Exendin-4螺旋结构对生物活性及稳定性的影响

针对Exendin-4的螺旋结构特点, 采用去掉螺旋序列、 用3个连续Ala替换螺旋以及Gln13替换为Tyr13的方式对N端α-螺旋及C端α-螺旋进行改造, 设计出4个结构模拟物. 通过圆二光谱和荧光光谱进行结构分析, 结合模拟物生物活性实验, 分析Exendin-4螺旋结构与生物活性的关系. 结果表明：  Exendin-4的N端螺旋比C端螺旋对生物活性影响更大； 在抗二肽基肽酶（DPPⅣ酶）的稳定性实验中, C端螺旋比N端螺旋具有更好维系Exendin-4稳定性的作用； 螺旋结构中Tyr13可作为提高Exendin-4生物活性的重要优化位点.     

轧制道次间插入冷却对特厚钢板组织与性能的影响

使用实验轧机旁冷却装置配合轧机进行轧制实验，研究轧制道次间不同冷却工艺对特厚钢板组织和性能的影响规律.研究结果表明:采用道次间冷却工艺可以在全厚度方向获得组织细化及强韧性提高效果，采用强冷道次间冷却实验钢1/4处晶粒尺寸可细化至10μm，强度为376MPa，-40℃冲击功为169J;心部晶粒尺寸可细化至15μm，强度为360MPa，-40℃冲击功为123J.本工艺可形成470μm厚表层细晶层，晶粒尺寸可细化至5μm;粗轧道次间插入冷却工艺轧制钢板强度和冲击韧性优于中间坯冷却工艺;随冷却强度增加，钢板内部组织明显细化且强度大幅提高.     

FeCo-based hybrid MOF derived active species for effective oxygen evolution

Metal-organic frameworks(MOFs) have been regarded as promising catalyst materials due to the richness of coordinately unsaturated metal sites on the surface,which can act as catalytic active centres.In this study,a hybrid MOF material composed of Fe-based MOF and Co-based MOF was prepared with the involvement of graphene oxide nanosheets as additive.It was demonstrated that the hybrid MOF materials showed much higher electro-catalytic activity towards oxygen evolution than the single-phase counterparts.To drive current density of 10 mA cm~(-2),the hybrid CoFe-based MOF only needed an over potential of 290 mV in 1 M KOH.The catalytic activity could sustain for a longer time with only slight current density decrease.During oxygen evolution operation,the MOF catalyst evolved into catalytic active species but kept well the microscale sheet-like structure.It is thus believed that this study will provide an avenue for the development of advanced electrocatalysts.     

Acyl-chloride functionalized graphene oxide chemically grafted with hindered phenol and its application in anti-degradation of polypropylene

In this study,graphene oxide (GO) nanosheets were first functionalized by the acyl-chloride reaction and then reacted with hindered phenol (HP) to obtain HP grafted GO (GO-g-HP).The GO-g-HP prepared under the optimized condition exhibited a high efficiency against both thermal and photo oxidation of isotactic polypropylene (iPP).GO-g-HP exhibited a much better anti-aging efficiency than that of HP and GO used individually or that of their physical mixture.The outstanding anti-aging effect of GO-g-HP was attributed to the excellent synergistic effect produced between the chemically bonded GO and HP,which resulted in an improved oxygen barrier property of GO and excellent utilization of the free radical scavenging capability of GO and HP.Also,thanks to the grafting of HP on GO,the physical loss of HP,which was one of the main shortcomings for traditional small molecular antioxidants,was largely suppressed.It is expected that the GO-g-HP prepared can well meet the requirement of long-term applications of polymers in some harsh service conditions.     

丙酸盐对厌氧氨氧化除氮性能及群落结构的影响

为了探究有机碳对厌氧氨氧化的长期影响, 向厌氧氨氧化膜生物反应器中添加不同浓度的丙酸钠, 研究对反应器的除氮效能以及微生物的种群结构和功能变化。结果表明: 反应器主要的脱氮过程由CandidatusBrocadia完成, 当丙酸钠浓度为100 mg/L时, 反应器中由于异养细菌的生长, 可实现碳氮的同步去除, 平均总氮去除率可达91.9%。当丙酸钠浓度为200 mg/L 时, 对Candidatus Brocadia的抑制作用导致反应器除氮性能下降, Candidatus Brocadia的丰度降至41.2%, 总氮去除率降至 78.8%。在有机碳抑制作用解除后, 反应器的除氮性能恢复为86.8%, Candidatus Brocadia丰度增加到54.0%, 但群落多样性下降, 属水平的微生物组成有较大的改变。     

连续刚构铁路桥收缩徐变效应监测与分析

对连续刚构铁路桥箱梁温度场及桥梁线形进行长期、连续监测,通过主梁跨中下挠的理论与实测对比揭示了连续刚构铁路桥收缩徐变效应。对比了国内外常用收缩徐变估算模型,选择CEB-FIP徐变模型对黄河特大连续刚构桥进行了有限元分析。采用实测温度数据,以箱梁内测温度、外侧温度、顶底板温度梯度、左右侧温度梯度作为箱梁温度场的评判指标,对箱梁1年内的四季温度场分布进行分析。在基于相同温度场的条件下,通过理论值与实测值对比,发现分析成果与实测结果较吻合,说明混凝土的收缩徐变是引起连续刚构铁路桥跨中下挠的主要原因,对比结果还说明通过改善箱梁顶底板应力差能够改善收缩徐变长期效应。     

高温作用后砂岩物理力学性质阈值温度的确定——基于机器学习算法

通过采用机器学习算法，提出了高温作用后砂岩物理力学性质变化的阈值温度的确定方法。基于Python语言，利用K-Means、SVM算法，实现了对样本数据的分类和聚类，确定了阈值温度区间，验证了二分类法的合理性和准确性.结果表明，砂岩样本的阈值温度区间为400~600 ℃，阈值温度上下砂岩的物理力学性质存在显著差异，体现为阈值温度区间以下的岩样物理力学性质较为分散，而阈值温度区间以上的岩样物理力学性质较为集中.     

温度和机械载荷联合作用下油田超深井中硬质涂层膨胀锥与套管的屈服挤毁压强及试验验证

在充分考虑温度载荷、机械载荷、硬质涂层膨胀锥硬度、套管硬度对膨胀锥与套管之间屈服挤毁压强影响的基础上,根据分形理论和接触力学推导出膨胀锥与套管之间屈服挤毁压强的计算公式.数值分析表明:膨胀锥与套管之间的屈服挤毁压强随最终温度、分形粗糙度、线膨胀系数、硬质涂层膨胀锥布氏硬度、中间主应力系数、套管壁厚的增大而增大;当分形维数从1增大时,膨胀锥与套管之间的屈服挤毁压强随分形维数的增大而减小;当分形维数增大到接近于2时,膨胀锥与套管之间的屈服挤毁压强随分形维数的增大而增大;随拉压强度比的增大,膨胀锥与套管之间的屈服挤毁压强减小.屈服挤毁压强的计算值与试验测试值之间的相对误差为-8.9253%～-0.9901%.     

页岩气低伤害超临界CO2凝胶压裂液研究

针对常规水压裂液会对页岩造成伤害，容易产生水锁，不易返排，还造成水资源消耗和污染环境等问题，制备了低伤害二氧化碳凝胶压裂液。将自备的F2EU和F4EU增稠剂加入到超临界CO₂基液中，探究两种增稠剂的加入量对CO₂凝胶压裂液黏度的影响，综合考虑成本与效果，优选了2%的F4EU增稠剂，可将CO₂的黏度增至15.4 mPa·s。研究了温度、压力以及剪切速率对凝胶压裂液黏度的影响。实验结果表明，随着温度升高黏度总体降低，但中间出现一个短暂升高阶段；随着压力上升压裂液黏度增加；随着剪切速率的增加压裂液黏度下降，属于一种典型的剪切变稀的假塑性流体。F4EU超临界CO₂凝胶压裂液的平均伤害率为1.39%，远远小于常规压裂液对岩芯的伤害率。实验表明，F4EU超临界CO₂凝胶压裂液在页岩气压裂开采中具有良好的应用前景。     

Predicting Initial Formation Temperature for Deep Well Engineering with a New Method

With the progress of science and technology, human beings explore the energy under-ground with thousands of meters. As a thermophysical parameter, initial formation temperature (IFT) plays an essential...