西秦岭南带中志留统的岩石学特征与沉积环境

详细研究了西秦岭南带中志留统岩石学特征,对遭受重结晶作用的碳酸盐岩进行了结构成因分类。分析了该区中志留世的沉积环境及变化特征。在该区发现的层孔虫生物礁及其它“浅水”标志,表明志留纪时,为若尔盖微古陆北侧的边缘浅海环境。西部为局限陆棚环境,可分为:局限内陆棚、海湾、礁滩-泻湖-潮坪(孤立台地)等亚环境;东部为开阔陆棚环境,可分为浅海砂滩、内陆棚、外陆棚等亚环境。     

稀土高碳当量灰口铸铁组织与性能的研究

本文研究了利用稀土合金改善高碳当量灰口铸铁质量的可能性,稀土合金对高碳当 量灰口铸铁组织和性能影响的规律,以及稀土夹杂物在铸铁各相中分布的规律．发现了 稀土合金加入量与铸铁的机械性能之间明显的对应关系——“双峰值效应”。对稀土高 碳当量灰口铸铁的某些高温机械、物理、化学性能进行了研究。结果表明稀土合金加入 到高碳当量灰口铸铁中以后能净化铁水,改善组织,并提高其性能．     

盾构隧道围岩与衬砌协同作用纵向位移计算法

盾构机掘进过程中,千斤顶顶进力的不均匀引起的纵向位移是管片间初始错台的主要原因之一;基于Timoshenko梁理论的隧道纵向位移计算方法,未能考虑隧道开挖后围岩卸载破坏的变形特征及围岩与衬砌结构的协同作用效应,预测误差较大。建立了考虑围岩卸载扩容效应的等效地基抗力系数计算方法,提出了能考虑螺栓个数的等效抗剪刚度计算公式,建立一种基于Timoshenko梁理论的改进管片拼装式隧道纵向位移理论计算方法。实际工程案例分析表明：考虑围岩开挖卸载过程中围岩的非线性体积相关塑性变形（即扩容效应）更合理;考虑壁后注浆液固化过程的时效性,采用改进的滑移边界条件计算的纵向位移最大值是传统的固定端边界的计算值的2.3倍,边界条件对计算结果影响较大,本文计算方法更符合实际情况,也更安全。     

地面突风对通航飞行器的影响及数值模拟研究

突风一直以来都是危及飞行安全的重要气象要素之一,造成国民经济和人民生命财产的损失。利用常规观测资料、ADWR-X多普勒气象雷达资料和ERA5逐小时再分析资料,对四川盆地西部一次爆发性大风过程中风场的精细化特征、成因及对飞行的影响进行诊断和模拟研究,结果表明：此次大风过程风速增长快,爆发性强。地面风速自午后开始出现4次波动,且每一次波动期间风速峰值呈增加趋势,时间呈缩短趋势。由于第4次波动风速呈爆发性增加,最大瞬时风达到了16.1 m/s,地面风速脉动值超过5 m/s,致使跑道区域内流场的不稳定性增加,起降跑道侧风值超过了中小型飞行器的起降标准。高空动量下传对本次大风过程中风速的爆发性增加起主导作用。中层强偏南气流与低层偏北急流配和,中层辐合以及低层辐散下沉的垂直结构使得低层下沉气流异常强劲,将900～850 hPa的大风核快速向地面传导。通过天气研究与预报(weather research and forecasting, WRF)模式四重嵌套对本次过程进行模拟,表明WRF对盆地西部冷空气补充南下引起的在风速演变趋势、风速最大值和大风影响时段的风向有较好的模拟能力,对飞行起飞和着陆有一...     

反应装甲爆轰阶段对射流干扰机理的研究

对射流与反应装甲相互作用的机理进行了分析和研究,建立了反应装甲在爆轰阶段干扰射流的数学模型,对“卵石模型”进行了简化和进一步定量化,推导了反应装甲运动的前、后板栏截射流的周期公式,提出了射流受反应装甲干扰后的后效穿深及干扰效率的计算方法,并与实验进行了对比．     

烟酸钕Nd2(C5H4NCOO)6(H2O4的晶体结构

从ＬｎＡｌａＮＡ溶液（Ｌｎ＝Ｎｄ,Ａｌａ＝Ｌ－丙氨酸,ＮＡ＝烟酸）中得到烟酸钕晶体,其晶体结构用四元Ｘ射线衍射技术测定。化合物为二聚体结构,属单斜晶系,Ｐ２１／ｃ空间群,晶胞参数：ａ＝９．６８６（２）,ｂ＝１１．９９６９（１１）,ｃ＝１７．２２０６（１３）,β＝９２．５５０（９）°,Ｖ＝１９９９．２（４）３,Ｚ＝２,Ｄｃ＝１．８１６ｍｇ／ｍ３。Ｎｄ配位数为８,配位多面体为畸变四方反棱柱。     

Genomic organization of EDSV strain AA-2

The genomic organization of egg drop syndrome virus strain AA-2 isolated in China is reported here. The genome was found to be 32 838 bp in length, approximately 2 kb shorter than those of the human subgenus C adenoviruses. Analysis of open reading frames indicated that the genes for major viral structural proteins (55 K, Penton base, pⅦ, pⅩ, pⅥ, Hexon, 100 K, pⅧ and Fiber), as well as EP, DNA polymerase and ⅣaⅡ are present in the expected locations in the genome. EDSV possesses no identifiable E3 and E4 regions and most proteins encoded by E3 and E4 regions of other adenoviruses genome were not presented in EDSV.     

Identification and classification of subspecies of Asian cultivated rice and their hybrids

Having reviewed the major classification systems proposed by various scholars across the world, it is found thatindica andjaponica underO. sativa L. are two major directions thoroughly differentiated from the Asian cultivated rice, forming the framework of the classification structure. A system withindica andjaponica as the only two subspecies is therefore reiterated. There are various ways to determine the indica-japonica identity of hybrid rice, but the “combined morphological trait index” (CMT index) method is more efficient and easier to handle, although the isozyme analysis, molecular marker analysis and grain quality assay methods are also feasible.     

Relationship between giant magnetoresistance of NiFe/Cu multilayers and their microstructures

The (111)-orientated NiFe/Cu multilayers were prepared by magnetron sputtering method. At room temperature, saturation magnetoresistances of NiFe/CU multilayers oscillate as a function of Cu spacer layer thickness. Two peak GMR values of 19.4%, 11.6% and 11.2%, 1% appear, respectively, at Cu sublayer thickness of t_Cu,= 1.0, 2.2 nm while the deposition pressures are 0.25 and 0.45 Pa. X-ray small-angle reflections and diffuse scattering at Cu K-edge (8.979 keV) by synchrotron radiation source were used to characterize the interfacial roughness. Diffraction anomalous fine-structure scattering (DAFS) was performed to investigate the local structure of NiFe and Cu sublayers. Results show that the deposition pressure has effect on interfacial roughness of the samples obviously, and the interfacial roughness also affects the GMR values of the samples strongly.     

酚醛树脂泡沫材料的填充改性及其性能研究

用氢氧化铝粉末对泡沫酚醛树脂材料进行填充改性,并对其主要性能进行研究．结果表明,填充改性能提高酚醛泡沫材料的抗压强度,其导热系数随温度和密度的升高而增大,泡沫材料在深冷情况下表现出优异的绝热性能．同时对酚醛泡沫材料的燃烧性能进行了考察,其临界氧指数高达４７,在高于１５０℃环境温度中有自燃的危险,１５０℃以下可安全使用．