| 浅谈车床加工螺纹常见故障及解决方法 |
| |
| 引用本文： | 潘忠业.浅谈车床加工螺纹常见故障及解决方法[J].科技情报开发与经济,2006,16(22):278-279. |
| |
| 作者姓名： | 潘忠业 |
| |
| 作者单位： | 太原市高级技工学校,山西,太原,030021 |
| |
| 摘 要： | 分析了车削螺纹时常见的故障,如牙型角不正确、螺距(或导程)不正确、表面粗糙度值大、乱牙、中径不正确等,针对故障产生的原因提出了相应的解决方法。
|
| 关 键 词： | 牙型角 螺距 表面粗糙度 |
| 文章编号： | 1005-6033（2006）22-0278-02 |
| 收稿时间： | 2006-08-25 |
| 修稿时间： | 2006年8月25日 |
Talking about the Common Faults of the Screw Processing with the Lathe and Solving Methods |
| |
| PAN Zhong-ye.Talking about the Common Faults of the Screw Processing with the Lathe and Solving Methods[J].Sci-Tech Information Development & Economy,2006,16(22):278-279. |
| |
| Authors: | PAN Zhong-ye |
| |
| Institution: | PAN Zhong-ye |
| |
| Abstract: | This paper analyzes on the common faults of the screw processing with the lathe, such as the incorrect thread angle, the incorrect pitch, the large value of surface roughness, the disorderly thread and the incorrect pitch diameter, and in the light of these faults, advances some corresponding solving methods. |
| |
| Keywords: | thread angle pitch surface roughness |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
