济南市城市垃圾资源化途径研究

城市垃圾资源化是目前世界各国面临的共同挑战,城市垃圾因其产生量大,处理技术落后等原因造成了严重的环境问题,在分析济南市城市垃圾现状、危害以及资源化潜力的基础上,提出了济南市必须采取综合利用的垃圾资源化途径以及实现垃圾资源化的保障措施。     

Simulation of dynamic recrystallization for an Al-Zn-Mg-Cu alloy using cellular automaton

A cellular automata (CA) model has been developed to predict and control the microstructure evolution during hot deformation on 7085 aluminum alloy. The initial microstructure and thermal-mechanical parameters were used as the input data of the CA model. To link microstructure evolution with macroscopic flow stress, dislocation density was set as an important internal state variable. The hot deformation behavior of 7085 aluminum alloy was studied by isothermal compression tests under a deformation temperature range of 623–723 K and a strain rate range of 0.001-1s^?1 up to true strains of 0.53–1.20. Electron backscattered diffraction technique and the CA model were utilized to systematically investigate the effects of strain, strain rate and deformation temperature on the microstructure evolution, and further to predict the average grain diameter and the recrystallization fraction after deformation. The simulated results were validated by the experimental data to demonstrate the feasibility and predictability of the CA model.     

井身结构设计必封点综合确定方法研究

在对库车地区深井超深井井下复杂情况分析的基础上，综合考虑地层岩性和地层压力等影响因素，根据已有资料，用随机理论方法确定发生井下复杂情况的概率密度函数，得出井下复杂情况发生的位置及可能性，提出新的井身结构必封点确定方法。应用实例表明，用随机理论方法确定井下复杂情况是可行和有效的，井身结构设计中必封点的确定原则并不惟一，设计者应根据经验和实际情况加以取舍。     

中华绒螯蟹酚氧化酶原系统与颤抖病的关系

近年来,颤抖病给中华绒螯蟹养殖业造成了巨大的经济损失.酚氧化酶原系统是甲壳动物最主要的体液免疫系统,当外源微生物侵入体内时,它发挥最基本的免疫防御作用来抵抗感染.酚氧化酶原系统的变化是蟹类健康状况的重要指标.prophenoloxidase和peroxinectin是酚氧化酶原系统中两个重要的体液免疫分子.实验从分子和蛋白两个水平研究了中华绒螯蟹酚氧化酶原系统与颤抖病的关系,建立了一种新的通过测定酚氧化酶原系统活性来判断蟹体质状况的方法.在分子水平上,中华绒螯蟹体液免疫分子prophenoloxidase和peroxinectin的部分基因序列被克隆和测序,并检测出这两种分子mRNA水平的表达情况与颤抖病的感染程度呈正相关,患病组蟹mRNA的表达水平远高于正常组;在蛋白水平上,酚氧化酶的活性被测定,在正常情况下,蟹体内酚氧化酶活性处于低水平状态,当被感染颤抖病后,酚氧化酶活性有一定程度的升高.这些结果提示了酚氧化酶原系统在抗颤抖病感染时起重要作用,为进一步研究预防和治疗颤抖病的新途径提供了理论依据.     

First principles studies on the electronics structures of (Li<Subscript>1−<Emphasis Type="Italic">x</Emphasis></Subscript>Me<Subscript><Emphasis Type="Italic">x</Emphasis></Subscript>)FePO<Subscript>4</Subscript> (Me=Na and Be)

Based on density functional theory (DFT) of the first-principle for cathode materials of lithium ion battery, the electronic structures of (Li_1?x Me _x )FePO₄ (Me=Na and Be, x=0–0.40) are calculated by plane wave pseudo-potential method using Cambridge serial total energy package (CASTEP) program. The calculated results show that Li-site doping can improve the electronic conductivity enormously. Doping with Na has a noticeable effect on improving its electrical conductivity. However, serious structural distortion will occur when its doping density is beyond 0.25. In view of this, the best density of doping Na is less than 0.25. Doping with Be has an inconspicuous effect on increasing its electrical conductivity and has good cyclical stability, but it cannot achieve as good results as when it is doped with Na. Therefore we cannot find a middle ground between the two proposals. Considering cost and environmental protection, it is ideal to choose Na. So this method gives a reasonable prediction to the improvement of electronic conductivity through Li-site doping in LiFePO₄ material.     

Stochastic differential equation software reliability growth model with change-point

This paper presents software reliability growth models （SRGMs） with change-point based on the stochastic differential equation （SDE）.Although SRGMs based on SDE have been developed in a large scale software system,considering the variation of failure distribution in the existing models during testing time is limited.These SDE SRGMs assume that failures have the same distribution.However,in practice,the fault detection rate can be affected by some factors and may be changed at certain point as time proceeds.With respect to this issue,in this paper,SDE SRGMs with changepoint are proposed to precisely reflect the variations of the failure distribution.A real data set is used to evaluate the new models.The experimental results show that the proposed models have a fairly accurate prediction capability.     

一类非线性发展方程的耦合周期解

文章利用具有e-凹凸性混合单调算子的性质,讨论了非线性发展方程存在耦合周期解存在的充要条件,并给出了耦合周期解的迭代收敛序列,为此类发展方程是否具有耦合周期解提供了一种判别方法,克服了以往只给出充分条件的局限性．     

弱含水地层青山组火山岩地下水分布规律及解决缺水问题探讨

白垩系青山组火山岩是弱含水岩层,但在有利的岩性与构造的作用下,可以形成相对富水地段,通过物探固定小MN装置测深法与地质分析相结合,已打出一批好机井,从而解决了该区严重缺水问题。     

ZnO/WO_3纳米片薄膜的光电催化性能研究

采用水热法在不锈钢基底上制备WO3纳米片阵列,然后将其浸渍于不同浓度Zn(NO_3)_2溶液中以负载ZnO纳米颗粒,从而制备出ZnO/WO_3纳米片薄膜。采用场发射扫描电镜(FESEM)、X射线衍射(XRD)、X射线光电子能谱(XPS)、紫外-可见吸收光谱(UV-Vis)和电化学阻抗图谱(EIS)等方法对ZnO/WO_3复合薄膜的形貌、结构、物相组成和光电性能等进行分析,重点考察了薄膜电极对亚甲基蓝(MB)的光电催化降解性能。结果表明,WO_3纳米片均匀垂直于基底生长,Zn元素以ZnO颗粒的形式分布在WO_3表面;ZnO的引入促进了WO_3中产生的光生电子-空穴对的分离,从而使ZnO/WO_3复合薄膜表现出比纯WO_3薄膜更优异的光电性能和光电催化活性;在Zn(NO_3)_2浸渍液浓度为20mmol/L时,所制ZnO/WO_3复合薄膜具有最佳的光电催化性能,在MB溶液初始浓度为10mg/L、外加偏压为0.8V、光照1h的条件下,采用该样品对MB的降解率达96.5%,并且复合薄膜具有良好的循环稳定性,在重复使用5次后,对MB的光电催化降解效率没有明显降低,有望在实际污水处理中得到应用。     

气隙式膜蒸馏法分离浓缩透明质酸水溶液的研究

介绍了应用气隙式膜蒸馏分离技术对透明质酸热敏性水溶液的浓缩分离情况. 结果表明, 使用膜孔径为0.2μm的聚四氟乙烯微孔疏水膜可使原料液的浓度提高1.6倍以上, 透明质酸截留率为80%以上. 探讨了循环时间、平均温差、热侧温度等条件对分离效果的影响, 并讨论了膜蒸馏过程热效率的变化规律.