首页 | 本学科首页   官方微博 | 高级检索  
     检索      

步进式加热炉内钢坯加热过程的模拟研究
引用本文:徐东,祭程,朱苗勇,唐正友.步进式加热炉内钢坯加热过程的模拟研究[J].东北大学学报(自然科学版),2013,34(2):244-247.
作者姓名:徐东  祭程  朱苗勇  唐正友
作者单位:东北大学材料与冶金学院,辽宁沈阳,110819
基金项目:国家自然科学基金青年基金资助项目(51004030,50901014);中央高校基本科研业务费专项资金资助项目(N100102001,N100402006)
摘    要:采用ABAQUS商业有限元软件对步进式加热炉内钢坯加热过程进行了分析计算,建立了加热炉内钢坯加热的热力耦合模型,计算了不同热送条件下,中心与表面的应力应变分布.结果表明:随着加热时间的延长及加热温度的提高,应力由铸坯表面向铸坯中心逐步增大;随着热送温度的升高,最大应变量逐步减少,应力存在一个拐点,且逐步出现双应力峰值.分析得出,在现有加热制度下,适合的热送温度在600℃左右.

关 键 词:加热炉  大方坯  温度场  有限元法  应力应变  

Simulation for Bloom Heating-up Process in Reheating Furnace
XU Dong,JI Cheng,ZHU Miao-yong,TANG Zheng-you.Simulation for Bloom Heating-up Process in Reheating Furnace[J].Journal of Northeastern University(Natural Science),2013,34(2):244-247.
Authors:XU Dong  JI Cheng  ZHU Miao-yong  TANG Zheng-you
Institution:(School of Materials & Metallurgy,Northeastern University,Shenyang 110819,China.)
Abstract:The bloom heating-up process of a reheating furnace was calculated and analyzed using the FEM based commercial software ABAQUS. A thermal-mechanical coupling model was established and the distribution of stress and strain was calculated under different hot charging conditions. The results show that the stress increases from the bloom surface to center with increasing the heating time and temperature. As the hot charging temperature rises, the maximum strain gradually decreases with a turning point of stress appearing, evolving double peak stress curve. The analysis indicates that the proper hot charging temperature is about 600 °C in the existing heating system.
Keywords:reheating furnace  bloom  temperature field  FEM  stress and strain  
本文献已被 CNKI 万方数据 等数据库收录!
点击此处可从《东北大学学报(自然科学版)》浏览原始摘要信息
点击此处可从《东北大学学报(自然科学版)》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号