流化床中光催化降解4BS染料废水的影响因素分析

用浸涂法以硅酸钠为粘结剂在沙子上制备了负载纳米TiO2光催化剂,在二相流化床光催化反应器中,通过处理4BS染料溶液考察了光催化剂的光催化活性和影响因素.得出最佳转化条件为, 催化剂(沙子,硅酸钠,二氧化钛)的最佳质量配比为10:1:2 ,光催化剂最适用量为20 mg,溶液中Fe3+最佳添加量为25 mg/L,在此条件下孔径0.45(40目)～0.90 mm(20目)的负载光催化剂处理20 mg/L的4BS染料溶液2 h,光催化降解率达到81.9%.结果还表明,溶液pH值为2～6时,光催化剂对4BS染料溶液的光催化降解率更高.

Analysis of Factors Influencing the Photocatalytic Degradation of 4BS Dye in Wastewater by Fluidized Bed

Coated-TiO2 photocatalyst on sand with sodium silicate as binder was prepared by the dipping method.The factors influencing the photodegradation rate of 4BS dye solution were investigated in a two-phase fluidized bed reactor.It was found that the optimal conditions for photo-catalytic conversion are that the best mass ratio for sand,TiO2 and sodium silicate is 10∶1∶2,the optimum photocatalyst dosage is 20 mg,and the optimal Fe3+ concentration in 4BS solution is 25 mg/L.At this conditions photodegredate rate of 81.9% could reach.The 4BS solution was illuminated and reacted 2 hours by coated-TiO2 photocatalyst binderded at sand within 20 to 40 meshes.It is also shown that the degradation conversion is higher at the pH ranges form 2 to 6.