| 基于Matlab-Simuink的串联型有源电力滤波器的仿真研究 |
| |
| 引用本文： | 罗耀华,吴永亮. 基于Matlab-Simuink的串联型有源电力滤波器的仿真研究[J]. 应用科技, 2009, 36(10): 38-43. DOI: 10.3969/j.issn.1009-671X.2009.10.011 |
| |
| 作者姓名： | 罗耀华 吴永亮 |
| |
| 作者单位： | 哈尔滨工程大学,自动化学院,黑龙江,哈尔滨,150001 |
| |
| 摘 要： | 介绍了串联型有源电力滤波器的基本工作原理,研究了基于三相瞬时无功功率理论的谐波电压检测方法,并分析了系统主要参数的选取方法,最后结合检测负载谐波电压控制方式用Matlab/Simulink搭建了系统的仿真模型.仿真结果验证了在合理的参数配置下,串联型有源电力滤波器可对电压型谐波能进行较好的补偿,使得电源电流的畸变减小.
|
| 关 键 词： | 有源电力滤波器 谐波检测 参数选择 Matlab建模与仿真 |
Researches on series active power filter based on Matlab/Simulink |
| |
| LUO Yao-hua,WU Yong-liang. Researches on series active power filter based on Matlab/Simulink[J]. Applied Science and Technology, 2009, 36(10): 38-43. DOI: 10.3969/j.issn.1009-671X.2009.10.011 |
| |
| Authors: | LUO Yao-hua WU Yong-liang |
| |
| Affiliation: | (College of AutomationHarbin Engineering University, Harbin 150001, China) |
| |
| Abstract: | This paper presents the basic operation principle and the harmonic voltage detecting method based on 3 phase instantaneous reactive power theory. The circuit parameter selection method is analyzed. Finally using the Matlab/Simulink software （mainly the toolbox PowerSystem Blockset）, a simulation system of series active power filter with the control scheme of detecting the load harmonic voltage method is built. In the end, a result is given to show that the series active power filter can compensate the voltage type harmonic source correctly and feasibly and reduce aberrance of current under proper parameter configuration. |
| |
| Keywords: | active power filter harmonics detecting method parameter selection Matlab simulation |
| 本文献已被 维普 万方数据 等数据库收录！ |
