Effect of particle size distribution on the microstructure,texture,and mechanical properties of Al–Mg–Si–Cu alloy

The effect of particle size distribution on the microstructure,texture,and mechanical properties of Al–Mg–Si–Cu alloy was investigated on the basis of the mechanical properties,microstructure,and texture of the alloy.The results show that the particle size distribution influences the microstructure and the final mechanical properties but only slightly influences the recrystallization texture.After the pre-aging treatment and natural aging treatment(T4 P treatment),in contrast to the sheet with a uniform particle size distribution,the sheet with a bimodal particle size distribution of large constituent particles and small dispersoids exhibits higher strength and a somewhat lower plastic strain ratio(r) and strain hardening exponent(n).After solution treatment,the sheet with a bimodal particle size distribution of large constituent particles and small dispersoids possesses a finer and slightly elongated grain structure compared with the sheet with a uniform particle size distribution.Additionally,they possess almost identical weak recrystallization textures,and their textures are dominated by CubeND {001}310 and P {011}122 orientations.     

高压天然气管道喷射火热辐射计算

天然气燃爆喷射火事故可能造成人员建筑严重损害,为研究大型天然气喷射火燃爆特性,使用CFD计算软件,对质量流量在5 kg/s以上,压力分别为12 MPa与6 MPa,泄漏孔径在25 mm、50 mm与100 mm时的高压天然气喷射火进行仿真,得到这六种工况下喷射火火焰尺寸、温度分布和近地热辐射强度分布曲线,并得到喷射火长度与宽度和泄漏孔直径的线性变化关系.与喷射火常用的Thornton模型对比,仿真结果计算的火焰长度基本符合,热辐射结果在泄漏中心30 m以外基本相近,两种方法都可用于估算远距离喷射火热辐射强度,为天然气设施安全设计提供参考.     

UHPLC-MS/MS法同时测定大鼠血浆中汉黄芩素、隐绿原酸和白杨素-7-O-葡萄糖醛酸苷含量

建立了UHPLC-MS/MS同时测定大鼠血浆中的汉黄芩素、隐绿原酸和白杨素-7-O-葡萄糖醛酸苷含量的方法。以芹菜苷为内标,采用ACQUITY UPLC HSS T3色谱柱(2.1 mm×100 mm, 1.8 μm),乙腈和0.1％甲酸溶液为流动相,流速为0.2 mL·min^-1。结果表明,汉黄芩素、隐绿原酸和白杨素-7-O-葡萄糖醛酸苷线性范围为1～1 000 ng·mL^-1(R2>0.99),最低定量浓度为1 ng·mL^-1,提取回收率、基质效应均符合生物样品分析要求。建立的方法灵敏、准确,可用于大鼠血浆中汉黄芩素、隐绿原酸和白杨素-7-O-葡萄糖醛酸苷的测定及其药代动力学研究。     

Effect of cold rolling process on microstructure and mechanical properties of high strength β titanium alloy thin sheets

The microstructure and mechanical properties of Ti-3.5Al-5Mo-6V-3Cr-2Sn-0.5Fe high strength titanium alloy sheets prepared by unidirectional cold rolling and two-step cross cold rolling were investigated. Results showed that the β phase grains were refined significantly by cold rolling followed by solution treatment for a short time.Compared to unidirectional cold rolling, the short time solution treatment after two-step cross rolling could significantly reduce the non-uniformity of the microstructure of the alloy sheets. After aging treatment at 550 ℃,the anisotropy of the mechanical properties still existed in the unidirectional rolled sheets, and the tensile strength was highest along the rolling direction. After solution and aging treatment, the anisotropy of the mechanical properties of the two-step cross rolling process sheet was not obvious than unidirectional cold rolling,and alloy had good strength and plasticity matching.     

The hidden disintegration of cluster heterogeneity in Fe-based glass-forming alloy melt

The evolution of liquid metal at high temperature is known much less than their solid states. This is partially due to that the message concerning clusters, metastable phase or heterogeneity in liquid is usually too slight to be traced. Here, we shed some light on the nature of structural evolution of Fe-based glass-forming alloy during overheating process by the investigation of high-temperature melt viscometry and first principles simulations. It was found that a structural transition around 1400 ℃ occurred in the melts of initial homogeneous ingot, heterogeneous ingot and amorphous ribbons jointly, and was confirmed by the results from differential scanning calorimeter(DSC), and ab initio molecular dynamics(AIMD). Combining these results with Fe-Si-B ternary phase diagram and the melting characteristics of Fe-B compounds, it is safe to conclude that the disintegration of Fe_2B type clusters to Fe_3B-type clusters leads to the observed transition. These results offer a significant reference for the preparation and property control of Fe-based amorphous alloys.     

我国高校图书馆创客服务存在的问题与对策

高校图书馆开辟创客空间,提供创客服务是在大众创业、万众创新时代浪潮的推动下必然需求。通过调研与比较国内外典型高校图书馆提供的创客服务,分析我国高校图书馆创客服务存在的问题,提出对策与建议,以期为国内高校图书馆提供借鉴与启示。     

Description of rotational properties of the superheavy nucleus ^256,258,260Rf by projected shell model

Band structure of the Z = 104 nucleus 256Rf has been a recent research focus in nuclear physics. We performed projected shell model calculations for this and some other neighboring Rf isotopes. Specifically, we studied rotational properties of these nuclei and showed that variations in dynamic moment of inertia were sensitive to single-particle structures, which may be useful information for locating the anticipated island of stability. Electromagnetic transition properties were also calculated, and measurable quantities were predicted for further experimental test.     

"一带一路"中国地方性政策的文本量化研究

"一带一路"对世界经济及我国民生的发展和改善发挥了积极作用,自"一带一路"实施以来,中国多个相关省、自治区、直辖市围绕自身特点积极布局,发布了一系列地方性"一带一路"相关政策.文章基于关键词词频—逆文件频率(TF-IDF),对中国"一带一路"沿线各省、自治区、直辖市在2014—2020年颁布的"一带一路"相关的政策文本进行量化分析和研究,通过可视化关键词的地理分布和构建的关键词网络发现,社团内部地区间的政策相似性主要并不取决于权重较大的关键词,而是由更多较小权重关键词共同决定的.文章还利用显性比较优势(RCA)进一步量化了各地的政策关键词的显性差异,得出各省、自治区、直辖市在政策关注上具有不同侧重的结论.     

父母陪伴与小学生完成作业质量的关系研究

采用自编问卷探讨父母陪伴与小学生完成作业质量的关系。结果发现:父母陪伴孩子作业相对于不陪伴情况有利于提高小学生完成作业的质量;父母耐心指导作业的陪伴方式可以提高小学生作业质量;父母经常陪伴孩子作业可以提高小学生作业质量;父母文化水平和家庭经济条件影响父母陪伴孩子作业的时间。