微量镍元素添加对铁基非晶/纳米晶磁芯软磁性能的影响

用单辊法制备的宽20 mm,厚25μm的Fe_(73.5)Cu_1Nb_3Si_(13.5)B_9和Fe_(73.5)Ni_(0.3)Cu_1Nb_3Si_(14.2)B_8合金带材,绕制成外径为40 mm,内径为25 mm的环型磁芯,然后将磁芯在不同的温度下进行退火处理,研究了微量Ni元素添加对合金带材的晶化行为以及对横向磁场退火后的非晶/纳米晶磁芯的软磁性能的影响。结果表明:与Fe_(73.5)Cu_1Nb_3Si_(13.5)B_9合金带材相比,添加微量Ni元素的Fe_(73.5)Ni_(0.3)Cu_1Nb_3Si_(14.2)B_8合金带材的一级起始晶化温度Tx1和一级晶化峰温度Tp1降低,其二级起始晶化温度Tx2和二级晶化峰温度Tp2升高,两级起始晶化温度之间的差值ΔTx增大;与横向磁场退火后的Fe_(73.5)Cu_1Nb_3Si_(13.5)B_9非晶/纳米晶磁芯相比,横向磁场退火后的Fe_(73.5)Ni_(0.3)Cu_1Nb_3Si_(14.2)B_8非晶/纳米晶磁芯的起始磁导率μi和饱和磁感应强度Bs减小,矫顽力Hc增大;当测试频率f和最大磁感应强度Bm不变时,有效幅值磁导率μa增大,比总损耗Ps和矫顽力Hc减小;当测试频率f不变时,电感Ls和品质因数Q增大;当励磁电流I不变时,感应电动势E大。     

不同林地清理和培肥措施对桉树人工林植物多样性的影响

【目的】探讨不同林地清理方式下不同培肥措施对植物多样性的作用规律,为桉树人工林的可持续经营提供理论依据。【方法】基于两种不同林地清理(火烧清理和人工清理)和3种不同培肥措施(加炭C、加氮N和套种绿肥)处理试验,比较研究不同林地清理和培肥措施的独立和交互作用对桉树人工林下植物多样性的影响。【结果】火烧清理和人工清理4年后,火烧清理林地的物种丰富度显著低于人工清理林地(P0.001);两种清理方式下加C、加N和套种绿肥均明显改变植物群落的组成和结构,但优势种保持不变,均为蔓生莠竹、弓果黍、小花露籽草和五节芒(套种绿肥中的小花露籽草除外),显著降低植物多样性指数(包括Shannon-Wiener指数、Simpson指数和Pielou均匀度指数);两种清理方式各处理林下植物功能群谱完全相同,均表现为禾草植物木本植物蕨类植物藤本植物杂草植物入侵植物;两因素方差分析表明,火烧清理和人工清理条件下,加C、加N、套种绿肥处理均极显著影响林下植物多样性指数,林地清理方式与不同处理的交互作用也对林下植物多样性指数产生极显著的影响。【结论】火烧和人工清理林地及加C、加N、套种绿肥等培肥措施对林下植物多样性存在显著影响。从维护生物多样性的视角出发,在桉树人工林的经营中应尽量减少加C、加N和套种绿肥等培肥措施的应用。     

不同林地清理方式下生物炭和氮添加对桉树红锥混交林土壤养分的影响

【目的】阐明不同林地清理方式下(火烧清理和人工清理)生物炭和氮添加对桉树红锥混交林土壤养分的影响,为人工林的经营管理提供参考。【方法】在火烧清理和人工清理林地的桉树红锥混交林中,设置生物炭和氮添加的控制实验,研究生物炭和氮添加对土壤有机碳(SOC)、全氮(TN)、全磷(TP)、全钾(TK)、有效磷(AP)和有效钾(AK)含量的影响。【结果】不同林地清理方式下,生物炭和氮添加对林地土壤养分的影响存在差异:与对照相比,人工清理林地时,添加生物炭显著增加了20～40cm土层的AP含量;氮添加极显著增加了0～10cm土层的SOC、TP、AP含量和C∶N;10～20cm土层的SOC、AK含量,20～40cm土层的AP和AK含量也显著增加;而0～10cm土层的N∶P则极显著降低。林地清理方式为火烧清理时,生物炭添加极显著增加0～10cm土层的TP含量,而0～10cm、10～20cm土层的SOC和AK含量,0～10cm土层的C∶N,10～20cm的AP∶TP、C∶P以及0～10cm、10～20cm、20～40cm土层的AK∶TK显著降低,0～10cm土层的AP含量、AP∶TP、C∶P和N∶P更是极显著降低。氮添加显著降低10～20cm土层的N∶P以及0～10cm土层的AP∶TP,0～10cm土层的AP含量以及10～20cm的TN含量下降达到极显著水平。【结论】人工清理林地条件下,实施生物炭和氮添加有利于提高桉树红锥混交林的土壤养分。     

Effect of Ce addition on hot tearing behavior of AZ91 alloy

A small amount of cerium (below 1.0 wt%) addition to AZ91 alloy have been investigated on the hot tearing susceptibility (HTS) at a cooling rate of 1.5Ks^?1. The HTS increased to a maximum value with a cerium addition of 0.6 wt% and then decreased to a stable status as cerium was gradually added. Due to high chemical activity, cerium into the melts can react with aluminum to form an Al₁₁Ce₃ intermetallic compound. X–ray diffraction results also confirmed the existence of Al₁₁Ce₃. The Al₁₁Ce₃ increased with the presence of the needle-like and block morphology. As cerium levels increased, the amount of Mg₁₇Al₁₂ decreased. The variations between Mg₁₇Al₁₂ and Al₁₁Ce₃ resulted in a similar normal distribution of the HTS in AZ91 alloy. The findings were further verified through the microstructure evolution and the surface morphology of fracture.     

Butterflies (Lepidoptera: Papilionoidea) of Mount Kilimanjaro: Nymphalidae subfamilies Libytheinae,Danainae, Satyrinae and Charaxinae

This paper, which presents an annotated checklist of the ‘lower Nymphalidae’ (Libytheinae, Danainae, Satyrinae, Charaxinae), is the fourth in a series on the butterfly fauna of Mount Kilimanjaro. Four genera of lower Nymphalidae (Danaus, Amauris, Bicyclus, Charaxes), with a total of 11 included species, are known or believed to occur within the main forest zone, from c. 1800 to 2800 m. Of these, only three species of Charaxes (Charaxes berkeleyi, Charaxes ansorgei, Charaxes xiphares) may be restricted locally to this primary forest. The lower slopes fauna, below 1800 m, is considerably richer, with a total of 11 genera and 41 species listed (8 species of which extend into the forest zone). Possible additional species, dubious earlier records, problems with African subspecies of Danaus chrysippus, a need for more work on certain Satyrinae, and classification of the genus Charaxes are discussed. An identification key to the subfamilies of Nymphalidae, and the 19 genera of Libytheinae, Danainae, Satyrinae, Charaxinae that occur in Tanzania, together with a key to the adults of all the species of these four subfamilies considered to occur or have occurred on Kilimanjaro, with 206 colour images, are included as online Supplementary Information.     

完整理解“必需够用为度”在教学内容构建中用好“加减法”

完整理解“必需够用为度”，有利于处理好高等职业教育理论教学与实践教学的关系和占比问题。文章分析了“必需够用”的基本涵义，提出“必需够用为度”的边界概念，给出了边界的下限和上限。在此基础上，强调在教学内容构建中既要用好“减法”，也要用好“加法”。最后，结合课程对具体教学内容构建进行探讨。     

外加入第二相颗粒对钢铁材料组织性能的影响

综述了外加颗粒对钢铁材料组织性能的影响,对钢铁中第二相颗粒的内部析出法和外部加入法的差异进行了简单概述。分析了第二相颗粒对钢铁材料的积极作用及不利影响,概述了钢铁材料中外加颗粒的选取原则、尺寸控制、加入量和加入方法等,提出了今后的研究方向。     

多次标准加入法测定样品中的微量氟

利用多次标准加入法,在pH5.0～6.0的缓冲体系中进行了样品中微量氟的测定.研究了测试体系中总离子强度调节缓冲溶液(TISAB)的组成和用量,以及空白电位的快速恢复方法.结果表明:用柠檬酸、醋酸、氯化钠组成TISAB,加入量为溶液总量的10%～20%,测定效果最佳.利用此法测量了水、食盐、牙膏、面粉、啤酒等样品中的氟含量,方法回收率为97.0%～103.0%,5次平行样品测定结果的相对标准偏差均不大于2%.本法操作简单、快速、准确,可用于微量氟的测定.     

Influence of B,Al and Nb addition on the glass forming ability and stability of mechanically alloyed Zr-Ni amorphous alloys

We investigated the influence of minor additions of B,Al and Nb that have representative atomic sizes on the glass forming ability (GFA) and stability of Zr-Ni amorphous alloys during mechanical alloying. The results show that the minor addition of B,Al or Nb does not shorten the initial time of the full amorphization reaction or improve the glass forming ability of the Zr-Ni alloys at a low rotation speed. However,B addition can effectively improve the mechanical stability of the amorphous phase against me...     

杯［8］酮衍生物与镨及铕配合物的合成与表征

以氯丙酮作为亲电试剂与对叔丁基杯[8]芳烃发生亲电取代反应制得杯[8]酮衍生物,并进一步合成了杯[8]酮衍生物与稀土镨、铕的固体配合物.通过元素分析、红外光谱、13C核磁共振、X-射线衍射、热谱分析对产物进行了表征.结果表明,两种固体配合物均为单核型分子,每种固体配合物都以2个杯[8]酮衍生物配体中的氧原子和中心离子配位,其中每个酮衍生物配体各以3个氧原子参与配位.另外,在两种固体配合物中,3个N,N-二甲基甲酰胺分子均以1个氮原子和中心离子配位.此时配位数为9,固体配合物呈对称的三冠三角棱柱结构.