| 掺杂钛酸铋钠对钛酸锶钡陶瓷介电性能的影响 |
| |
| 引用本文： | 屈少华,尚玉黎,曹万强. 掺杂钛酸铋钠对钛酸锶钡陶瓷介电性能的影响[J]. 湖北大学学报(自然科学版), 2013, 0(4): 484-486,491 |
| |
| 作者姓名： | 屈少华 尚玉黎 曹万强 |
| |
| 作者单位： | [1]湖北文理学院物理与电子工程学院,湖北襄阳441053 [2]湖北大学材料科学与工程学院,湖北武汉430062 |
| |
| 基金项目： | 湖北省自然科学基金（2012FFlC05101）和功能材料绿色制备与应用教育部重点实验室开放课题资助. |
| |
| 摘 要： | 采用固相法制备钛酸铋钠掺杂的钛酸锶钡（Ba0.9Sr0.1TiO3）铁电陶瓷，研究钛酸铋钠的掺杂量对钛酸锶钡陶瓷的微观结构和介电性能的影响，并探讨相关机理．研究结果表明，在讨论的掺杂范围内，随着钛酸铋钠掺杂量的增加，钛酸锶钡的晶粒尺寸先增大，后减小．当掺杂量为0．5％（质量分数，下同）时，介电弥散发生，半导化现象出现．当钛酸铋钠掺杂量介于1．0%-1．5％之间时，钛酸锶钡陶瓷的介电常数均保持在5000，且居里温度向高温移动到120℃，10kHz频率的介电损耗低于0．05．
|
| 关 键 词： | 钛酸锶钡 钛酸铋钠 介电性 |
Effects of Bi0. 5 Na0. 5TiO3 doping on dielectric properties of BST ceramics |
| |
| QU Shaohua,SHANG Yuli,CAO Wanqiang. Effects of Bi0. 5 Na0. 5TiO3 doping on dielectric properties of BST ceramics[J]. Journal of Hubei University(Natural Science Edition), 2013, 0(4): 484-486,491 |
| |
| Authors: | QU Shaohua SHANG Yuli CAO Wanqiang |
| |
| Affiliation: | 1. Institute of Physics and Electronic Engineering, Hubei University of Arts and Science,Xiangyang 441053,China; 2. School of Material Science and Engineering, Hubei University,Wuhan 430062, China) |
| |
| Abstract: | Bi0. 5 Na0. 5 TiO3 （BNT） added Ba0.9 Sr0. 1 TiO3 （BST） ceramics were prepared by solid state method. Effects of BNT adding amount on the dielectric properties and microstructure of prepared BST ceramics were investigated. The results showed that the microstructure displayed different degree of change as different doping amount. The dielectric constants had a hung increase, and presented obvious diffuse phase transition when BNT doping content was 0.5%（w/w, the same below）, while the doping content over 0.5%, there were no obvious effects on dielectric content but a significant increase on dielectric loss. The curie temperature was observed to move to the higher temperature （120℃）. |
| |
| Keywords: | barium strontium titanate sodium bismuth titanate dielectric properties |
| 本文献已被 维普 等数据库收录！ |
