双轴等拉低周疲劳实验装置

本文给出能在一般单向加载液压疲劳试验机上做双轴等拉低周疲劳实验研究的双向拉伸装置,并对有关影响因素进行了讨论。 本试验是在百吨液压低周疲劳试验机上进行的。双向拉体装置已经受近百万次疲劳载荷,其中交变载荷幅围5.5,t亦经受近20万次。在使用过程,各构件完好合手使用要求,将十字试样进行低周疲劳断裂试验,成功地开出合格裂纹,用它进行超速条件下叶轮材料性能研究亦取得初步结果。可以认为它适用于平而应力集中问题低周疲劳性能的研究。若使用液压高、中周疲劳试验机,它还可用于双轴载荷下裂纹试样裂纹扩展的研究。 本文指出了双向拉伸装置有待改进的方面。     

Internal interactions within the human circadian system: the masking effect

Summary In the realm of human circadian rhythms, the masking effect is defined as the change in the course of deep body temperature induced by changes in the degree of physical activity, or by the alteration between sleep and wake. This effect is particularly obvious during internal desynchronization where the rhythms of deep body temperature, and the sleep-wake sleep-wake sleep cycle — i.e. one of the masking factors — run with different periods.Every sleep onset is accompanied by a rapid drop, and wake onset by a rapid rise in deep body temperature, each one with an overshoot of about 50% of the steady state variations. When rhythms are calculated, with the dominant temperature period as the screening period, exclusively from data obtained during sleep episodes, on the one hand, and from those obtained exclusively during wake, on the other, two average cycles emerge: the sleep temperature curve and the wake temperature curve. Both run in parallel but are separated by the masking effcct. As derived from many experiments, the mean masking effect amounts to 0.28±0.06°C. The masking effect also depends to some extent on the phase of the temperature rhtthm; it is larger than average around the temperature maximum and during the descending phase of the temperature cycle, where the alertness commonly is highest and the probability to sleep, in general, and the REM sleep propensity, in particular, are smaller than average. This also can be interpreted to indicate that the sleep temperature curve is phase advanced relative to the wake temperature curve; this, on the average, by 0.9±0.3 h.If the individually determined amount of masking is added to the temperature data obtained during sleep, or substracted from the temperature data obtained during wake, a temperature curve emerges that can be though of as being purified of the masking effect. Analyses of this artificial curve allow estimation of that part of the internal interactions uninfluenced by the masking effect. On the average, about half of the amount of interaction between the rhythm of sleep-wake and that of deep body temperature is explained by the masking effect, whereas the other half is oscillatory interaction. Both types of interaction are inherent and inseparable parts of the circadian clock mechanism, as can be deduced from model considerations.     

钢坯磨削温度的若干试验研究

通过使用“可磨式”人工热电偶进行的不同条件下的磨削温度测量试验研究了钢坯磨削工件表层温度,结果表明钢坯被磨削表层温度分布与热强呈三角形分布时的理论分析结果相同,表层峰值温度随磨削压力及磨削功率增大而提高,且随工件进给速度提高而略有降低,峰值温度还随磨削角度减小而提高,90°磨削的峰值温度比0°磨削要低250℃左右,砂轮种类也对峰值温度有重要影响,使用锆刚玉砂轮时磨削温度低于棕刚玉砂轮,试验结果表明高效钢坯磨削的磨削区温度远比普通磨削为高,可达1200℃左右,还从不同方面探讨了磨削高温对钢坯磨削的影响,认为尽管磨削高温有若干不利影响,但对高效钢坯磨削却是重要条件,上述讨论,从一个方面揭示了钢坯磨削机理,并验证了关于钢坯磨削温度的理论分析结果。     

Photoperiodic summation is temperature-dependent inPyrrhocoris apterus (L.) (Heteroptera)

Summary InPyrrhocoris apterus, a low temperature, 15°C, prevented the termination of diapause by long days and, unexpectedly, also the induction of diapause by short days. Both responses were enabled at a higher temperature, 26°C. In contrast to current concepts, it was proved that the summation of photoperiodic signals was temperature-dependent, since the morphogenetic development was prevented by starvation.     

涂层对热电偶热电性能及大气中寿命的影响

在难熔金属热电偶表而施加涂层的目的,旨在使原仅限和真空、中性及还原气氛中测量的热电偶能在大气中使用.本文讨论涂层对难熔金属热电偶在氧化气氛的"热电势—温度","热电势—时间"的关系及其寿命的影响.具有涂层的W/M.热电偶在氧化气氛(常压下1500℃取得263小时±1%t的最高记录,而W-Re热电偶存1500℃试验的前70小时偏差也在1%t内.而没有涂层的热电偶仅支持数分钟便破坏.     

云南两高辐合背景下低涡强降水过程对比分析

基于气象观测和欧洲中期天气预报中心第五代大气再分析资料（ERA5）,选取2018—2020年发生在云南的3次两高压辐合区（以下简称两高辐合）背景下低涡连续性强降水过程进行对比分析,探究其环流形势、动热力因子及水汽辐合的相似性和差异性.结果显示：(1)夏半年西太平洋副热带高压（以下简称西太副高）西伸时,云南常受两高辐合影响,当辐合区中有低涡生成,易发生连续性强降水,且强降水落区并不完全分布在整个狭长的两高辐合区内.(2)两高辐合区低涡降水具有相似的雨带分布和移动特征,但雨带的集中程度、分布范围、小时雨强和总雨量存在差异.强降水开始时,落区偏东,随着西太副高西伸及东北引导气流的引导,低涡向南向西移动,强降水落区也随之向南向西移动.低涡在某一地区徘徊导致降水集中在该区域,且西太副高西伸较强时,两高辐合形势更强,低涡降水大雨及以上量级雨带也更窄.(3)低涡造成的降水主要分布在低涡中心及低涡切变附近,且降水发生在低层暖湿的环境中,低层及中高层有冷空气侵入时,小时雨强的极端性更强,降水落区也相对偏北.两高辐合区低涡降水落区与水汽辐合区对应较好,水汽辐合强度较弱时,对应的总降水量较小.     

泵闸混凝土施工期智能温控关键信息识别

为实现施工期大体积混凝土温控要素的智能快速识别,提高智能温控系统的反馈及预测模型精度,提出了一套智能算法对物联网技术采集到的各类温控要素原始测值进行识别及转化。针对浇筑温度、浇筑时间、最高温度、内外温差、冷却通水起止时间与表面保温覆盖等施工期关键温控参数,结合工程经验分别给出相应识别任务的判定逻辑并编写对应程序,然后应用多个实际工程数据进行验证,并分析各识别功能的准确率。验证结果表明,本文算法识别效果良好,能够实现温控要素采集的自动化、智能化、快速化、精准化,具有较强的工程实用价值。     

基于残差卷积自注意力神经网络的铝电解过热度识别方法

过热度是反映铝电解槽当前生产效率的重要指标,由于过热度难以在线实时测量,本文提出一种基于残差卷积自注意力神经网络的过热度识别方法.针对铝电解生产过程数据为时间序列数据且具有多源异构特性,设计异构数据的同构表示方法.在此基础上建立残差卷积自注意力神经网络模型以提取同构时间序列数据的全局与局部特征.针对过热度数据标签少且类别分布不均匀问题,采用基于自动编码器的无监督预训练方法与加权交叉熵损失函数以提高过热度识别任务的性能.在基准数据集上进行仿真对比实验以验证本文所提方法的有效性,然后在只包含少量不平衡标签的铝电解过热度数据集上进行实验验证,结果表明本文构建的过热度识别模型相较与其他现有模型不仅提高了过热度识别准确率,而且在训练样本较少时保证了模型的泛化能力.     

低真空对电渣重熔工艺和铸锭质量的影响

脱氧和夹杂物控制是电渣重熔钢锭质量提升的关键.分别在氩气保护的常压和低真空(10 kPa)条件下重熔H13电极,结合热力学计算,分析了低真空对电渣重熔工艺过程和铸锭质量的影响.结果表明,相比常压,低真空条件下渣池含气率升高,熔速波动更剧烈,所得电渣锭表面质量较差.常压和低真空条件制得电渣锭中总w_O分别为24×10^-6和18×10^-6,碳脱氧反应随压力降低而加强,并逐渐取代铝脱氧.相比Al-O平衡,10 kPa条件下与电极中w_C平衡的溶解w_O更低,因而能够进一步降低钢锭中w_O.碳脱氧产物是CO气体,不会引入新的夹杂物.常压和低真空条件制得电渣锭中夹杂物的类型没有明显区别,最大夹杂物尺寸从14.9μm分别减小到10.5μm和8.3μm,等效直径小于3μm的夹杂物检出比分别为63.85%和75.91%.低真空条件能够进一步细化夹杂物,提高钢锭洁净度.     

震区中小跨径桥梁墩柱配筋率取值范围

为研究配筋率对钢筋混凝土桥梁延性抗震性能的影响,并在不同设防烈度对主筋配筋率的合理取值进行细分。以钢筋混凝土桥梁为研究对象,通过拟静力模型试验与有限元数值分析的方法,研究竖向钢筋(主筋)配筋率对桥墩延性的影响,提出典型桥墩的多级性能水平量化指标;并探究在氯离子侵蚀的恶劣环境下,不同配筋率对桥梁抗震性能所带来的影响,从而对氯离子侵蚀环境下的震区中小跨径桥梁墩柱配筋率取值范围提供参考建议。结果表明：考虑氯离子侵蚀作用下的恢复力模型能够较好地反映刚度的退化特性,墩柱的最佳配筋率取值范围为1.11%～2.72%;当加速度为0.3g(g为重力加速度)时,仅从配筋率的角度已无法满足墩柱的损伤指标,建议采用减隔震体系进行抗震设计,如采用延性体系时配筋率不得小于2.64%。研究结果可为中小跨径连续桥梁抗震设计提供参考。