Microstructure,mechanical properties and wear resistance of an Al–Mg–Si alloy produced by equal channel angular pressing

Microstructure, mechanical properties and wear resistance in an ultrafine-grained Al–Mg–Si alloy fabricated utilizing a combination of equal channel angular pressing (ECAP) and dynamic aging were investigated in this paper. The results indicated that the grain size of the ECAP alloy was significantly refined, i.e., to ~239 nm after three ECAP passes. Meanwhile, the yield and tensile strength of the ECAPed material reached 340 MPa and 445 MPa, respectively, while maintaining a significant uniform elongation of 14%. Wear resistance results demonstrated that the wear rate, wear depth and width of the ECAPed material decreased in comparison with the solution-treated (SST) and peak-aged (T6) conditions under a load range of 5–25 N. The adhesive wear that occurs in the undeformed specimens at 10 N does not appear in the ECAPed specimen at the same load, indicating that the ECAPed specimen delay the appearance of more serious wear mechanisms under certain loads. The cooperative interaction of high density nano-scale β" precipitates and dislocations resulted in a combination of super-high strength and good work hardening ability which suppressed the extension of cracks between the friction layer and the plastic deformation zone. As a consequence, the combination of ECAP and dynamic aging brings a significant improvement for antifriction performance of the 6061 aluminum alloy.     

Effect of heat treatment on microstructures and properties of a novel Al-Zn-Mg-Cu alloy for oil drilling

In view of the special requirements for strength, heat resistance and corrosion resistance of Al-Zn-Mg-Cu alloy for oil drilling, the Al-6.2 Zn-2.5 Mg-1.6 Cu alloy was prepared by increasing Cu content on basis of Russian Series 1953 alloy. The effect of heat treatment on the microstructures and properties of the alloy was characterized by optical microscope(OM), scanning electron microscope(SEM) and transmission electron microscope(TEM), and investigated by tensile test at room temperature, thermal exposure test and corrosion test. The results show that the strength after T6 aging treatment exhibit a decrease trend as an increase of the solution temperature from465 °C to 480 °C. After the solution treated by the rate of 470 °C/1 h, second phases dissolve into the matrix very well and the strength property reaches optimum. The alloy has better comprehensive properties treated by a solution treatment of 470 °C/1 h and then followed by an aging treatment of 120 °C/24 h + 170 °C/1 h + 120 °C/24 h. Under the aging state, the precipitated phases inside the grains are suitable in size, while on the grain boundary distribute discontinuously and the precipitate-free zone is obvious. Besides, the alloy still maintain high tensile properties. The yield strength, tensile strength and elongation are 650 MPa, 686 MPa,12.0%, respectively. The yield strength retention after heat exposure is 92%. The alloy has good corrosion resistance and the exfoliation corrosion degree. The average corrosion rate in the H_2S and CO_2 environment is 0.0024 mm/a, which is far less than the required 0.12 mm/a. It is insensitive to H_2S and CO_2 environments.     

半潜式钻井平台螺旋桨修复技术的应用研究进展

针对半潜式海洋钻井平台推进器螺旋桨面临的空泡腐蚀、电化学腐蚀以及海洋生物附着污损等问题，综述了焊接、粘接、热喷涂、冷喷涂修复技术的应用研究进展。认为目前的螺旋桨修复再制造技术普遍存在着修复层应力集中、结合强度低、孔隙率高、高温导致材料变性等缺陷，今后的研究工作应向着避免应力集中、增大修复层结合强度、降低作业温度、减小孔隙率的方向发展，以期能够制备更加致密均匀的修复层。     

海上电泵结蜡井热循环洗井工艺参数优化设计

为探索海上油田电泵举升结蜡井热循环洗井工艺井筒温度场分布规律，综合考虑潜油电机增温、电缆散热、热流体注入量、注入深度、注入温度、结蜡管段传热和海水空气导热的影响，基于热能守恒原理，建立了电泵井结蜡热循环洗井工艺井筒温度场计算模型，分析了热流体注入温度和注入量对混合产出流体的井筒温度分布的影响。研究结果表明，随着注入量的增加混合产出液沿程井筒温度增加，随着注入温度的增加混合产出液沿程井筒温度增加。该方法可有效指导现场措施工艺的实施，达到延长结蜡井的清蜡周期、延缓产液/产油量下降速度的目的。     

智能高速罐身电阻焊机数字化控制系统

提出了以国产MCT80 0 0F8运动控制器为核心的智能高速罐身电阻焊机数字化控制系统 ,并介绍了系统的组成、工作原理、硬件接口、电机控制方法以及伺服电机的运动关系数学模型 .新的系统有利于提高罐身电阻焊机的制罐生产速度 ,并具有功能全面、可靠性高、控制精确、开放性好以及成本较低等优点     

环氧-呋喃防护材料的研制

碳化是引起水工钢筋混凝土钢筋锈蚀的重要因素之一．用糠醛、丙酮作活性稀释剂的环氧一呋喃涂料、玻璃钢与混凝土复合使用，粘接性能好，机械性能优良，防碳化、冻融能力强，与混凝土的弹性模量接近，能有效阻止混凝土碳化、钢筋(钢丝网)锈蚀．经过20余项工程应用及10余年的考验效果良好．     

NIPA类共聚温敏水凝胶中水的状态和耐热性

用N-异丙基丙烯酰胺（NIPA）与丙烯酸钠（SA）及甲基丙烯酸钠（SMA）共聚合成了两个系列的水凝胶，研究了共聚组成与水凝胶基本性质的关系，并用示差扫描量热法（DSC）和热失重法（TG）研究了此类水凝胶中水的状态和耐热性。     

关于差分式放大器输入电阻的研究

差分式放大器在实际应用方面非常广泛,其理论分析方法的深入研究,对生产实践和教学都有重要的意义。采用电路理论分析、差放理论分析、“虚短”理论分析及实验的方法对差分式放大电路进行了研究。     

高贵心灵的无声抗争——《女勇士》与《红字》两则故事相似性之比较

华裔美国女作家汤婷婷的作品《女勇士》中无名女人的故事与美国19世纪浪漫主义小说家纳塞尼尔·霍桑的代表作《红字》中海斯特·白兰的故事都是有关通奸的故事，虽写于不同的时代，但两个故事有着惊人的相似性。本文从两个故事的发生原因，结果以及两位女主人公对通奸行为的态度三个方面简要分析两种通奸行为，旨在阐明通奸行为是两个女人对自由和爱情的追求以及她们对当时父权社会的反抗。     

强化传热生物质燃料热风炉研究

研制出用于粮食及其它农副产品干燥的新型热风炉。此炉型采用生物质燃料洁净燃烧技术及高强化传热技术,具有低污染、高效率、长寿命等优点。