Interferon therapy: side effect scare hits French trials

The French Ministry of Health, acting on the advice of its scientific council, has halted clinical trials of interferon in cancer patients after four out of eleven recipients died of myocardial infarctions. Trials are expected to resume after the domestically produced drug stock is repurified and successfully retested. It has been suggested that council oversight should be extended to imported interferon and other experimental drugs which are now being used in human trials without the Ministry's control or knowledge.     

环路热管启动特性的实验研究

通过大量的实验研究了蒸发器内气液分布、反重力工作高度、启动热载荷的大小、热沉温度等因素对启动的影响, 描述并分析了4种不同蒸发器内气液分布情况下的启动现象, 给出了系统温度变化曲线图, 分析了启动的难易程度. 根据实验数据得出结论: (ⅰ) 对于液体干道内充满液体的启动情况, 储液器温度上升的主要原因并不是漏热, 而是回路压力升高所致. (ⅱ) 热载荷大有利于启动. (ⅲ) 未完全绝热时小热载荷下热沉温度不影响启动. (ⅳ) 环路热管在反重力情况下启动时, 当蒸汽槽道存在蒸汽时, 所需启动时间、启动温升增大; 而蒸汽槽道充满液体时, 所需时间、过热度和启动温升都减少. 实验还观察到了反重力启动时呈现两种启动方式的特别现象.     

Fe/Cr(001)超晶格层间耦合和自旋极化的第一性原理计算

采用基于密度泛函理论的平面波赝势法对Fe／Cr（001）起晶格的层间耦合和自旋极化进行了系统地研究．结果表明：理想Fe／Cr超晶格的层间耦合随反铁磁Cr层层数的增加呈短周期性振荡；在较稳定的结构中，整个Cr层都以较大的磁矩被极化，且极化程度受铁磁层原子数的影响较大．     

The fate of injectant coal in blast furnaces: The origin of extractable materials of high molecular mass in blast furnace carryover dusts

The aim of the work was to investigate the fate of injectant coal in blast furnaces and the origin of extractable materials in blast furnace carryover dusts. Two sets of samples including injectant coal and the corresponding carryover dusts from a full sized blast furnace and a pilot scale rig have been examined. The samples were extracted using 1-methyl-2-pyrrolidinone (NMP) solvent and the extracts studied by size exclusion chromatography (SEC). The blast furnace carryover dust extracts contained high molecular weight carbonaceous material, of apparent mass corresponding to 10⁷?10⁸ u, by polystyrene calibration. In contrast, the feed coke and char prepared in a wire mesh reactor under high temperature conditions did not give any extractable material. Meanwhile, controlled combustion experiments in a high-pressure wire mesh reactor suggest that the extent of combustion of injectant coal in the blast furnace tuyeres and raceways is limited by time of exposure and very low oxygen concentration. It is thus likely that the extractable, soot-like material in the blast furnace dust originated in tars is released by the injectant coal. Our results suggest that the unburned tars were thermally altered during the upward path within the furnace, giving rise to the formation of heavy molecular weight (soot-like) materials.