| 涡轮逆向工程的三维扫描检测技术 |
| |
| 引用本文： | 谢雪冬.涡轮逆向工程的三维扫描检测技术[J].黑龙江科技学院学报,2013(5):479-481. |
| |
| 作者姓名： | 谢雪冬 |
| |
| 作者单位： | 黑龙江科技大学现代制造工程中心,哈尔滨150022 |
| |
| 基金项目： | 国家科技重大专项项目（2020ZX04016-012）;博士后研究人员落户黑龙江科研启动资助金项目（LBH-Q12019） |
| |
| 摘 要： | 为提高涡轮的三维扫描检测技术水平,采用三维扫描的相位测量技术获取涡轮增压器三维点云数据.利用三维点云数据重构涡轮检测模型,并应用GEOMAGIC QUALIFY软件对其进行3D误差分析和尺寸标注.实验结果表明：涡轮70％左右的数据点云与实物模型之间的偏差在-0.2～0.2mm之间,能够满足涡轮检测质量要求.
|
| 关 键 词： | 逆向工程 测量 检测 质量评价 |
3D scanning detection technology of turbine reverse engineering |
| |
| XIE Xuedong.3D scanning detection technology of turbine reverse engineering[J].Journal of Heilongjiang Institute of Science and Technology,2013(5):479-481. |
| |
| Authors: | XIE Xuedong |
| |
| Institution: | XIE Xuedong( 1.Modern Manufacture Engineering Center, Heilongjiang University of Science ＆ Technology, Harbin 150022, China;) |
| |
| Abstract: | Aimed at improving the 3D scanning measurement technology of turbine,this paper discusses the achievement of the 3 D point cloud data of the turbocharger by the phase measurement technology of 3D scanning,the reconstruction turbo detection model using the 3D point cloud data,and the realization of the 3D error analysis and dimension marking using the GEOMAGIC QUALIFY software.The experimental results show that the deviation in the range of the-0.2 ～ 0.2 mm between around 70％ of the data point cloud and physical model is adequate for the purpose of the quality detection. |
| |
| Keywords: | reverse engineering measurement testing quality evaluation |
| 本文献已被 维普 等数据库收录！ |
