首页 | 本学科首页   官方微博 | 高级检索  
     

导管架平台浮托法安装的数值模拟与模型试验
引用本文:许鑫,杨建民,吕海宁. 导管架平台浮托法安装的数值模拟与模型试验[J]. 上海交通大学学报, 2011, 45(4): 439-445
作者姓名:许鑫  杨建民  吕海宁
作者单位:(上海交通大学 海洋工程国家重点实验室, 上海 200240)
基金项目:国家高技术研究发展计划(863)项目(2006AA09A107),上海市科委基地能力建设项目(07DZ22027)
摘    要:以一座导管架平台实际安装为例,分别使用数值计算和模型试验的方法对浮托法安装进行了系统的研究.对整个浮托安装过程仔细剖析,选出具有代表性的工况,分别从频域和时域两方面分析.分析结果表明,数值计算与模型试验结果吻合良好,数值模拟方法具有较高的可靠性.在所考虑的海况条件下,驳船与上部模块运动符合要求,各种装置上受力均在允许范围内,可以进行安装作业.

关 键 词:   浮托法; 导管架平台; 海上安装; 上部模块  
收稿时间:2010-03-18

Experimental and Numerical Analysis for Floatover Installation on Jacket
XU Xin,YANG Jian-Min,LV Hai-Ning. Experimental and Numerical Analysis for Floatover Installation on Jacket[J]. Journal of Shanghai Jiaotong University, 2011, 45(4): 439-445
Authors:XU Xin  YANG Jian-Min  LV Hai-Ning
Affiliation:(State Key Laboratory of Ocean Engineering, Shanghai Jiaotong University, Shanghai 200240, China)
Abstract:This paper investigated the floatover installation process on a jacket with numerical and experimental analysis. Numerical analyses in both frequency and time domain were carried out for typical configurations during floatover operation. Corresponding model tests were also performed in ocean engineering basin. The comparison between numerical and experimental results shows that the response amplitude operator and time series agree quite well. The barge has favorable hydrodynamic behavior in considered sea state and the loads of equipments are allowable. The floatover operation on the jacket is feasible.
Keywords:floatover  jacket  offshore installation  topside  
点击此处可从《上海交通大学学报》浏览原始摘要信息
点击此处可从《上海交通大学学报》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号