首页 | 本学科首页   官方微博 | 高级检索  
     

小断面收缩率轴类零件楔横轧成形的可行性分析
引用本文:刘文科,张康生,胡正寰. 小断面收缩率轴类零件楔横轧成形的可行性分析[J]. 北京科技大学学报, 2011, 33(6): 762-765
作者姓名:刘文科  张康生  胡正寰
作者单位:北京科技大学机械工程学院,北京,100083
基金项目:国家自然科学基金资助项目(No.51075030)
摘    要:利用ANSYS/LS-DYNA软件,对楔横轧小断面收缩率轴类零件的成形过程进行了有限元数值模拟,通过与常规断面收缩率轧件对比,分析了小断面收缩率轧件的表面和心部质量情况.结果表明:相同工艺参数条件下,小断面收缩率轧件横截面的椭圆度大于常规断面收缩率轧件;由于小断面收缩率轧件中心点处的平均应力和最大主应力均较大,因而更容易发生心部缺陷.提出了改善轧件表面和心部质量的措施.经轧制实验验证,楔横轧成形小断面收缩率轴类零件是可行的.

关 键 词:  楔横轧  金属成形  有限元法  应力分析

Feasibility study on forming light area reduction shafts by cross wedge rolling
LIU Wen-ke,ZHANG Kang-sheng,HU Zheng-huan. Feasibility study on forming light area reduction shafts by cross wedge rolling[J]. Journal of University of Science and Technology Beijing, 2011, 33(6): 762-765
Authors:LIU Wen-ke  ZHANG Kang-sheng  HU Zheng-huan
Affiliation:LIU Wen-ke,ZHANG Kang-sheng Wingdingsj,HU Zheng-huanSchool of Mechanical Engineering,University of Science and Technology Beijing,Beijing 100083,China
Abstract:The forming process of light area reduction shafts by cross wedge rolling was simulated with the analysis software ANSYS/LS-DYNA.Surface and central qualities of light area reduction rolled pieces were analyzed in comparison with those of conventional area reduction rolled pieces.It is found that the ovality of the light area reduction rolled piece exceeds that of the conventional area reduction rolled piece under the same process parameter condition.Compared with the conventional area reduction rolled piec...
Keywords:shafts  cross wedge rolling  metal forming  finite element method  stress analysis  
本文献已被 CNKI 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号