首页 | 本学科首页   官方微博 | 高级检索  
     检索      

核电站给水加热器建模与仿真
引用本文:刘洪涛,彭敏俊,田兆斐,薛若军.核电站给水加热器建模与仿真[J].应用科技,2011,38(6):67-72.
作者姓名:刘洪涛  彭敏俊  田兆斐  薛若军
作者单位:哈尔滨工程大学核安全与仿真技术国防重点学科实验室,黑龙江,哈尔滨,150001
摘    要:核电站中所应用的给水加热器的建模是核电厂热力系统仿真的重要组成部分.文中建立了核电机组给水加热器双区多节点动态数学模型,并利用大亚湾核电站和秦山二期核电站中使用的高压给水加热器数据进行了稳态验证,仿真值与设计值相对误差在1%以内.在此基础上,利用所建模型研究了大亚湾核电站第6级给水加热器给水流量阶跃减少、加热蒸汽流量阶跃减少2种瞬态工况.结果表明,所建数学模型能够准确地反映给水加热器在特定工况下的动态特性,基本可以满足工程仿真分析的要求,并可作为工程仿真的一个模块使用.

关 键 词:核电站  给水加热器  建模  仿真

Modeling and simulation of the feed-water heater in a nuclear power plant
LIU Hongtao,PENG Minjun,TIAN Zhaofei,XUE Ruojun.Modeling and simulation of the feed-water heater in a nuclear power plant[J].Applied Science and Technology,2011,38(6):67-72.
Authors:LIU Hongtao  PENG Minjun  TIAN Zhaofei  XUE Ruojun
Institution:LIU Hongtao,PENG Minjun,TIAN Zhaofei,XUE Ruojun (National Defense Key Subject Laboratory of Nuclear Safety and Simulation Technique,Harbin Engineering University,Harbin 150001,China)
Abstract:The modeling of a feed-water heater is an important part of the thermal system simulation in a nuclear power plant(NPP).In this paper,dual-zone and multi-node dynamic mathematical simulation model of the feed-water heater is built.This model is evaluated by comparing the design parameters of the Daya Bay NPP high-pressure feed water heaters and Qinshan Phase II NPP high-pressure feed water heaters.It is shown that the relative error between steady-state calculation result and design parameters is within 1%....
Keywords:nuclear power plant  feed-water heater  modeling  simulation  
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号