奥氏体—铁素体区循环形变对Q235钢力学性能的影响

研究开发出了一种钢材料组织细化的新方法,即奥氏体——铁素体区循环形变,并采用自行设计的热模拟试样,研究了奥氏体——铁素体区循环形变对Q235钢力学性能的影响规律。结果表明：在大部分变形条件下,采用该方法所得到的Q235钢的抗拉强度大于500MPa,屈服强度大于400MPa,伸长率大于20%。     

Combustion synthesis and magnetic investigation of nanosized CoFe2O4

Nanosized Co spinel ferrite was prepared by a combustion method. The grain size of resultant ferrite can be controlled by the reaction conditions. Magnetic investigation revealed that the products with an average grain size of 4 nm behave as superparamagnetic materials and have zero coercive force; whereas the samples with an average grain size of 85 nm (near the size of critical single domain) have the maximal coercive force. There were the negative magnetic intergrain interactions which became stronger when the grain size neared that of the single domain.     

Formation and characterization of phthalocyanine dimer/C60 solar cells

Ni-Cu-Zn ferrite/CaTiO_3 and Ni-Cu-Zn ferrite/BaTiO_3 composites which can be applied in low temperature co-fired ceramic(LTCC) technology were synthesized by conventional solid-state reaction at temperature lower than 950℃.Influence of the microstructures and the gap parameterδ/D on the complex permeability of the above two composites was investigated.The modifiedδ/D values of the above two composites show a good fit to the magnetic circuit model.The dielectric properties of the composites were predicte...     

临界区淬火铁素体对钢性能的影响

研究了铁素体形态和亚结构对临界区淬火强韧化的影响。表明：临界区淬火温度不同时，铁素体形态有所差异，当铁素体呈针状，与马氏体相间分布且含量为２０～２５％时强韧化效果最佳。临界区淬火时，铁素体可产生位错强化、固容强化等强化效果，提高铜的强韧性。     

磁记录材料锶、钡铁氧体的穆斯堡尔研究

本文用穆斯堡尔效应详细地研究了化学共沉淀法制备的M型锶、钡铁氧体和烧结温度分别为750℃,950℃,1000℃,1100℃,保温2小时急冷的Co_(0.8)Zn_(1.4)W型钡铁氧体,对样品之物相进行了鉴定。计算了晶位分布及掺杂离子的从尤晶位;讨论了烧结温度对材料结构和磁性能的影响以及掺杂对磁性能的影响;探讨了材料宏观磁性与微观磁性之关系。通过计算和与实验对比找到了从穆斯堡尔参数直接计算材料饱和磁化强度的关系式。本文之目的是要弄清烧结温度和掺杂对材料结构和磁性的影响,从而对实际工作提供改进意见。1.实验     

A New Design Method for the Octave-Band Stripline Circulators

In this paper, a new design method for high performance octave-band stripline circulator is giv     

表面钴改性γ－Fe_2O_3磁粉的结构表征

利用广延Ｘ射线精细结构和Ｘ射线吸收近边结构技术，结合高分辨电镜和磁性能测量，研究了各种还原温度处理后的包钴型γ－Ｆｅ＿２Ｏ＿３磁粉的微结构与磁性能的关系。结果表明，还原温度对包钴型γ－Ｆｅ＿２Ｏ＿３磁粉的表面层结构的形成、转变影响很大，３５０℃左右的热处理能够形成较理想的表面层结构，增大磁各向异性，从而大幅度提高其矫顽力。     

平炉尘合成超细Fe3O4碱性条件研究

包头钢铁厂的平炉尘含铁量高，较径微细，以γ—Fe2O3为主．经过提纯分级可作为生产超细磁性材料的原料．在有Fe^2 存在及避免氧化的条件下，将平炉尘转化为超细晶石型铁酸盐Fe3O4，对不同碱性条件下的反应进行了比较研究．     

永磁铁氧体材料中的添加剂及其作用

微量添加剂引入永磁铁氧体材料中能较大幅度地提高材料的磁性能，这是开发研究高性能永磁铁氧体材料的一个非常重要的途径。本文较系统地总结了铁氧体永磁材料中所使用的各种添加剂及其作用，并提出了提高永磁铁氧体材料的性能的努力方向。     

Effect of La and Co-doping on microstructure and electrical properties of Bi FeO_3 thin films

Adding both La3＋and Co3＋was used to tune the microstructure and electrical properties of Bi Fe O3（BFO） thin films, and Bi1-xLaxFe0.90Co0.10O3 thin films were grown on the Sr Ru O3-buffered Pt-coated silicon substrates by a radio frequency sputtering. A polycrystalline structure with（110） orientation was shown in thin films, and their resistivity dramatically increases as the La3＋content increases. Their dielectric constant increases,and dielectric loss decreases with increasing La3＋content.In addition, their ferroelectric and fatigue properties were enhanced with rising La3＋content. The thin films with x = 0.03 have optimum electrical properties（e.g., remanent polarization 2Pr＊ 175.6 l C/cm2, coercive field2Ec＊ 699.5 k V/mm, dielectric constant er＊ 257 and tan d ＊ 0.038）, together with a good fatigue behavior. The impendence analysis of the films was conducted to identify the defects type during conductivity, and both hopping electrons and single-charged oxygen vacancies are mainly responsible for the conduction of grain and grain boundaries regardless of La3＋content. As a result, the doping with both La3＋and Co3＋benefits the improvement in the electrical properties of BFO thin films.