降解效率。     

一种带预处理的离散系数滤波器设计方法

提出了一种带预处理的离散系数滤波器设计方法。该方法基于离散系数滤波器设计问题的{-1,1}二次规划模型,利用{-1,1}二次规划的全局最优性条件,提出了一种最优解元素的判断准则,得到了一个规模较小的离散系数滤波器设计问题。结合随机扰动方法,得到了求解离散系数滤波器设计问题的一种带预处理的随机扰动算法。与随机扰动方法相比,带预处理的随机扰动方法得到的次优解的性能更好,需要的时间也大大减少。     

三相电路功率因数的校正

在Ｔｅｎｔｉ的瞬时功率理论基础上，设计了一种用于功率因数校正装置的补偿电流参考信号检测电路，并在实验室设计安装了１台小容量并联型功率因数校正装置，其主回路采用电压型三相ＤＣ－ＡＣ逆变器，并采用改进的自适应电流跟踪型ＰＷＭ控制电路．实验结果表明，该装置达到了很好的补偿效果，验证了设计的正确性     

DIGITAL FILTER PROCESS DURING THE DISCRETE MAGNITUDE DATA GATHERING

We analyze the reason that causes the error during the discrete magnitude data gathering. A method,dealing with data by means of second -order low -pass digital filter,is brought out,which will improve both the smooth degree and the response of the data into a quite good state.     

TMS320C5402数字IIR滤波器的超声回波信号检测

通过对IIR滤波器结构分析,制作了超声回波信号高速采样系统,并基于TMS320C5402数字IIR滤波器,对超声回波信号进行了降噪处理.结果表明,与不经过IIR滤波的数字采样相比,应用该方法可以较好恢复超声回波信号,这对超声信号的在线检测有一定实用意义.     

Ultra-high suppression microwave photonic bandstop filters

A bandstop radio frequency （RF） filter can enhance the capabilities of RF communication systems by removing unwanted signal components such as distortion, or interference. In modem cognitive radio systems, frequency agile filters are desired to block interferers with dynamically changing frequencies and powers. These filters should be tunable over a broad frequency range, and they should be capable of suppressing very strong signals with a high resolution. To simultaneously meet these requirements with traditional RF filters are highly chal- lenging. Microwave photonic （MWP）, a technology that primary deals with the generation, distribution, and processing of high speed RF signals using photonic techniques and components, is promising for creating frequency agile RF filters. However, traditional MWP filters are lacking the high resolution and peak suppression exhibited by state-of-the-art RF electrical filters. We recently introduced a new class of MWP notch filter which is free from this limitation. This scheme allowed the creation of anomalously high suppression MWP notch filter from virtually any kind of optical resonance, irrespective of its type （gain or absorp tion）, or its magnitude. This enabled, for the first time, simultaneous optimization of the MWP filter resolution, peak attenuation, and frequency tuning range. In this paper, we present the analysis of notch filter response creation using the novel sideband processing technique. We then show the applicability of this technique to a wide range of optical filters. We compare simulated and experimental results of the notch filter response created using three types of optical filter commonly used in MWP signal processing, namely stimulated Brillouin scattering （SBS）, an integrated optical ring resonator （ORR）, and a phase-shifted fiber Bragg-grating （FBG）.     

偏序集上的弱滤子弱极大理想

文章在偏序集上引入偏序集上弱滤子弱极大理想,证明其存在性定理,并研究它的一些性质,得到弱理想在满足弱理想降链条件的偏序集上的一个分解定理.     

一种46 MHz Gm-C复数滤波器及其自动频率调谐电路设计

基于0.18μm CMOS工艺,设计了一款高频Gm-C复数滤波器,该滤波器的中心频率达到46MHz,在20MHz的通带内的平坦度小于0.36dB,能够实现98dB的镜像抑制,以及28dB的带外抑制.滤波器工作在1.8V电源电压下,消耗的电流小于7.9mA.为了纠正滤波器的频率,提出了一种基于积分器和数字电路的频率调谐方法,该调谐电路在调谐完成后会自动关闭,实现了"零功耗",特别适合低功耗的应用.仿真结果表明调谐误差小于±1.5%.