Effect of heat treatment on microstructures and properties of a novel Al-Zn-Mg-Cu alloy for oil drilling

In view of the special requirements for strength, heat resistance and corrosion resistance of Al-Zn-Mg-Cu alloy for oil drilling, the Al-6.2 Zn-2.5 Mg-1.6 Cu alloy was prepared by increasing Cu content on basis of Russian Series 1953 alloy. The effect of heat treatment on the microstructures and properties of the alloy was characterized by optical microscope(OM), scanning electron microscope(SEM) and transmission electron microscope(TEM), and investigated by tensile test at room temperature, thermal exposure test and corrosion test. The results show that the strength after T6 aging treatment exhibit a decrease trend as an increase of the solution temperature from465 °C to 480 °C. After the solution treated by the rate of 470 °C/1 h, second phases dissolve into the matrix very well and the strength property reaches optimum. The alloy has better comprehensive properties treated by a solution treatment of 470 °C/1 h and then followed by an aging treatment of 120 °C/24 h + 170 °C/1 h + 120 °C/24 h. Under the aging state, the precipitated phases inside the grains are suitable in size, while on the grain boundary distribute discontinuously and the precipitate-free zone is obvious. Besides, the alloy still maintain high tensile properties. The yield strength, tensile strength and elongation are 650 MPa, 686 MPa,12.0%, respectively. The yield strength retention after heat exposure is 92%. The alloy has good corrosion resistance and the exfoliation corrosion degree. The average corrosion rate in the H_2S and CO_2 environment is 0.0024 mm/a, which is far less than the required 0.12 mm/a. It is insensitive to H_2S and CO_2 environments.     

变系数对流扩散方程的交替分段显-隐式方法

应用交替分段显－隐方法求解变系数对流扩散方程，此方法具有很好的并行性且无条件稳定。     

对摩擦力作功与摩擦生热的量度的认识

本文通过对摩擦力作功与不擦生热的讨论，给出摩擦生热的量度方法．     

双门电冰箱的热传导问题

本文将根据热传导方程,对电冰箱达定态过程进行理论推导,以及定态后电冰箱单位时间吸收的热量,并由此计算出由于冰箱箱体的热量泄漏而消耗的能量。     

金属工件内部残余应力的振动消除研究

本文针对传统的消除金属工作内部残余应力的热时效处理法的不足，从激振角度，运用材料力学、动力学中的振动理论等知识，并通过大量试验验证，研究了振动消除应力的方法－－振动时效法的原理及其有关问题。说明这种新的方法具有节能、高效等一系列优点。     

对流扩散方程参数识别的扰动方法

采取扰动方法确定对流扩散方程的未知参数,并应用正则化方法求解所得到的线性方程组,具有计算稳定,易于实行等优点。     

n维空间简谐势阱中理想费米气体的化学势与热容量

采用Ｔｈｏｍａｓ－Ｆｅｒｍｉ的半经典近似方法,得到处于ｎ维空间简谐势阱中的理想费米气体的化学势和热容量等物理量的通用表示式,并讨论了空间维数和外势对这些物理量的影响     

方腔内混合对流换热的数值研究与模型实验

为研究方腔内混合对流向受迫对流过渡的临界参数,通过数值模拟和模型实验,得到了不同工况下的流场、温度场,并将数值结果与实验结果进行了对比,通过一系列的数值计算,取得了均匀通风方式时混合对流处于受迫对流占优状态、自然对流受到抑制时的特征参数,指出描述方腔内混合对流的特征参数Ｇｒ／Ｒｅｎ中的ｎ不等于２,并发现当自然对流引起的旋涡消失时,自然对流对换热仍有一定的影响。     

Pattern formation in Rayleigh-Bénard convection: Numerical simulation with a coupled-map-lattice model

The various patterns formed in Rayleigh-Bénard convection under different conditions are numerically simulated with a coupled-map-lattice model. In the case of a lower aspect ratio (L/d=5), the simulations vividly depicted the main features of the transition process from a laminar state to a soft turbulence and then to a hard turbulence. In this case, the cellular structure in a horizontal section is also reproduced. In the case of a larger aspect ratio (L/d=30), the simulations successfully reproduced the spiral-defect chaos and target chaos in the initial stage of the pattern evolution which were recently found in experiments. In this case, for a fluid ofPr=1, it is verified in simulations that both the ideal straight rolls and spiral-defect chaos are stable attractors in the same parameter regime, and that the initial condition is a decisive factor for which one of the two is formed. In the same case, for a fluid ofPr=4, the target patterns are dominant instead of the spirals, the sizes and distributions of the target are also notably dependent on the initial condition.