热处理条件对IrO2-pH电极性能的影响

在700℃炉冷、870℃空冷和炉冷三种热处理条件下,制备了氧化铱pH微电极,并对比了微电极的线性范围及响应时间.结果表明:热处理条件对Ir氧化物膜的均匀性有很大影响,进而影响其开路电位的稳定性及响应速度.700℃炉冷和870℃空冷制得的电极氧化膜表面粗糙,孔隙率不均匀并伴随有裂纹;而870℃炉冷条件下制得的电极具有表面氧化膜均匀、响应时间短以及线性好等优点.铱氧化物的形成机理是Ir丝被空气中的O2氧化,而高温Li2CO3起到一种溶剂的作用.铱氧化物电极的H+响应是由于电极表面水合氧化铱与溶液中H+发生化学反应,反应为Ir4+与Ir3+之间的转变.     

温度不均匀性对吸收池中气体吸收的影响

为研究温度不均匀性对低温控制吸收池中气体吸收的影响,建立了桌面不锈钢体低温控制吸收池体积分数标定装置,并使用自行编制的大气辐射传输软件ARH iRS进行模拟计算.实验结果和数值模拟计算结果表明,长1m,充满1.01×105Pa二氧化碳(CO2)气体的吸收池,由于吸收池内外温差导致内部温度不均匀分布(吸收池中轴向温度呈中心对称分布,且吸收池中间的气体温度较低,两端靠近窗片处的温度比中心温度高276~278 K),温度不均匀分布对吸收池气体吸收透射比的影响不大于0.05%,对反演体积分数的影响不超过0.80%,能够满足体积分数定标的需要.     

B2O3对高铝钢连铸保护渣理化性能的影响

高铝钢连铸过程中,为了避免或减轻钢液中Al与保护渣中SiO2发生反应,设计了低SiO2、高Al2O3含量的高铝钢连铸保护渣,通过添加适量的酸性氧化物B2O3协调熔渣酸碱性,利用实验分析了B2O3含量对高铝钢保护渣熔融特性、黏度特性及渣膜传热特性的影响。结果表明,B2O3含量在4%～10%时,随着B2O3含量增加,保护渣熔化温度、黏度、黏流活化能均降低,渣膜热流密度增加;保护渣的等温转变曲线(TTT曲线)向孕育时间增加的方向移动,晶体生长速率降低;实验条件下,增加B2O3含量可抑制保护渣中CaF2的析出。     

浸没式膜生物反应器处理微污染水的工艺强化

对比了单独膜与膜生物反应器(MBR)对微污染原水的处理效果,并研究了投加氯化铵、葡萄糖和粉末活性炭等强化措施对MBR处理效果的影响。结果表明,单独膜工艺对CODMn和氨氮去除率只有16%和5%;而以粉末活性炭为生物载体的MBR工艺对CODMn和氨氮去除率提高到35.3%和44.5%;提高原水有机物浓度和氨氮浓度对CODMn和氨氮去除效率提高作用有限;更换10%的PAC后,提高了MBR对CODMn的去除效果,其去除效率可由原来的35.3%提高到50% 。     

基于真彩切片的MRI图片颜色迁移及三维重构分析

借助于可视人工程的真彩图片作为常用MRI、CT等灰度图片彩色化的颜色迁移的彩色特性源本,以MRI切片和真彩图片的亮度、纹理和几何作为映射间的配准参数而进行合理的颜色转换,以弥补医学灰度图片伪彩色方案中各组织非对应的彩色映射关系.通过真彩图片与灰色图片的亮度分布曲线的调整和纹理特征关系的调整和配准而到有效和符合真实人体器...     

Entransy dissipation minimization for optimization of heat exchanger design

In this paper,by taking the water-water balanced counterflow heat exchanger as an example,the entransy dissipation theory is applied to optimizing the design of heat exchangers.Under certain conditions,the optimal duct aspect ratio is determined analytically.When the heat transfer area or the duct volume is fixed,analytical expressions of the optimal mass velocity and the minimal entransy dissipation rate are obtained.These results show that to reduce the irreversible dissipation in heat exchangers,the heat exchange area should be enlarged as much as possible,while the mass velocity should be reduced as low as possible.     

A comparison of optimization theories for energy conservation in heat exchanger groups

In general,thermal processes can be classified into two categories: heat-work conversion processes and heat transfer processes. Correspondingly,the optimization of thermal processes has to have two different criteria:the well known entropy generation minimization method and the recently proposed entransy dissipation maximization method. This study analyzes the thermal issues in a heat exchanger group,and optimizes the unit arrangements under different constraints based on a suitable optimization crite-rion. The result indicates that the principle of minimum entropy generation rate is valid for optimizing heat exchangers in a ther-modynamic cycle with given boundary temperatures. In contrast,the entransy dissipation maximization is more suitable in heat exchanger optimizations involving only heat transfer processes. Furthermore,the entropy generation rate induced by dumping used streams into ambient surroundings has to be taken into account,except for that originating from the hot and cold-ends of heat exchangers,when using the entropy generation minimization to optimize heat exchangers undergoing a thermodynamic cycle.     

Reverberation nulling and echo enhancement at low frequency using waveguide invariance

Based on the fact that the transfer function vector between a source receiver array and the dominant scatterer of boundary reverberation at a range can be obtained from the corresponding reverberations scattered from this range cell, a reverberation nulling concept using time reversal processing has been proposed. However, current reverberation nulling methods have certain limitations when applied into practice, which would null boundary reverberation and target echo simultaneously. As a solution, a passive reverberation nulling and echo enhancement method at low frequency using waveguide invariance is proposed in this paper. In this method, the reverberation subspace for the target range cell is not obtained directly from the return signals scattered by the target range cell but from the return signals scattered by a range cell located before the target using waveguide invariance, so as to suppress the reverberation embodied in the target echo by passive reverberation nulling. Besides, a range-dependent optimal weighting vector rather than conventional projector matrix is deduced to null the reverberation component meanwhile maximizing the target echo, thereby enhancing the echo-to-reverberation ratio furthest. Numerical simulations in typical range-independent shallow water environment demonstrate the efficacy and the improved performance of the proposed method for echo-to-reverberation enhancement.     

激光辐照移动平板温度场分布的有限元分析

基于热传导理论,采用有限元方法建立激光辐照无限长移动平板表面激发瞬态温度场的三维模型,用以研究移动平板上下表面瞬态温度场.考虑板材料的热物理参数依赖于温度、板表面的热辐射及对流等因素,计算了上述因素及移动速度对温度场的影响,并进一步讨论了激光半径对温度场的影响.数值结果表明:激光辐照移动平板后,在材料中将产生准稳态温度...     

不同恶化程度胃癌细胞系的细胞间隙连接通讯功能及Cx43表达的差异

以人正常胃黏膜上皮细胞系GES-1和不同恶化程度的人胃癌细胞系(低恶化AGS细胞系、中恶化SGC-7901细胞系、高恶化BGC-823细胞系)为研究对象,采用激光共聚焦显微镜的荧光漂白恢复技术及划痕标记荧光染料示踪技术研究不同恶化程度的胃癌细胞系细胞间隙连接通讯(Gap junctional intercellular communication,GJIC)功能的差异;采用荧光定量PCR技术和间接免疫荧光技术检测间隙连接蛋白(Connexin43,Cx43)基因在mRNA和蛋白水平的表达差异,探求其与胃癌恶性程度的相关性.结果表明,在正常胃细胞系和低、中及高恶化胃腺癌细胞系中,细胞间的GJIC功能随着恶性程度的升高而减弱(AGS、SGC-7901)或消失(BGC-823),且Cx43蛋白及mRNA的表达量随着恶性程度的升高而下调(AGS、SGC-7901)或缺失(BGC-823).这提示胃癌恶性程度与胃癌细胞的GJIC功能显著相关(P<0.05),GJIC在胃癌发生中起重要作用.