| 高强度钢板复杂零件的冲压压边圈拓扑优化 |
| |
| 引用本文： | 汤禹成,徐栋恺,陈军.高强度钢板复杂零件的冲压压边圈拓扑优化[J].上海交通大学学报,2010,44(1):6-0010. |
| |
| 作者姓名： | 汤禹成 徐栋恺 陈军 |
| |
| 作者单位： | 上海交通大学 模具CAD国家工程研究中心 |
| |
| 基金项目： | 国家高技术研究发展计划(863)资助项目(2007AA04Z130) |
| |
| 摘 要： | 在分析冲压模具结构的基础上,提出了冲压模具结构拓扑优化方法,建立了以减重为目标的高强度钢板压边圈优化设计方法,并以DP590轿车侧向高强度双向钢底板拉深压边圈为例加以验证.结果表明:与按准则的设计相比,采用拓扑优化设计的压边圈可以减重50%,且其结构的关键位移及最大应力均未受到影响.
|
| 关 键 词： | 高强度钢板 模具结构分析 拓扑优化 |
| 收稿时间： | 2009-7-16 |
Topology Optimization of Blank Holder Structure of Stamping Die for Forming Complicated Automotive Part of High-Strength Sheet Metal |
| |
| TANG Yu-cheng,XU Dong-kai,CHEN Jun.Topology Optimization of Blank Holder Structure of Stamping Die for Forming Complicated Automotive Part of High-Strength Sheet Metal[J].Journal of Shanghai Jiaotong University,2010,44(1):6-0010. |
| |
| Authors: | TANG Yu-cheng XU Dong-kai CHEN Jun |
| |
| Institution: | National Engineering Research Center of Die & Mold CAD, Shanghai Jiaotong University |
| |
| Abstract: | Based on die structure analysis, an SIMP based die structure topology optimization model was proposed. An optimal design method for binder part was established, aiming to reduce die weight. Optimization of binder structure of a floor member part of DP590 was studied. Compared with current design, optimally designed binder can reduce 50% weight. And the critical displacement and maximum stress are not affected. |
| |
| Keywords: | high-strength steel die structure analysis topology optimization |
| 本文献已被 CNKI 等数据库收录！ |
| 点击此处可从《上海交通大学学报》浏览原始摘要信息 |
| 点击此处可从《上海交通大学学报》下载免费的PDF全文 |
