蒲菜中矿质元素和水溶性维生素的检测与分析

通过ICP-AES和HPLC测定了新鲜蒲菜中15种矿质元素和6种水溶性维生素的含量.结果显示在新鲜蒲菜中K、Ca、Mg、Mn、Sr、Zn、Se及Cr等元素的含量较高,尤其是Mn和Sr元素远高于其他蔬菜,而Pb、Cd、As及Hg元素含量极低,维生素C、烟酸、烟酰胺的含量也较高.表明蒲菜是一种营养丰富且具有一定保健功能的蔬菜.     

Magnetic fabrics in fault-related fold and its relation with finite strain: an example from Mingjiang thrust structures in Western Sichuan

The anisotropy of magnetic susceptibility (AMS) is a quick, effective and sensitive technique used to measure the weakly deformed sedimentary rocks, and also a reliable method to reveal the deforming mechanisms of fault-related folds. In Longmenshan front belt, a typical cross-section of fault-related folds is chosen to study the AMS. A total of 224 oriented specimens have been drilled at 23 different sampling sites which were distributed at the key structural positions of this structural section developed in the Xujiahe formation of the upper Triassic. Six elementary types of magnetic fabrics are recognized and established through this AMS study: 1) a sedimentary fabric; 2) an initial deformation fabric; 3) a pencil structure fabric; 4) a weak cleavage fabric; 5) a strong cleavage fabric; 6) a stretching lineation fabric. It has been found that most of magnetic fabrics are characterized by fabrics of weak deformation which belong to the pure-shear results of a pre-folding layer parallel shortening (LPS). In the fault-bend fold, almost all magnetic fabrics are the initial deformation fabrics of weak deformation, and denote that the deformation in the forelimb is stronger than that in the backlimb and no finite strain is shown in the footwall. While in the fault-propagation fold， finite strains are concentrated in the trishear zone where magnetic fabric results are approximately consistent with the estimated consequences of the kinematic model. The tectonic stress field indicated by the magnetic fabrics is basically the same along the whole structural section and shows a NW to SE compression and shortening which is accordant with the regional compressive stress field of the Longmenshan fold-thrust belt.     

和谐边疆构建下的宗教渗透问题研究——基于对云南跨境民族的田野调查

通过对云南跨境民族地区的田野调查,该区域宗教渗透不仅没有停止,反而呈现出多样性、隐蔽性等特点。宗教渗透对跨境民族的国家政治认同等造成了严重破坏,对云南边疆社会的稳定构成了较大的威胁,成为了云南边疆地区非传统安全问题中最敏感、最复杂、最难解决的问题之一。抵御宗教渗透不仅要完善政府宗教管理能力、改善经济条件等,更要调动作为文化主体者的跨境民族自身的文化自觉,以主动抵御宗教渗透。只有如此才是最有效的抵御宗教渗透举措,才最终有利于和谐边疆的构建。     

尼莫地平对蛛网膜下腔出血大鼠脑功能的改善作用

目的探讨尼莫地平对SAH大鼠脑功能改善作用,并分析相关机制.方法采用枕大池二次注血法建立大鼠SAH模型,通过神经行为学评分,经颅多普勒超声检测基底动脉的平均血流速度,HE染色法观察脑形态学改变,脑含水量检测分析尼莫地平对SAH的治疗机制.结果与假手术组相比,SAH组大鼠出现明显的神经运动功能障碍体征,其神经行为学评分明显降低;与SAH组相比,尼莫地平组大鼠神经运动功能障碍体征明显减轻,神经行为评分明显高于SAH组.颅超声多普勒检测结果表明:SAH组大脑基底动脉血流速度明显加快,而经过尼莫地平治疗后,其血流速度明显降低;HE染色发现:SAH组大鼠脑中可见明显的出血灶,神经元数目减少,神经元及神经胶质出现肿胀,尼莫地平能够明显减轻SAH后的脑损伤;大鼠SAH时,脑水含量明显增加,尼莫地平既能减轻血管源性脑水肿症状,又减轻细胞毒性脑水肿症状.结论尼莫地平能改善神经运动功能障碍,其机制与降低基底动脉血流速度、减轻神经细胞、胶质细胞肿胀及减轻脑水肿有关.     

盐蚀环境下沥青结合料化学组分及性能演化

为更好地认识盐蚀环境下沥青路面的性能损伤机理,在实验室内模拟除冰盐、融雪剂形成的盐蚀环境对沥青结合料的侵蚀作用。采用沥青四组分试验和原子力显微镜(AFM)试验评价沥青的化学组分及表面微纳观形貌特性。开展针入度、软化点、延度和粘度试验,探讨盐蚀环境下沥青结合料的性能演化情况。结果表明：在氯盐溶液中干湿循环和冻融循环处理后,沥青中的饱和分和芳香分含量减少,沥青质和胶质含量增加。沥青结合料表面粗糙度和蜂形结构面积百分比出现不同程度的下降。在盐蚀环境下,沥青结合料的针入度和延度均有不同程度的下降,软化点和粘度出现不同程度的升高。沥青结合料性能劣化的主要原因是在盐蚀环境中沥青的化学组分发生改变,出现一定程度的“盐老化现象”。     

基于完全集成经验模态分解和模糊熵分频的短期风电功率预测

随着风电接入电力系统的比例日益增大,准确的风电功率预测显得愈发重要。为此,提出了一种基于模糊熵和完全集成经验模态分解(complete ensemble empirical mode decomposition with adaptive noise,CEEMDAN)的短期风电功率预测模型。采用完全集成经验模态分解将原始风电功率序列进行分解,得到一系列不同频率的子序列。再使用模糊熵(Fuzzy Entropy,FE)算法识别各频率分量特征,将子序列分量分为高、中频分量类和趋势项。趋势项为低频分量,具有较为平稳,波动性小的特点,采用麻雀算法(sparrowSsearch algorithm,SSA)优化支持向量回归(support vector regression,SVR)进行预测;高、中频分量的波动性大且特点较为复杂,则采用SSA优化长短期记忆神经网络(Long Short-Term Memory,LSTM),同时引入注意力机制(Attention Mechanism,AM)对重要信息进行更好的权值分配。最后,经过实验结果分析表明,该模型具有更高的风电功率预测精度。     

抗粘、耐酸汽车钢化玻璃油墨的制备与性能

采取自制的调墨油、耐酸钢化颜料黑(低熔点玻璃粉和高温陶瓷黑色素的混合物)和助剂制备了抗粘、耐酸的汽车钢化玻璃油墨,进行了同步热分析,并采用SEM和XRD研究了烧结温度和时间对油墨釉层表面析晶、表面形貌及其对釉层光泽度和耐酸性的影响,确定了油墨的最佳烧结温度和时间.结果显示:低熔点玻璃粉的软化点为512℃,与调墨油树脂的最终分解温度(470℃)较接近,从而在600～700℃的烧结温度范围内可以充分熔融流动并代替树脂作为连结料;钢化颜料黑在579.4℃开始析晶,起到了降低油墨烧结温度和抗粘的作用;采用SEM和XRD研究了烧结温度和时间对油墨釉层表面析晶、表面形貌及对釉层光泽度和耐酸性的影响,确定了油墨的最佳烧结温度和时间分别为660℃和4 min;所制备的油墨具有良好的抗粘性、耐酸性以及较好的光泽度.     

Sinorhizobium meliloti lsrB is involved in alfalfa root nodule development and nitrogen-fixing bacteroid differentiation

Rhizobia interact with host legumes to induce the formation of nitrogen-fixing nodules, which is very important in agriculture and ecology. The development of nitrogen-fixing nodules is stringently regulated by host plants and rhizobial symbionts. In our previous work, a new Sinorhizobium meliloti LysR regulator gene (lsrB) was identified to be essential for alfalfa nodulation. However, how this gene is involved in alfalfa nodulation was not yet understood. Here, we found that this gene was associated with prevention of premature nodule senescence and abortive bacteroid formation. Heterogeneous deficient alfalfa root nodules were induced by the in-frame deletion mutant of lsrB (lsrB1-2), which was similar to the plasmid-insertion mutant, lsrB1. Irregular senescence zones earlier appeared in these nodules where bacteroid differentiation was blocked at different stages from microscopy observations. Interestingly, oxidative bursts were observed in these nodules by DAB staining. The decreased expression of lipopolysaccharide core genes (lpsCDE) was correspondingly determined in these nodules. S. meliloti lipopolysaccharide is required for suppression of oxidative bursts or host cell defense. These findings demonstrate that the S. meliloti lsrB gene is involved in alfalfa root nodule development and bacteroid differentiation by suppressing oxidative bursts or defense responses in host cells.     

考虑热负荷的活塞形状优化设计

给出一种受热负荷作用的结构形状优化设计方法并编制相应的优化软件,     

绳驱动并联清洗机器人绳索张力优化

将绳驱动并联机器人应用至外墙清洗领域,并对清洗机器人的动力学建模及张力优化进行深入研究。首先,确定机器人的构型为完全约束绳驱动并联机器人,并建立了考虑绳索弹性的动力学模型;其次,针对该类型绳驱动并联机器人绳张力解不唯一问题,提出将相关力改进的最小方差作为优化目标对绳索张力进行优化。最后,通过Simulink-Adams进行联合仿真验证。结果表明,优化后的绳索张力光滑连续变化。系统开环的情况下,圆形轨迹最大误差均值为0.071 m,终点误差均值为5.15 mm;直线轨迹最大误差均值为9.25 mm,终点误差均值为3.5 mm。解决了完全约束绳驱动并联机器人绳索张力不唯一、不连续问题,并为控制策略研究提供理论依据。