|
|||||
|
|
| 基于Pro/E的车用起重尾板举升机构运动仿真 | |
| 引用本文： | 田杰,商高高,周黎敏.基于Pro/E的车用起重尾板举升机构运动仿真[J].南京林业大学学报(自然科学版),2006,30(5):76-78. |
| 作者姓名： | 田杰 商高高 周黎敏 |
| 作者单位： | 1. 南京林业大学机械电子工程学院,江苏,南京,210037;江苏大学汽车与交通工程学院,江苏,镇江,212013 2. 江苏大学汽车与交通工程学院,江苏,镇江,212013 3. 南京林业大学机械电子工程学院,江苏,南京,210037 |
| 基金项目： | 跃进汽车集团南京标准件有限公司资助项目 |
| 摘 要： | 在利用Pro/E建立了车用起重尾板举升机构的三维模型后,对举升机构进行了运动仿真,根据检查到的干涉情况对设计中潜在的问题进行了修改。并对仿真过程中机构的关键点和重要参数进行了测量和分析,结果表明该举升机构运动平稳,且油缸行程均在设计范围内,因此能够满足使用要求,同时也验证了该模型的正确性。 |
| 关 键 词： | 车用起重尾板 举升机构 三维建模 运动仿真 |
| 文章编号： | 1000-2006(2006)05-0076-03 |
| 收稿时间： | 2005-11-10 |
| 修稿时间： | 2006-04-10 |
Motion Simulation of Tail-lift Lifting Mechanism for Vehicle Based on Pro/E |
|
| TIAN Jie,SHANG Gao-gao,ZHOU Li-min.Motion Simulation of Tail-lift Lifting Mechanism for Vehicle Based on Pro/E[J].Journal of Nanjing Forestry University(Natural Sciences ),2006,30(5):76-78. | |
| Authors: | TIAN Jie SHANG Gao-gao ZHOU Li-min |
| Institution: | 1. College of Electronic and Mechanical Engineering, Nanjing Forestry University, Nanjing 210037, China; 2. School of Automobile and Traffic Engineering,Jiangsu University,Zhenjiang 212013,China |
| Abstract: | After modeling the three-dimensional solid model and motion simulation of the tail-lift lifting mechanism for vehicle based on Pro/E,the lifting mechanism was revised according to the interference check.Measurement and analysis of the key point and the pivotal parameters were carried during the simulation.The simulation results show that the lifting mechanism has stable movement and both of the hydro cylinder strokes are in the design range,it can meet the operation requirements and the simulation model is proved to be correct. |
| Keywords: | Tail-lift for vehicle Lifting mechanism Three-dimensional modeling Motion simulation |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ | |