首页 | 本学科首页   官方微博 | 高级检索  
     

微量样品pH测量的实现
引用本文:微量样品pH测量的实现. 微量样品pH测量的实现[J]. 山东科学, 2010, 33(2): 126-130. DOI: 10.3976/j.issn.1002-4026.2020.02.018
作者姓名:微量样品pH测量的实现
作者单位:温州大学 数理学院,浙江 温州 325035
基金项目:国家自然科学基金(11574232,11274245);浙江省自然科学基金(LY17A040006);国家大学生创新创业训练计划(201810351031);校级大学生创新创业训练计划(DC2017057);温州大学实验室开放项目
摘    要:利用电化学方法将氧化铱薄膜修饰在微电极上制备微量样品pH计,此电极体积很小,测量中只需滴3~5 μL溶液即可测出测试电极与参比电极之间的电势差,然后通过数据采集卡读取数据,将电势差信号转化为数字信号,最后用Matlab拟合输出溶液对应的pH。测量结果与商用pH计基本保持一致,此电极使用方便,灵敏度高,重现性好,而且在稀、贵样品及生物样品的分析中更显示其优越性,具有广阔的发展前景。

关 键 词:pH计   微量样品   氧化铱电极  电势差  小型化  
收稿时间:2019-10-14

Implementation of microsample pH measurement
DONG Jian,XU Shi-yu,HUANG Shen-hao,HE Jia-qi,HU Jie,XI Liang-yan,WANG Yan-wei. Implementation of microsample pH measurement[J]. Shandong Science, 2010, 33(2): 126-130. DOI: 10.3976/j.issn.1002-4026.2020.02.018
Authors:DONG Jian  XU Shi-yu  HUANG Shen-hao  HE Jia-qi  HU Jie  XI Liang-yan  WANG Yan-wei
Affiliation:College of Mathematics and Physics, Wenzhou University, Wenzhou 325035, China
Abstract:A microsample pH meter was prepared by modifying Iridium oxide thin film on a microelectrode using an electrochemical method. In the measurement process, the potential difference between the test and reference electrode was determined by dropping only approximately 3~5 μL solution on the electrode which with small volume. Then, data was obtained using a data acquisition card. The potential difference signal is converted into a digital signal, and the pH value is output with the Matlab software fitting curve. The measurement results of microsample pH meter are consistent with those of commercial pH meters. The electrode is convenient,and high sensitivity and good reproducibility, and it has superiority in the analysis of rare and expensive samples biological samples. Therefore, it has broad development prospects.
Keywords:pH meter   micro sample   iridium oxide electrode   potential difference   miniaturization  
点击此处可从《山东科学》浏览原始摘要信息
点击此处可从《山东科学》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号