工作气压对磁控溅射法制备硼碳氮薄膜结晶度的影响

本文用六方氮化硼和石墨靶材采用射频（频率为13．56MHz）磁控溅射法沉积硼碳氮薄膜,得到的硼碳氮薄膜可用红外,拉曼表征。工作气压从0．2Pa升高到6．0Pa。我们可以观察到工作气压可以明显的改变硼碳氮薄膜的晶体结构和结晶度。硼碳氯薄膜的半高宽随工作气压的增加而变化并且在工作气压1．0Pa时得到较好结晶度的薄膜。     

放电电流对热阴极等离子体化学气相沉积金刚石膜影响

建立了快速沉积高品质金刚石膜的热阴极辉光放电等离子体化学气相沉积新方法. 相对于常规冷阴极辉光放电而言,热阴极辉光放电是一种新型放电形式,具有许多新的特性,其中重要一点是具有较高的放电电流(6.0～10.0 A). 较高的放电电流既是热阴极辉光放电本身的突出特点,同时对于化学气相沉积金刚石膜工艺也产生重要影响. 实验研究了放电电流于金刚石膜沉积速率、表面形貌和热导率的影响,发现由于放电电流影响辉光放电的等离子体区和阳极区,进而对金刚石膜的沉积速率和品质有很大影响. 特别是通过放电电流的提高,可以有效地提高金刚石膜的品质,这对于制备优质金刚石膜产品有重大意义.     

镍诱导纳米晶硅薄膜的生长

采用磁控溅射方法制备了含镍过渡层的富纳米晶硅二氧化硅薄膜．对薄膜退火后的微观结构和发光性能进行了试验分析．结果表明,在高温退火后,有Ni过渡层的富纳米晶硅薄膜较没有Ni过渡层的薄膜具有更高的纳米晶硅密度和更强的室温光致发光强度．对试验结果进行热力学分析后,认为NiSi2作为纳米晶硅的形核中心诱导了薄膜的分相和纳米晶硅生长．     

棒状薄层色谱法在焦化蜡油族组成分析中的应用

建立了快速测定焦化蜡油族组成的薄层色谱／氢火焰（TLC／FID）检测法，使用2种展开剂可以将试样很好地分成饱和烃、芳烃、胶质和沥青质．以经典柱色谱法测得的数据为基准，考察了方法的准确度，2种方法的绝对偏差不大于3％．同时对方法的精密度进行了考察，相对标准偏差小于5％，方法简单快速，每分析10个样品仅需3h，为蜡油族组成分析提供了一个方便快速的方法．     

近距离高瓦斯低渗透率煤层组“UL”型通风方式研究

文章通过对近距离具有煤层自燃倾向低渗透率薄煤层组高瓦斯矿井采煤工作面瓦斯涌出规律进行分析,同时针对这样的煤层赋存条件的矿井,以实现高产高效为目标,进行了新型UL型通风方式的技术研究。研究表明,新型UL型通风方式与传统的高瓦斯矿井通风方式相比有明显的优点,它有效地解决了工作面上隅角瓦斯超限、煤层自燃等难题,具有良好的技术和经济效益。     

薄抹灰EPS保温板外墙保温施工工艺

文章主要从EPS保温系统的特点、原材料的质量要求、施工步骤及施工注意事项几个方面进行阐述,以供同行参考。     

水力喷射压裂技术在薄层底水油藏中的应用

常规压裂技术是一种传统的油井增产工艺技术;水力喷射压裂技术是一种集射孔、压裂、隔离为一体的新型增产工艺技术,具有穿透性强、伤害低、孔径大、定向准的特点,是油田油井储层改造的新技术。分析水力喷射压裂技术的基本原理、适用条件、技术特点及施工工艺等,通过对梁7-01和梁45-01等五口井的水力喷射压裂现场试验,结果表明可以在薄层底水油藏中应用且增产效果明显。     

Tunable water-based lubrication behavior of alkyl- and fluoroalkyl-silanes

In this paper,we report the tribological properties of self-assembled molecular(SAM) films of fluoroalkylsilanes and non-fluoroalkylsilanes,with different chain-lengths,adsorbed on Si substrate surfaces by covalent bonds.The SAM films were characterized using a universal ball-disk experimental tester in aqueous solutions.The substrate surface was examined by X-ray photoelectron spectroscopy(XPS),and the SAM films adsorbed on the Si surfaces were inspected by contact angle measurements and XPS.Lubrication studies revealed that several kinds of fluoroalkylsilanes had similar friction coefficients;the small differences were attributed to the chain flexibility.In contrast,differences in the aqueous lubrication properties of SAM films of non-fluoroalkylsilanes were clearly identified.It is suggested that substitution with fluorine atoms and the surface affinities of fluoroalkylsilanes contributed to redistribution of surface changes,causing variations in lubrication behaviors.     

Magnetoresistance of the thin film ferromagnetic nanoconstrictions

The magnetoresistance and I-V characteristics at different temperatures of the thin film ferromagnetic nanoconstrictions of variable width (from 20 to 250 nm) and 10 nm thicknesses, fabricated by electron beam lithography and vacuum thin film deposition are compared. The magnetoresistance and resistance of the thin film ferromagnetic nanoconstrictions are not related to the width of the nanoconstrictions. Instead the resistance of the local nano-region in the middle of the thin film ferromagnetic nanoconstriction has only a minor role compared to that of the two microscale thin film ferromagnetic electrodes, which contribute the majority of the measured resistance. The magnetoresistances of the thin film ferromagnetic nanoconstrictions and a 0.2 cm × 0.8 cm thin ferromagnetic film deposited under the same conditions were also compared; the thin film ferromagnetic nanoconstrictions have higher magnetoresistances than the thin ferromagnetic film, which implies that the measured magnetoresistance of the thin film ferromagnetic nanoconstrictions comes mainly from the local nano-region in their centers. In conclusion, the measured magnetoresistance of the whole sample is similar to the anisotropic magnetoresistance, because the resistance of the two microscale thin film ferromagnetic electrodes is much higher than that of the local nano-region in the middle of the samples. Comparing the experimental results for the thin film ferromagnetic nanoconstrictions and the thin ferromagnetic film reveals that the magnetoresistance of the local nano-region in the middle of the sample is much higher than that of the two microscale thin film ferromagnetic electrodes attached to it.