| 滚轮法测量大直径的探讨 |
| |
| 引用本文： | 玄兆燕,孙荣平.滚轮法测量大直径的探讨[J].河北理工学院学报,1998,20(2):47-50. |
| |
| 作者姓名： | 玄兆燕 孙荣平 |
| |
| 作者单位： | [1]唐山钢铁公司培训中心 [2]北京科技大学 |
| |
| 摘 要： | 在滚轮法测量大直径探讨的基础上，针对滚轮法测量的打滑问题，提出了分段取值，统计定值，合理地补偿的处理方法，并进行了软，硬件设计，最后通过实测，取得了初步结果。
|
| 关 键 词： | 大直径测量 光电传感器 滚轮法 机械工业 |
AN APPROACH TO MEASURELARGE DIAMETER BY MEANS OF ROLL ING WHEEL |
| |
| Xuan Zhaoyan.AN APPROACH TO MEASURELARGE DIAMETER BY MEANS OF ROLL ING WHEEL[J].Journal of Hebei Institute of Technology,1998,20(2):47-50. |
| |
| Authors: | Xuan Zhaoyan |
| |
| Institution: | Xuan Zhaoyan (Tangshan Iron and Steel Company Training Centre) Song Rongping (Bieijing University of Science and Technology) |
| |
| Abstract: | A computer controlled large diameter system which consists of base wheel,rolling grate sentor,photoelectric gate sensor,MCS8098 and pc is studied in this paper.Aimed at the problem of the base wheel slipping,a new method is put forward to compensate the slipping value of the slipped section.Based on this method,a software and hardware is designed.A preliminary results are obtained by this system in experiments. |
| |
| Keywords: | Large diameter measurement Sensor Computer |
| 本文献已被 CNKI 维普 等数据库收录！ |
