首页 | 本学科首页   官方微博 | 高级检索  
     

UCMW轧机正弦函数形单锥度工作辊边降控制
引用本文:张赟,杨荃,邵健,杜晓钟,王晓晨. UCMW轧机正弦函数形单锥度工作辊边降控制[J]. 北京科技大学学报, 2009, 31(12)
作者姓名:张赟  杨荃  邵健  杜晓钟  王晓晨
作者单位:北京科技大学冶金工程研究院,北京,100083
基金项目:国家科技支撑计划专题 
摘    要:以某冷轧宽带钢UCMW轧机为研究对象,采用有限元法分析了单锥度工作辊窜辊和单锥度工作辊端部辊形对边降控制的影响. 结果表明:端部辊形采用正弦函数时,随工作辊端部锥段窜入带钢深度的增加,边降呈抛物线关系减小;工作辊窜辊的边降调控能力随端部辊形有效段锥度的增加而增加. 同一窜辊深度下,增大有效段锥度可以减小边降;不改变有效段辊形而减小锥段长度可以减小边降. 此外,减小锥度和增大锥长可减小最大辊间压力和辊间压力不均匀度.

关 键 词:冷轧机  锥度辊  正弦函数  板形控制  有限元

Edge drop control using sinusoidal tapered work roll on a UCMW mill
ZHANG Yun,YANG Quan,SHAO Jian,DU Xiao-zhong,WANG Xiao-chen. Edge drop control using sinusoidal tapered work roll on a UCMW mill[J]. Journal of University of Science and Technology Beijing, 2009, 31(12)
Authors:ZHANG Yun  YANG Quan  SHAO Jian  DU Xiao-zhong  WANG Xiao-chen
Abstract:Taking the UCMW mill, a cold rolling mill, for an example, the finite element method (FEM) was employed to estimate the effects of tapered work roll shifting and the change in roll contour of the work roll end on edge drop control. The results show that the edge drop of cold rolled strips decreases with the increase in penetration length of the tapered part into strip edge when the work roll end is defined as a sinusoid curve, and the function of edge drop to work roll shifting is parabolic. The effect of work roll shifting on edge drop control increases with the increase in taper at the work roll end. Edge drop can be alleviated by increasing the taper of the work roll end at the same work roll shifting, whereas it can be also reduced when the roll contour at the work roll end does not change but the taper length decreases. In addition both the unevenness of pressure distribution and the maximum pressure between the work roll and the intermediate roll can be alleviated in terms of decreasing the taper and increasing the taper length.
Keywords:cold rolling mill  tapered roll  sine function  shape control  finite element method
本文献已被 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号