多环节冲击测量系统方波响应时间的计算

实际的冲击高电压测量系统，通常由多个不同特性的环节组成．作者以最简洁的数学推导式，表达了多环节测量系统方波响应时间的计算方法。借助于这一计算方法．讨论了方波源波形非理想时，它对实际方波响应时间测量值的影响。所提出的反映原始方波质量的技术指标，可比“上升时间”更易确定，而且实用性强．     

地下感应式通信理论的研究

本文研究了地下矿井内,电波沿巷道内线缆传播的可行性及单线波模的传播与衰减规律,研究巷道内电小天线与线缆之间的耦合情况,从而为实际工作提供理论依据。     

杂环基二硅烷的合成与波谱表征

由2—噻吩基锂和N-吡咯格氏试剂分别与氟五甲基二硅烷反应,制得了2—噻吩基、五甲基二硅烷(Ⅰ)和N-吡咯基五甲基二硅烷(Ⅱ)。两种二硅烷都是无色液体。Ⅰ在室温下空气中是稳定的,Ⅱ在空气中逐渐转变成绿褐色。元素分析,IR,~1H MR和MS分析证实了其结构。Ⅰ和Ⅱ的最大紫外吸收峰分别为242.0nm和220.1nm。     

偏最小二乘紫外分光光度法同时测定萘，1－甲基萘和蒽

用偏最小二乘法（ＰＬＳ）进行校正和预测，不经分离同时测定了混合体系中的萘，１－甲基萘和蒽。萘，１－甲基萘和蒽的浓度分别在０～２８ｍｇ／Ｌ，０～４０ｍｇ／Ｌ和０～４０ｍｇ／Ｌ的浓度范围服从比耳定律。对合成样品中这三种组分进行分析，结果令人满意。     

阶段原型法及其支持环境

本文介绍了阶段原型法(SPA)及其支持环境(PEMIS)的总体结构和主要功能,探讨了知识库和推理机制在循环控制中的作用,以及软件重用技术、图形接口技术和应用生成技术等实现技术。     

A study of macromolecular diffusion through native porcine mucus.

A diffusion chamber technique based on time-lag analysis for the estimation of effective diffusion coefficients of radiolabelled macromolecules of varying molecular weights through native mucus gel is reported. For all solutes studied, a reduction in effective diffusion coefficients was observed with a retardation of solute flux in both aqueous and mucus layers. Over the molecular weight range of solutes investigated (126-186,000 Daltons), a consistent effect of molecular weight was evident with regard to the retarding effect of mucus. No apparent or absolute molecular weight cut-off for macromolecular transfer was exhibited. However, at high molecular weights (greater than 30,000 Daltons) the retardation was greatly enhanced. The results confirm that mucus can be regarded as a gel with finite pores, but that it does not constitute an absolute barrier to even high molecular weight solutes.     

利福平菌丝体厌氧生化处理的研究

制药厂生产利福平过程中产生大量的利福平菌丝体,可严重污染环境。用厌氧消化法处理利福平菌丝体,消化温度40℃,反应器容积负荷2KgCOD/m~3·d,液料滞留期(SRT)14～20天,取得了良好的处理效果。COD去除率稳定在90％左右,BOD_5去除率达到95％以上,产气率达到0.49m~3/去除KgCOD。     

THE INFLUENCE OF SPINNING CONDITION ON STRUCTURE & PROPERTIES OF MASS-DYED SUPERFINE PP AS-SPUN FILAMENTS

The effect of colorant additive on the rheology of PP polymer melt and the influence of spinning conditions on the crystalline and orientation structure of mass-dyed as-spun PP filament are reported. The △E~~~ value for all colored chips is higher than that of blank chip to a varying degree. The crystallinity and orientation degree of dyed PP as-spun filament decrease with increasing melt temperature, decreasing spinning speed and increasing denier per filament (dpf), while the crystallinity of dyed as-spun filament increases with the content of colorant additive as a nucleation agent.     

水电工程规划设计方案的自动生成及评价

本文介绍了在水电工程规划设计时，如何利用三次自然样条插值函数在有限个方案的基础上自动生成无限多个方案，然后采用多目标综合决策模型在其中选择最优方案的一种方法．文中还给出了程序流程，并以某水电站正常蓄水位选择作为实例，对方法进行了验证，结果与专家决策完全吻合．