首页 | 本学科首页   官方微博 | 高级检索  
     检索      

基于模糊修正的叉车自动称重系统研究
引用本文:刘美俊,郑志达,张辑,于季刚.基于模糊修正的叉车自动称重系统研究[J].厦门理工学院学报,2010,18(1):39-42.
作者姓名:刘美俊  郑志达  张辑  于季刚
作者单位:1. 厦门理工学院电子与电气工程系,福建,厦门,361024
2. 安特威尔叉车属具,厦门,有限公司,福建,厦门,361100
基金项目:厦门市科技计划项目(3502Z20093036)
摘    要:针对叉车的工作特点,探讨了叉车自动称重系统的设计方法,分析了叉车的受力情况,对系统的组成、信号采集、数据处理进行了研究.重点阐述了二维测力和模糊修正的组合新方法,实现了称重的智能化,保证了受载信号的精确度,同时论述了称重时货物的偏载影响及消除这些影响的措施,实验证明了本系统的有效性.

关 键 词:叉车  自动称重  受力分析  模糊修正  实验

The Research on the Auto Fork-Lift Scale System Based on Fuzzy Modifier
LIU Mei-jun,ZHENG Zhi-da,ZHANG Ji,YU Ji-gang.The Research on the Auto Fork-Lift Scale System Based on Fuzzy Modifier[J].Journal of Xiamen University of Technology,2010,18(1):39-42.
Authors:LIU Mei-jun  ZHENG Zhi-da  ZHANG Ji  YU Ji-gang
Institution:1. Faculty of Electronic and Electrical Engineering, Xiamen University of Technology, Xiamen 361024, China; 2. Antwell Forklift Truck Attachment( Xiamen), Xiamen 361100, China)
Abstract:According to the characteristics of fork-lift at work,the design method of auto fork-lift scale is presented in this paper,the force analysis,the principle of the system and signal acquisition and data disposal are introduced,a kind of fuzzy modifier and two-dimensional force measurement is emphasized.To reach the goal mentioned above,the accurancy of loading signal should be controlled in a certain range besides computerizing the whole system.This paper emphasizes the influence of cargo eccentric load-bear...
Keywords:fork-lift  auto weigh  force analysis  fuzzy modifier  experiment  
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号