| 液压仿形铣床微电脑控制器 |
| |
| 引用本文： | 林章省.液压仿形铣床微电脑控制器[J].华侨大学学报(自然科学版),1990,11(1):100-107. |
| |
| 作者姓名： | 林章省 |
| |
| 作者单位： | 华侨大学电子工程系 |
| |
| 摘 要： | 本文介绍液压仿形铣床微电脑控制系统的设计过程和运行情况.提出了机床的控制任务;基本加工顺序和人工调整及特殊要求;叙述了系统硬件;微电脑的选取,接口和强电控制电路的设计;论述了系统软件,包括主控制器的 I/O 地址分配,输出与输入信号间的关系的分析和综合,用逻辑代数法设计的程序流程图及其特点.
|
| 关 键 词： | 仿形铣床 液压 微机控制 系统软件 |
Microcomputer Controller for a Hydraulic Form Milling Machine |
| |
| Lin Zhangsheng.Microcomputer Controller for a Hydraulic Form Milling Machine[J].Journal of Huaqiao University(Natural Science),1990,11(1):100-107. |
| |
| Authors: | Lin Zhangsheng |
| |
| Institution: | Lin Zhangsheng |
| |
| Abstract: | This paper describes the desisn procedure of a microcomputer control system for a hydraulic form milling machine and its operational aspect.It besins with the task of machine tool control,including elementary procedure of milling operation and manual adjustment and particular requirements;and then it descr- ibes system hardwares,including selection of microcomputer and the design of interface and heavy-current control circuits;and finally it shows system softwares, including I/O address assignment of the master controller,analysis and synthe- sis on the relation of input and output signals,program flow chart designed by means of logic algebra and its characteristic. |
| |
| Keywords: | microcmputer comtroller machine tool control system hardwares system softwares |
| 本文献已被 CNKI 维普 等数据库收录！ |
|
