| 冲床数控化的微机控制——冲床数控化之二 |
| |
| 引用本文： | 卢励勤,谢虞华,高成岳,祁国忠.冲床数控化的微机控制——冲床数控化之二[J].贵州工业大学学报(自然科学版),1986(1). |
| |
| 作者姓名： | 卢励勤 谢虞华 高成岳 祁国忠 |
| |
| 作者单位： | 贵州工学院采矿系，贵州工学院采矿系，贵州工学院采矿系，贵州工学院采矿系 |
| |
| 摘 要： | 本文介绍以TP——801单版微型计算机为核心控制器的数控冲床控制系统,论述了控制的原理和方法,给出了有关程序流程和模块,接口电路和执行电路。
|
| 关 键 词： | 数控冲床 模块 程序流程 控制器 接口电路 执行电路 |
The Microcomputer Control of the Numerically Controlled Punch |
| |
| Lu Liqin,Xie Yuhua,Gao Chengyue,Qi Guozhong the.The Microcomputer Control of the Numerically Controlled Punch[J].Journal of Guizhou University of Technology(Natural Science Edition),1986(1). |
| |
| Authors: | Lu Liqin Xie Yuhua Gao Chengyue Qi Guozhong the |
| |
| Institution: | Lu Liqin;Xie Yuhua;Gao Chengyue;Qi Guozhong the Department of Mining Engineering |
| |
| Abstract: | This paper describes the control system for an numerically controlled punch, the central controller of which is the Tp-801 microcomputer. It also discusses the principles and the mode of control. Eventually it shows the relative flow chart and module, the interface circuit and executive circuit. |
| |
| Keywords: | numerically controlled punch controller flow chart module Interface circuit executive circuit |
| 本文献已被 CNKI 等数据库收录！ |
