Effect of heat treatment on microstructures and properties of a novel Al-Zn-Mg-Cu alloy for oil drilling

In view of the special requirements for strength, heat resistance and corrosion resistance of Al-Zn-Mg-Cu alloy for oil drilling, the Al-6.2 Zn-2.5 Mg-1.6 Cu alloy was prepared by increasing Cu content on basis of Russian Series 1953 alloy. The effect of heat treatment on the microstructures and properties of the alloy was characterized by optical microscope(OM), scanning electron microscope(SEM) and transmission electron microscope(TEM), and investigated by tensile test at room temperature, thermal exposure test and corrosion test. The results show that the strength after T6 aging treatment exhibit a decrease trend as an increase of the solution temperature from465 °C to 480 °C. After the solution treated by the rate of 470 °C/1 h, second phases dissolve into the matrix very well and the strength property reaches optimum. The alloy has better comprehensive properties treated by a solution treatment of 470 °C/1 h and then followed by an aging treatment of 120 °C/24 h + 170 °C/1 h + 120 °C/24 h. Under the aging state, the precipitated phases inside the grains are suitable in size, while on the grain boundary distribute discontinuously and the precipitate-free zone is obvious. Besides, the alloy still maintain high tensile properties. The yield strength, tensile strength and elongation are 650 MPa, 686 MPa,12.0%, respectively. The yield strength retention after heat exposure is 92%. The alloy has good corrosion resistance and the exfoliation corrosion degree. The average corrosion rate in the H_2S and CO_2 environment is 0.0024 mm/a, which is far less than the required 0.12 mm/a. It is insensitive to H_2S and CO_2 environments.     

磁流变液中磁性颗粒成链与团聚的临界特征分析

热运动对纳米级磁流变液系统的颗粒团聚行为和宏观流变特性扰动影响不可忽视.为研究施加外磁场后系统微结构与热运动间的关系，探讨在不同颗粒粒径情况下热运动能量在系统总能量中的占比.采用CCD设计方法，分析Monte Carlo仿真获取的颗粒位形信息，生成关于外磁场磁感应强度、颗粒粒径和体积分数的系统热耦合系数<λ>回归模型;成链团聚的临界颗粒粒径计算值比文献经验值高出约23%，证实在考虑系统内多因素的综合影响下，纳米级磁流变液具有更严格的流变现象临界发生条件.     

基于热中子探测评价裂缝的示踪剂特性研究

针对裂缝热中子示踪探测方法,从中子双组扩散理论入手结合蒙特卡洛数值模拟方法,分析压裂前后地层热中子分布影响因素,并模拟不同类型示踪剂及含量的热中子裂缝响应规律,筛选最佳示踪剂并给出其在支撑剂中含量的上、下限。结果表明:压裂前后热中子计数变化量主要受裂缝宽度和标记支撑剂中示踪剂含量的影响;钆对裂缝宽度变化反应最灵敏,钆元素是作为标记支撑剂的最佳示踪元素;随支撑剂中Gd 2O 3含量的增加,热中子计数率降低,热中子计数变化量D增加;示踪剂中氧化钆的上、下限值随裂缝宽度呈指数降低,且当裂缝宽度为1.0 cm时,Gd 2O 3的质量分数上限为0.68%,下限为0.03%。     

高速电主轴热特性仿真与实验研究

对高速电主轴温度场分布随转速的变化规律进行了研究。通过在外壳上布置一定数量的温度传感器,对不同转速下的外壳温度进行实时测量,并将实验结果与ANSYS的模拟结果进行对比,验证了采用在电主轴外壳上布置多个测点测量与仿真相结合的方法来预测电主轴内部温度场分布的可行性;另外还分析了在不同转速下,高速电主轴关键部位的温升,仿真结果表明:主轴在6000~10000 r/min时,温升呈线性增加,在大于10000 r/min后,温升以指数规律增加。     

Predicting Initial Formation Temperature for Deep Well Engineering with a New Method

With the progress of science and technology, human beings explore the energy under-ground with thousands of meters. As a thermophysical parameter, initial formation temperature (IFT) plays an essential...     

NIPA类共聚温敏水凝胶中水的状态和耐热性

用N-异丙基丙烯酰胺（NIPA）与丙烯酸钠（SA）及甲基丙烯酸钠（SMA）共聚合成了两个系列的水凝胶，研究了共聚组成与水凝胶基本性质的关系，并用示差扫描量热法（DSC）和热失重法（TG）研究了此类水凝胶中水的状态和耐热性。     

关于差分式放大器输入电阻的研究

差分式放大器在实际应用方面非常广泛,其理论分析方法的深入研究,对生产实践和教学都有重要的意义。采用电路理论分析、差放理论分析、“虚短”理论分析及实验的方法对差分式放大电路进行了研究。     

高贵心灵的无声抗争——《女勇士》与《红字》两则故事相似性之比较

华裔美国女作家汤婷婷的作品《女勇士》中无名女人的故事与美国19世纪浪漫主义小说家纳塞尼尔·霍桑的代表作《红字》中海斯特·白兰的故事都是有关通奸的故事，虽写于不同的时代，但两个故事有着惊人的相似性。本文从两个故事的发生原因，结果以及两位女主人公对通奸行为的态度三个方面简要分析两种通奸行为，旨在阐明通奸行为是两个女人对自由和爱情的追求以及她们对当时父权社会的反抗。     

Developmental modes of the Neoproterozoic-Lower Paleozoic marine hydrocarbon source rocks in China

Based on the researches on rock type, the mode of occurrence, diagnostic minerals and creatures, the sedimentary geochemistry and organic facies of Chinese marine source rocks from wells and outcrops, and on the research findings of developmental modes of foreign marine source rock, the authors consider that it is impossible to objectively make clear the formation mechanism of hydrocarbon source rock with high organic matter abundance by either single mode of preservation or high organic matter productivity. According to the Chinese geological features, the formation mechanism of the Neoproterozoic-Lower Paleozoic marine source rock is generalized into four modes, namely, thermal water activity-upwelling flow-anoxic; carbonate gentle slope-upwelling flow; xerothermic climate-brine euxinic milieu; and humid climate-retained euxinic milieu; as the Lower Cambrian undercompensation basin organic facies （the Tarim Basin, South China and southwestern margin of North China）, carbonate gentle lime mud bound organic facies （the Upper Ordovician in Tazhong region of the Tarim Basin and the Lower Silurian in the Upper Yangtze Platform）, the Middle Cambrian evaporation laggon organic facies （the Tarim Basin and the Upper Yangtze Platform）, enclosed undercompensation terrigenous bay organic facies （the Middle-Upper Ordovician in the west of the Tarim Basin, the Lower Silurian Long- maxi Formation in the Upper Yangtze platform）. Chinese marine sedimentations with lower organic matter abundance are generalized into two modes of consumption-dilution mode of open epicontinental sea and depletion-dilution mode of supercompensation basin.     

浅析供热计量收费计算原理与方法

介绍了热量计量的基本原理和热费确定的基本原则,阐述了供热总费用的构成与计算原理以及用户热费的构成与计算原理。