某电解铅厂周边农田土壤和玉米中铅污染评价及同位素溯源研究

为探究铅在土壤-玉米-大气中的迁移转化行为,以某电解铅厂周边农田土壤和玉米为研究对象,采集距排烟口50 m、110 m、300 m、500 m、700 m、900 m和3 000 m处的土壤和玉米样品,利用原子吸收光谱仪(AAS)和电感耦合等离子体质谱仪(ICP-MS)分别测定土壤、玉米和大气样品的铅含量和同位素比值。结果表明:电解铅厂周边的玉米均受到铅的污染,玉米根中的铅主要来自土壤,籽粒中的铅很有可能大部分来自大气,少部分来自土壤,茎中的铅很可能来自土壤而不是叶面传输;籽粒中的铅与叶片中的铅具有显著的相关关系(P0.01),相关方程为y=-0.0002x~2+0.0461x-0.4643,R=0.966 7。     

淀山湖水质及与环湖稻田农业面源污染的关系

对淀山湖主要进水和出水口水质进行年度定点监测; 同时, 布置田间试验, 研究不同施肥稻田田面水养分含量动态. 结果表明:淀山湖进出水口水体氨氮和总磷年平均质量浓度分别为 0.47 和 0.13 mg/L, 基本处于 Ⅴ 类水质标准; 进水口水质略劣于出水口, 不同进水口的水质也有很大差异. 进一步研究发现, 淀山湖水质的年度变化与稻田田面水养分的动态变化有密切的相关性, 表明农业面源污染对淀山湖水环境具有显著影响. 在环湖地区, 减少和控制农业面源, 是进一步改善淀山湖水环境质量的关键.     

佛山市基本农田保护区养殖鱼塘水质抽样调查与评价

对佛山市5区的基本农田保护区养殖鱼塘水质抽样调查,并采用环境污染指数对水质状况进行评价。结果表明,养殖鱼塘水温和p H值均能达到鱼类正常生长要求,溶解氧较丰富,但水质普遍过肥。在5区20个调查点中,CODCr、NH4+-N和TP超标率分别为90%、30%、85%。5区养殖鱼塘水质的污染程度由高到低依次为禅城区、南海区、三水区、顺德区、高明区。全市养殖鱼塘的综合质量指数为1.44,水质整体上受到重度污染。TP的污染负荷分担率最高,其次是CODCr和NH4+-N。总体来说,佛山市基本农田保护区养殖鱼塘水体有机物污染十分突出,已出现富营养化。     

Tailoring soft magnetic properties of Fe-based amorphous alloys through C addition

It is known that developing Fe-based amorphous alloys with the saturation flux density(B_s) higher than 1.65 T is a major challenge.In present work,effects of C addition on magnetic properties of Fe-based amorphous alloys were systematically studied.It has been found that the addition of C can significantly increase the saturation flux density(B_s) and the magnetic flux density at 800 A/m(B_(800)) of the Fe-B-C-Si-P amorphous alloys.After the addition of C,the B_s of the amorphous alloys increase from 1.61 T(Fe_(83)B_(13)Si_3 P_1) to 1.65-1.71 T(Fe_(83)B_(13-x)C_xSi_3 P_1,x=1.5,2,3 and 4). The Fe_(83)B_(10)C_3 Si_3 P_1 amorphous alloy possesses excellent soft magnetic properties with high B_s of 1.71 T and low H_c of 1.5 A/m.It shows that density increase of the alloys and weakened metalloid-sp/metal-d bonding caused by C addition contribute to the increment of B_s.It suggests that the newly developed high-performance amorphous alloys possess great potential in application.     

Effect of Al on microstructure and mechanical properties of as-extruded Mg–1Mn alloy sheet

The effect of Al addition on microstructure and mechanical properties of hot extruded Mg–1 Mn alloy sheet was investigated. The results revealed that the dynamic recrystallization was promoted by increasing Al content. The ultimate tensile strength and yield strength of the alloy increased with the increase of Al content. The Mg–9 Al–1 Mn alloy exhibited the highest strength, with tensile strength of 308 MPa, 307 MPa, 319 MPa, yield strength of 199 MPa, 207 MPa, 220 MPa and the elongation of 20.9%, 20.1%, 19.2% in 0°, 45°, 90°, respectively.The high strength was mainly attributed to the formation of fine dynamically recrystallized grains and large amounts of the second phase. The strengthening mechanism of the alloys was explained.     

Microstructure,mechanical properties and wear resistance of an Al–Mg–Si alloy produced by equal channel angular pressing

Microstructure, mechanical properties and wear resistance in an ultrafine-grained Al–Mg–Si alloy fabricated utilizing a combination of equal channel angular pressing (ECAP) and dynamic aging were investigated in this paper. The results indicated that the grain size of the ECAP alloy was significantly refined, i.e., to ~239 nm after three ECAP passes. Meanwhile, the yield and tensile strength of the ECAPed material reached 340 MPa and 445 MPa, respectively, while maintaining a significant uniform elongation of 14%. Wear resistance results demonstrated that the wear rate, wear depth and width of the ECAPed material decreased in comparison with the solution-treated (SST) and peak-aged (T6) conditions under a load range of 5–25 N. The adhesive wear that occurs in the undeformed specimens at 10 N does not appear in the ECAPed specimen at the same load, indicating that the ECAPed specimen delay the appearance of more serious wear mechanisms under certain loads. The cooperative interaction of high density nano-scale β" precipitates and dislocations resulted in a combination of super-high strength and good work hardening ability which suppressed the extension of cracks between the friction layer and the plastic deformation zone. As a consequence, the combination of ECAP and dynamic aging brings a significant improvement for antifriction performance of the 6061 aluminum alloy.     

Effect of heat treatment on microstructures and properties of a novel Al-Zn-Mg-Cu alloy for oil drilling

In view of the special requirements for strength, heat resistance and corrosion resistance of Al-Zn-Mg-Cu alloy for oil drilling, the Al-6.2 Zn-2.5 Mg-1.6 Cu alloy was prepared by increasing Cu content on basis of Russian Series 1953 alloy. The effect of heat treatment on the microstructures and properties of the alloy was characterized by optical microscope(OM), scanning electron microscope(SEM) and transmission electron microscope(TEM), and investigated by tensile test at room temperature, thermal exposure test and corrosion test. The results show that the strength after T6 aging treatment exhibit a decrease trend as an increase of the solution temperature from465 °C to 480 °C. After the solution treated by the rate of 470 °C/1 h, second phases dissolve into the matrix very well and the strength property reaches optimum. The alloy has better comprehensive properties treated by a solution treatment of 470 °C/1 h and then followed by an aging treatment of 120 °C/24 h + 170 °C/1 h + 120 °C/24 h. Under the aging state, the precipitated phases inside the grains are suitable in size, while on the grain boundary distribute discontinuously and the precipitate-free zone is obvious. Besides, the alloy still maintain high tensile properties. The yield strength, tensile strength and elongation are 650 MPa, 686 MPa,12.0%, respectively. The yield strength retention after heat exposure is 92%. The alloy has good corrosion resistance and the exfoliation corrosion degree. The average corrosion rate in the H_2S and CO_2 environment is 0.0024 mm/a, which is far less than the required 0.12 mm/a. It is insensitive to H_2S and CO_2 environments.     

基于突变级数法的福州市某区土壤重金属污染综合评价

以福州市某区土壤为研究对象,采用突变级数法对福州市某区土壤重金属污染进行评价,依据主成分分析对评价因子进行选择,整个评价指标体系避免了人为确定权重的主观性.结果表明:福州市某区土壤重金属污染目前整体呈现一个较为良好的态势,但有部分地区处于"病态"状况.距离该区中心较近的西客站、李园天桥、远洋以及于山、东街口到靠近郊区的燎原、三角埕、鼓山等地的污染的综合隶属值呈递增的趋势,表明距离城市中心越近的土壤重金属污染越为严重.     

上海黄浦江两支流河流甲烷含量研究

甲烷是一种重要的温室气体,虽然目前大气中含量远小于二氧化碳,但排放增长率却大于后者.研究区域为上海市黄浦江支流苏州河和淀浦河,通过实验数据对比城郊春夏的甲烷排放的差异,探讨甲烷产生的机制及其与环境因子的关系,这将有助于研究河流甲烷排放对于环境变化的影响.研究结果认为河流甲烷主要来源于水中沉积物,其产生与水质、温度等因素相关;同时甲烷摩尔浓度与硝酸根离子质量体积比存在负相关性,与铵根离子质量体积比和有机碳质量分数存在正相关性.     

非同分布φ混合序列加权和的强极限收敛性

利用φ混合序列矩不等式和截尾的处理方法,研究非同分布φ混合序列加权和强极限收敛性质的问题,得到了若干新结果,推广并改进了独立同分布情形下的相应结果.