整机老炼条件的优化设计

本文通过工程实例，阐述如何利用现有信息来设计产品的老炼条件，以使它在保证产品达到规定可靠性的前提下尽量节省成本     

Pb-Sn-Bi三元系α相固溶体的点阵参数

应用X射线衍射法测定了Pb-Sn-Bi三元系Pb基α相固溶体的点阵参数,发现点阵间距与成分呈线性变化,对两批实验数据分别进行回归分析,得到点阵参数-浓度关系的统一解析式: α=0.49495X_(Pb)+0.47813X_(Sn)+0.50629X_(Bi)。其F检验置信度大于99.9％,残余标准差σ=6.4×10~(-5) nm,分析点阵畸变的影响因素表明尺寸效应是控制固溶体点阵行为的主要因素。     

A High Speed Detection Scheme for Point Targets in a Multitarget Environment

The purpose of this paper is to develop a high speed detection scheme for moving and / or stationary point targets in a multitarget environment as registered in an IR image sequence. An iterative approximate 3-D line searching algorithm based upon the geometric representation of lines (for non-maneuvering targets in space) in a 3-D space is derived. The convergency of the algorithm is proved. An analysis is performed of the theoretical detection performance of the algorithm. The statistical experiment results show high effectiveness and computational efficiency of the algorithm in the case of low SNR. The idea may be employed to satisfy the real-time processing requirement of an IR system.     

煮糖汁汽加热器故障分析及防止措施

本文对糖厂用煮糖汁汽加热器的不锈钢换热管与管板连接焊缝产生的裂纹和换热管横向断裂问题,进行全面的理论分析,並结合具体情况,提出一些可行的防止焊缝裂纹和管子横向断裂的主要措施。     

三价钕与绕丹宁（RACP）及其衍生物二元体系配合物的电位滴定法研究

本文运用电位滴定法与ＴＩＴＦＩＴ程序研究了２９８Ｋ下，三价钕与新型荧光试剂配合物的稳定性，并得出其相应的络合常数。     

向量变分不等式解的存在性

利用广义向量平衡问题解的存在性结论，给出了向量变分不等式解的存在性定理。     

钢液定氧测头响应时间和热平衡态

本文分别研究了ＺｒＯ２（ＭｇＯ）固体电解质管头壁厚，参比电极量对定氧测头响应时间的影响，得出了以ＺｒＯ２管头壁厚为０．６０－０．８０ｍｍ，Ｃｒ／Ｃｒ２Ｏ３参比电极加入量为４０－６０ｍｇ所组成的定氧测头响应速度最快，同时采用了“双偶法”对定氧测头在工作过程中的热平衡态进行了研究。结果表明：氧浓差电池中的传热是响应过程的控速步骤，氧电势曲线上峰值的产生是起源于电池中的热平衡态。     

Radar Imaging Based on Iterative Algorithms

It has long been realized that the problem of radar imaging is a special case of image reconstruction in which the data are incomplete and noisy. In other fields, iterative reconstruction algorithms have been used successfully to improve the image quality. This paper studies the application of iterative algorithms in radar imaging. A discrete model is first derived, and the iterative algorithms are then adapted to radar imaging. Although such algorithms are usually time consuming, this paper shows that, if the algorithms are appropriately simplified, it is possible to realize them even in real time. The efficiency of iterative algorithms is shown through computer simulations.     

反应条件及添加惰性物质对三聚甲醛合成反应的影响

研究了三聚甲醛合成过程进料浓度、催化剂用量等对副产物（特别是甲酸）生成行为的影响。结果表明，该体系副产物的生成强烈地依赖于反应时间和催化剂硫酸的用量，而与原料浓度的波动无关。在反应－精馏过程的反应器中添加惰性高沸有机物，可有效地缩短反应物的停留时间，提高三聚甲酸的选择性，大大降低快速反应－精馏过程对反应器的设计要求。