首页 | 本学科首页   官方微博 | 高级检索  
     

FGH96合金双道次热变形及其热加工图
引用本文:方彬,纪箴,田高峰,贾成厂,胡本芙,崔照雯. FGH96合金双道次热变形及其热加工图[J]. 北京科技大学学报, 2015, 0(3): 336-344. DOI: 10.13374/j.issn2095-9389.2015.03.012
作者姓名:方彬  纪箴  田高峰  贾成厂  胡本芙  崔照雯
作者单位:1. 北京科技大学材料科学与工程学院,北京,100083;2. 北京航空材料研究院,北京,100095
基金项目:国家重点基础研究发展计划资助项目
摘    要:采用 Gleeble-1500热模拟试验机对 FGH96合金进行双道次真应变量为0.6+0.6和0.3+0.9的等温间断热压缩试验,研究了变形温度为1050~1125℃、变形速率为0.001~0.1 s -1时合金的热变形行为和组织演变.热变形过程中合金发生了再结晶,第一道次较小的真应变量减轻了合金的开裂.当第一道次真应变量小时,随着温度和变形速率的上升,合金道次间再结晶软化率增加.不同应变量以及不同道次真应变量均对合金热加工图产生明显影响.在相同变形条件下,当能量耗散率随应变量的增加而下降时,合金中组织由细晶向粗晶转变,反之则由粗晶向细晶转变;当能量耗散率不随应变量的变化而变化时,能量耗散率低于20%的合金中出现大量的不完全再结晶组织,能量耗散率高于35%的合金中出现细小完全再结晶组织.

关 键 词:高温合金  双道次  热变形  加工  组织演变

Flow behavior and processing map of FGH96 superalloy during two-pass hot deformation
FANG Bin,JI Zhen,TIAN Gao-feng,JIA Cheng-chang,HU Ben-fu,CUI Zhao-wen. Flow behavior and processing map of FGH96 superalloy during two-pass hot deformation[J]. Journal of University of Science and Technology Beijing, 2015, 0(3): 336-344. DOI: 10.13374/j.issn2095-9389.2015.03.012
Authors:FANG Bin  JI Zhen  TIAN Gao-feng  JIA Cheng-chang  HU Ben-fu  CUI Zhao-wen
Affiliation:FANG Bin;JI Zhen;TIAN Gao-feng;JIA Cheng-chang;HU Ben-fu;CUI Zhao-wen;School of Materials Science and Engineering,University of Science and Technology Beijing;Beijing Institute of Aeronautical Materials;
Abstract:Isothermal interrupted hot compression tests of FGH96 superalloy at the two-pass strains of 0. 6 + 0. 6 and 0. 3 + 0. 9 were performed on a Gleeble- 1500 thermo-mechanical simulator. The hot deformation behavior and microstructural evolution of the su-peralloy were investigated in the deformation temperature range of 1050 to 1125 ℃ and the strain rate range of 0. 001 to 0. 1 s - 1 . It is found that recrystallization happens during the two-pass hot deformation, and less deformation in the first pass results in less cracks in samples. As the first-pass hot deformation is less, the recrystallization degree increases during the deformation gap with increasing de-formation temperature and strain rate. An obviously change is found in the processing map with different strains or different two-pass strains. Under the same deformation condition, when the energy dissipation rate changes with strain, different microstructural evolution rules happen. When the energy dissipation rate decreases with increasing strain, the recrystallization grains coarsen; otherwise, the re-crystallization grains refine. But when the energy dissipation rate does not change with strain, coarse grains appear with the energy dis-sipation rate lower than 20% or a fine grain microstructure appears with the energy dissipation rate higher than 35% .
Keywords:superalloys  two-pass procedure  hot deformation  processing  microstructural evolution
本文献已被 CNKI 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号