| 球形刀三坐标曲面加工刀位计算及误差分析研究 |
| |
| 引用本文： | 谢黎明,蔡善乐,张永贵,马志宏,蒋钧钧. 球形刀三坐标曲面加工刀位计算及误差分析研究[J]. 甘肃科学学报, 2002, 14(4): 53-57 |
| |
| 作者姓名： | 谢黎明 蔡善乐 张永贵 马志宏 蒋钧钧 |
| |
| 作者单位： | 甘肃工业大学机电工程学院,甘肃兰州,730050 |
| |
| 基金项目： | 教育部高等学校重点实验室访问学者基金项目(2001-03) |
| |
| 摘 要： | 针对三坐标数控编程及加工中的刀位计算问题，分析了计算球形刀在被加工曲面上任意一点刀具中心轨迹的坐标公式，讨论了采用球形刀加工而引起加工方法误差的原因及误差补偿方法，并给出了走刀步长与加工误差的关系式。
|
| 关 键 词： | 球形刀三坐标曲面加工 刀位计算 数控加工 误差分析 数控机床 NC加工程序 |
| 文章编号： | 1004-0366(2002)04-0053-05 |
| 修稿时间： | 2001-11-06 |
A STUDY ON THE CALCULATED POSITION OF THE SPHERE-SHAPED CUTTER IN CURVED SURFACE MACHINING AND ON ITS ERROR ANALYSIS |
| |
| XIE Li|ming,CAI Shan|le,ZHANG Yong|gui,MA Zhi|hong,JIANG Jun|jun. A STUDY ON THE CALCULATED POSITION OF THE SPHERE-SHAPED CUTTER IN CURVED SURFACE MACHINING AND ON ITS ERROR ANALYSIS[J]. Journal of Gansu Sciences, 2002, 14(4): 53-57 |
| |
| Authors: | XIE Li|ming CAI Shan|le ZHANG Yong|gui MA Zhi|hong JIANG Jun|jun |
| |
| Abstract: | The problem of calculating the position of the cutter during three|coordinate NC machining and programming is discussed. The formula of calculating the coordinate of the sphere|shaped cutter's track of center at the machined hood face is analyzed.The reason and the compensating method of the machining error caused by using the sphere|shaped cutter during machining are discussed. The formulas of the step and machining error are also given. |
| |
| Keywords: | sphere|headed cutter hood face machining numerical control error analyzis |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
