载荷预估在火控稳像系统中的应用

研究火控稳像系统实际产品的振动故障，应用载荷预估原理提出了一种控制陀螺仪振动的新方法，证实了其有效性与技术的上的可行性，为元件的筛选提供了依据。     

苯甲醛生产中氯含量的分析方法

确定了分析条件:用铂丝作催化剂,样品在氧气中燃烧;样品的质量为10mg;6％H_2O_2用量为10mL;0.5％KOH用量为2mL。采用本法,分析时间仅需20min(老方法需1h);使用的分析仪器和药品均为常用且简单的;平均误差为0.015％,平均偏差为0.05％。该法解决了由氯化苄生产苯甲醛反应的终点控制问题。     

FSH和氯■酚对猕猴超数排卵及异体授精的影响

本实验对ＦＳＨ及大剂量氯酚诱发猕猴超数排卵的效果以及两种药物对新捕获野生猕猴和多年圈养猕猴之间排卵效应和体外授精进行观察分析，结果表明ＦＳＨ每只１ｍｇ／ｄ诱发超数排卵的效果比氯酚每只５０～１００ｍｇ／ｄ效果好．氯酚诱发超数排卵的效应与剂量不呈正比．圈养的猕猴对氯酚的反应较新捕获猕猴高．两侧卵巢的卵泡发育存在交替优势现象，同一只动物两次诱排实验中间隔一次月经周期后，其卵巢对药物诱发超排效果反应良好．超排不影响猕猴的正常生育能力．用兔输卵管进行异体授精，因卵回收率低而影响成功率     

商南-商城断裂带中段大型韧性走滑剪切带研究

商南－商城断裂带中段的韧性剪切带是由多条糜棱岩带及其所夹的变质岩块体组成的大型韧性剪切带。它是以简单剪切为主要变形机制的、于绿片岩相温压条件下形成的韧性剪切带。剪切带内糜棱岩的塑性变形和恢复重结晶作用强烈。糜棱叶理产状多较陡倾，ａ线理近水平，表明为走滑断裂。大量不对称旋转构造指示该剪切带早期为左行剪切，后期在不同地段又叠加上程度不同的右行剪切     

Preparation and performance of a cold gas dynamic sprayed high-aluminum bronze coating

By mixing preheated high-aluminum bronze powders with different amounts of Al₂O₃ powder, a low-pressure cold-sprayed coating was prepared and sprayed onto a Cr12MoV steel substrate. The hardness of the coating and the bonding strength between the coating and the substrate were tested with a HV-1000 microhardness tester and a mechanical universal testing machine. The surface microstructure, cross-section and tensile fracture surface of the coating were observed with a scanning electron microscope (SEM). Correspondingly, the influences of the preheat treatment temperature of the bronze powder and the Al₂O₃ content on the coating performance were investigated. The results indicate that the hardness of bronze powders decreased and the coating deposition rate increased after the preheating treatment of the bronze powder. The Al₂O₃ content in the mixed powders contributed to the deformation of bronze powders during the spraying process. This trend resulted in varied performance of the coating.     

以典型产品带动专业课实践教学改革

介绍了金属材料专业课实践教学改革的思路和过程,围绕培养学生工程能力和创新精神,以典型产品带动专业课理论和实践教学,实现实践教学环节和内容的贯通,建立由多个环节有机组成的实践教学体系,通过综合性、工程性、设计性、创造性的实践教学,以科研生产促进实践教学开展,丰富和完善各个实践教学环节并突出能力培养,从而有利于学生提高工程实践能力及创新精神。     

常利率下信用风险模型的破产问题

对常利率下的信用风险模型进行了研究,运用概率论的分析方法得到了该模型下有限时间内破产概率和破产时间分布所满足的积分方程.进一步通过对破产概率的分析,得出破产前一时刻的瞬时盈余分布和破产时刻余额分布所满足的递推积分方程,完善了Yang Hailiang的相关问题的结果.     

Effects of AlN on the densification and mechanical properties of pressureless-sintered SiC ceramics

In the present work, Si C ceramics was fabricated with Al N using B_4 C and C as sintering aids by a solid-state pressureless-sintered method. The effects of Al N contents on the densification, mechanical properties, phase compositions, and microstructure evolutions of as-obtained Si C ceramics were thoroughly investigated. Al N was found to promote further densification of the Si C ceramics due to its evaporation over 1800 °C,transportation, and solidification in the pores resulted from Si C grain coarsening. The highest relative density of 99.65% was achieved for Si C sample with 15.0 wt% Al N by the pressureless-sintered method at 2130 °C for 1 h in Ar atmosphere. Furthermore, the fracture mechanism for Si C ceramics containing Al N tended to transfer from single transgranular fracture mode to both transgranular fracture and intergranular fracture modes when the sample with 30.0 wt% Al N sintered at 1900 °C for 1 h in Ar. Also, Si C ceramics with 30.0 wt% Al N exhibited the highest fracture toughness of 5.23 MPa m~(1/2) when sintered at 1900 °C.     

几种光产酸剂产酸效率的测定

溴酚兰水溶液的紫外吸收会随着体系中含酸的量发生变化,在440 nm吸收峰处一定浓度范围内溴酚兰水溶液的吸光度与溶液中酸浓度成正比,可由此测定酸浓度.用这种方法测定了3种不同类型的光产酸剂在聚乙二醇膜层中在低压汞灯(254 nm)照射下的产酸量.其中三嗪光产酸剂的光照产酸能力最强.     

太阳电池填充因子随日照强度变化的理论分析与计算

根据太阳电池直流模型和最大功率点数学条件,推出短路电流、开路电压、最大功率点电流和电压 以及填充因子随日照强度变化的数学关系式;并选取２个电池分别计算出在不同日照强度下上述电池参数随日 照强度的变化率。验证了短路电流和最大功率点电流是近似跟日照强度成正比,开路电压和最大功率点电压是 近似跟日照强度的自然对数成正比。并提出了填充因子随日照强度的变化关系不具有简单的函数形式,而对不 同的太阳电池其变化关系也迥异。最后用Multisim的模拟结果检验了理论分析计算的正确性。