中频反应磁控溅射Al2O3薄膜的光学性质

采用中频反应磁控溅射技术在玻璃基片上制备了Al2O3薄膜,提出了一种利用透射光谱来简单有效地分析弱吸收薄膜的光学特性及与光学相关的其他物理特性的方法.对Al2O3薄膜进行透射谱测量,通过对薄膜折射率、吸收系数、膜厚度与入射光波长相互关系的分析,获得了Al2O3薄膜在400~1 100 nm区域内的折射率、吸收系数与入射光波长的关系式,以及Al2O3薄膜厚度的计算公式.     

基于Profibus总线的薄膜生产线的设计

论文介绍了双向拉伸聚丙烯（BOPP）薄膜的生产方法及工艺流程,并根据控制要求设计了BOPP薄膜生产线控制系统.在上位机设计了基于WinCC的监控界面,便于系统调试和用户设定参数 在下位机以西门子CPU 414为控制器,应用Profibus总线控制其他功能模块（如变频器、ET200M等）,使得系统很好地满足生产线的自动控制要求.     

氧化锌透明导电膜的光电性能研究

采用磁控溅射法在载玻片上制备出Al3 掺杂型ZnO透明导电薄膜.对不同厚度薄膜的光电性能进行了研究.结果表明,所制备的薄膜随着厚度的增加,透过率略有下降;ZnO薄膜在可见光区的吸光度很小,对可见光几乎不吸收.     

非线性耦合力作用下转子系统混沌行为分析

研究了具有非线性局部碰摩力和油膜力耦合作用下转子-定子系统的分叉与混沌运动,利用计算机仿真对某发动机转子的碰摩及油膜故障进行了数值模拟,讨论了转子系统参数的变化对转子混沌运动状态的影响,发现了具有非线性碰摩力及油膜力的局部耦合作用下转子系统的各种多周期运动和混沌运动及其演变过程,为大型旋转机械的故障诊断提供参考。     

镍诱导纳米晶硅薄膜的生长

采用磁控溅射方法制备了含镍过渡层的富纳米晶硅二氧化硅薄膜．对薄膜退火后的微观结构和发光性能进行了试验分析．结果表明,在高温退火后,有Ni过渡层的富纳米晶硅薄膜较没有Ni过渡层的薄膜具有更高的纳米晶硅密度和更强的室温光致发光强度．对试验结果进行热力学分析后,认为NiSi2作为纳米晶硅的形核中心诱导了薄膜的分相和纳米晶硅生长．     

超级电容器RuO_2·nH_2O电极材料的热处理工艺

以RuCl_3·3H_2O水溶液为电沉积液,采用直流一示差脉冲组合电沉积技术制备超级电容器用钽基RuO_2·nH_2O薄膜阴极材料.借助扫描电镜、X射线衍射仪和电化学分析仪,研究RuO_2·nH_2O薄膜的微观形貌、物相结构、循环伏安和充放电性能.实验结果表明:RuCl_3H_2O先驱体经热处理后转变成RuO_2·nH_2O薄膜,呈不定形结构时能获得较大的比电容;随着热处理温度的升高,薄膜材料的附着力提高,RuO_2·nH_2O薄膜由不定形结构向晶体结构转变,随之薄膜的比电容下降;在300℃热处理的RuO_2·nH_2O薄膜电极材料,其比电容为466 F/g,薄膜与钽基体的附着力为11.3 MPa,薄膜的单位面积质量为2.5 mg/cm~2,1 000次充放电循环后比电容为循环前的93.1%.     

氧化硅基底负载TiO2薄膜的制备及其光催化应用研究

以钛酸丁酯为钛源，乙酰丙酮和冰醋酸为水解抑制剂，聚乙二醇为致孔剂，制备了一种稳定的TiO₂水溶胶。采用浸渍提拉法将TiO₂溶胶负载到活化的载玻片上，再经180℃水热或500℃煅烧得到TiO₂薄膜催化剂。采用扫描电子显微镜（SEM）、原子力显微镜（AFM）、透射电子显微镜（TEM）、X射线晶体衍射（XRD）和Raman光谱等分析手段对样品进行了表征，结果表明：TiO₂薄膜是由粒径为8~12 nm的球形颗粒组成的多孔结构，其晶型为结晶度良好的锐钛矿。以甲基橙为光降解物，在紫外灯下测试薄膜的光催化性能，结果显示煅烧处理的TiO₂薄膜催化剂的光催化活性优于水热处理，对低浓度甲基橙的降解效率达90%以上，并且多次重复使用后光催化活性基本保持不变。     

Magnetoresistance of the thin film ferromagnetic nanoconstrictions

The magnetoresistance and I-V characteristics at different temperatures of the thin film ferromagnetic nanoconstrictions of variable width (from 20 to 250 nm) and 10 nm thicknesses, fabricated by electron beam lithography and vacuum thin film deposition are compared. The magnetoresistance and resistance of the thin film ferromagnetic nanoconstrictions are not related to the width of the nanoconstrictions. Instead the resistance of the local nano-region in the middle of the thin film ferromagnetic nanoconstriction has only a minor role compared to that of the two microscale thin film ferromagnetic electrodes, which contribute the majority of the measured resistance. The magnetoresistances of the thin film ferromagnetic nanoconstrictions and a 0.2 cm × 0.8 cm thin ferromagnetic film deposited under the same conditions were also compared; the thin film ferromagnetic nanoconstrictions have higher magnetoresistances than the thin ferromagnetic film, which implies that the measured magnetoresistance of the thin film ferromagnetic nanoconstrictions comes mainly from the local nano-region in their centers. In conclusion, the measured magnetoresistance of the whole sample is similar to the anisotropic magnetoresistance, because the resistance of the two microscale thin film ferromagnetic electrodes is much higher than that of the local nano-region in the middle of the samples. Comparing the experimental results for the thin film ferromagnetic nanoconstrictions and the thin ferromagnetic film reveals that the magnetoresistance of the local nano-region in the middle of the sample is much higher than that of the two microscale thin film ferromagnetic electrodes attached to it.     

中国三维动画电影与动画设计师

随着计算机软、硬件的不断发展,三维动画电影,作为艺术与技术的高度结合体,逐渐成为动画领域的新型产物,备受动画设计师们的高度关注.通过阐述中国三维动画电影的本质特征,并对其现状进行深入分析,找出它与动画设计师的关系所在,并针对存在的问题,提出几点提高动画设计师综合技能的建设性的思考.     

Biomimetic fluorapatite films for conservation of historic calcareous stones

Fluorapatite protective films were prepared on marble substrates using a biomimetic method. By mimicking the mineralization mechanism of enamel, phosphorus and fluorine were introduced on the surface of the marble substrate. In the presence of a biological template, namely collagen, an integrated fluorapatite film was produced and the marble substrate was entirely covered. The prepared fluorapatite films were characterized by scanning electron microscopy (SEM), X-ray diffraction (XRD), and energy dispersive X-ray (EDX) spectroscopy. The performances of the fluorapatite films were evaluated by color changes, capillary water absorption, and acid resistance tests. The results revealed that the fluorapatite films had good compatibility with the marble substrate; the physical properties such as color and capillary water adsorption of the marble substrates were unchanged. The fluorapatite films also had good acid resistance and were stable even in heavy acid rain.