Spheroidization of silica powders by radio frequency inductively coupled plasma with Ar–H_2 and Ar–N_2 as the sheath gases at atmospheric pressure

Amorphous spherical silica powders were prepared by inductively coupled thermal plasma treatment at a radio frequency of 36.2 MHz. The effects of the added content of hydrogen and nitrogen into argon(serving as the sheath gas), as well as the carrier gas flow rate, on the spheroidization rate of silica powders, were investigated. The prepared silica powders before and after plasma treatment were examined by scanning electron microscopy, X-ray diffraction, and laser granulometric analysis. Results indicated that the average size of the silica particles increased, and the transformation of crystals into the amorphous state occurred after plasma treatment. Discharge image processing was employed to analyze the effect of the plasma temperature field on the spheroidization rate. The spheroidization rate of the silica powder increased with the increase of the hydrogen content in the sheath gas. On the other hand, the spheroidization rate of the silica power first increased and then decreased with the increase of the nitrogen content in the sheath gas. Moreover, the amorphous content increased with the increase of the spheroidization rate of the silica powder.     

Effect of Cr2O3 addition on oxidation induration and reduction swelling behavior of chromium-bearing vanadium titanomagnetite pellets with simulated coke oven gas

The oxidation induration and reduction swelling behavior of chromium-bearing vanadium titanomagnetite pellets (CVTP) with Cr₂O₃ addition were studied, and the reduction swelling index (RSI) and compressive strength (CS) of the reduced CVTP with simulated coke oven gas (COG) injection were investigated. The results showed that the CS of the CVTP decreases and the porosity of the CVTP increases with increasing amount of Cr₂O₃ added. The Cr₂O₃ mainly exists in the form of (Cr, Fe)₂O₃ solid solution in the CVTP and as Fe-Cr in the reduced CVTP. The CS of the reduced CVTP increases and the RSI of the reduced CVTP decreases with increasing amount of Cr₂O₃ added. The limited aggregation and diffusion of metallic iron contribute to the formation of dense lamellar crystals, which leads to the slight decrease for reduction swelling behavior of reduced CVTP. This work provides a theoretical and technical basis for the utilization of CVTP and other Cr-bearing ores such as chromite with COG recycling technology.     

Complete stabilization of severely As-contaminated soil by a simple H2O2 pre-oxidation method combined with non-toxic TMT-15 and FeCl3·6H2O

The stabilization of severely As-polluted soil has been a challenge, especially for the extremely toxic As(Ⅲ) contaminants. In this study, soil with a high As concentration (26084 mg/kg) was availably stabilized by a H₂O₂ pre-oxidation assisted TMT-15 (Na₃S₃C₃N₃ solution with a mass fraction of 15%) and FeCl₃·6H₂O stabilization method. The results showed that the combination of the two stabilizers (i.e., TMT-15 and FeCl₃·6H₂O) presented a better stabilization behavior than either stabilizer used individually. The use of the H₂O₂ pre-oxidation assisted TMT-15 and FeCl₃·6H₂O stabilization approach not only converted the As(Ⅲ) to As(V) but also reduced the toxic leaching concentration of As to 1.61 mg/L, which is a safe level, when the additions of TMT-15 and FeCl₃·6H₂O were 2 mL and 0.20 g, respectively. Thus, using only a simple H₂O₂ pre-oxidation to combine clean stabilization with non-toxic stabilizers TMT-15 and FeCl₃·6H₂O could render the severely As-contaminated soil safe for disposal in a landfill.     

Spheroidization of silica powders by radio frequency inductively coupled plasma with Ar-H2 and Ar-N2 as the sheath gases at atmospheric pressure

Amorphous spherical silica powders were prepared by inductively coupled thermal plasma treatment at a radio frequency of 36.2 MHz.The effects of the added content of hydrogen and nitrogen into argon (serving as the sheath gas),as well as the carrier gas flow rate,on the spheroidization rate of silica powders,were investigated.The prepared silica powders before and after plasma treatment were examined by scanning electron microscopy,X-ray diffraction,and laser granulometric analysis.Results indicated that the average size of the silica particles increased,and the transformation of crystals into the amorphous state occurred after plasma treatment.Discharge image processing was employed to analyze the effect of the plasma temperature field on the spheroidization rate.The spheroidization rate of the silica powder increased with the increase of the hydrogen content in the sheath gas.On the other hand,the spheroidization rate of the silica power first increased and then decreased with the increase of the nitrogen content in the sheath gas.Moreover,the amorphous content increased with the increase of the spheroidization rate of the silica powder.     

Publisher's Erratum to: Spheroidization of silica powders by radio frequency inductively coupled plasma with Ar-H2 and Ar-N2 as the sheath gases at at-mospheric pressure

In this article the corresponding author is incorrectly given as Lin Li instead of Guo-hua Ni who is the actual corresponding author.     

Synthesis, Characterization and Calorimetry of Ni（C4H8N2O3）2Cl2

A coordination complex was synthesized from NiCl2 and dipeptide glycylglycine（GG）. It was characterized by element analysis, NMR and TG methods, and then was determined to be Ni（C4HsN2O3）2Cl2. Using an isoperibolic reaction calorimeter, the standard molar enthalpy of formation of Ni（GG）2Cl2（solid） has been determined to be -（1 674.66±2.02） kJ · mol^-1 at 298.15 K.     

Shear-thinning behavior of the CaO-SiO2-CaF2-Si3N4 system mold flux and its practical application

Satisfying the mold-flux performance requirements for high-speed continuous casting necessitates the development of a new non-Newtonian-fluid mold flux with shear-thinning behavior, i.e., a mold flux whose viscosity is relatively high under lower shear rates and relatively low under higher shear rates. In this work, a mold flux that exhibits shear-thinning behavior was developed by adding different amounts of Si₃N₄ to the CaO-SiO₂-CaF₂ mold flux. The shear-thinning behavior was investigated using a rotational viscometer. In addition, the microstructure of the newly prepared slags was studied by high-temperature Raman spectroscopy and X-ray photoelectron spectroscopy. The results showed that the mechanism of shear-thinning was attributable to a temporary viscosity loss caused by the one-way shear stress, whereas the corresponding magnitude of shear-thinning was closely related to the degree of polymerization (DP). Finally, the non-Newtonian fluid mold flux was used for laboratory casting tests, which revealed that the mold flux could reduce slag entrapment and positively affect the continuous casting optimization.     

Fabrication of porous alumina templates with a large-scale tunable interpore distance in a H<Subscript>2</Subscript>C<Subscript>2</Subscript>O<Subscript>4</Subscript>-C<Subscript>2</Subscript>H<Subscript>5</Subscript>OH-H<Subscript>2</Subscript>O solution

Highly ordered porous alumina templates with a large-scale tunable interpore distance （100-445 nm） have been successfully fabricated under an electric field of 40-180 V by modifying oxalic acid solution with adequate alcohol. The results under our experimental conditions show that the phenomena of burning and breakdown during the high-field anodization process can be avoided by adding a proper amount of alcohol to the oxalic acid solution. An excellent linear relationship between interpore distance and anodization voltage is obtained under 40-170 V, and the maximum anodization voltage that could be used to avoid burning and breakdown is 180 V.     

Synthesis, characterization and properties of ruthenium-substituted polyoxometallic acid H_6Ru(H_2O)FeW_(11)O_(39)·18H_2O with Keggin structure

The ruthenium-substituted polyoxometallic acid H6 [Ru(H2O)FeW 11O39 ]·18H2O was synthesized by stepwise acidification and stepwise addition of solutions of the component elements, and an ion-exchange-cooling method. The product was characterized using inductively coupled plasma spectrometry (ICP), Infrared Spectroscopy (IR), Ultraviolet Spectroscopy (UV), and X-ray diffraction (XRD). The results show that this complex has the Keggin structure. The determination of the thermal stability and proton conductivi...     

Analysis of active sites for N2 and H^＋ reduction on FeMo-cofactor of nitrogenase

Dinitrogen (N2) and proton (H ),which act as physiological substrates of nitrogenase,are reduced on FeMo-co of the MoFe protein. However,researchers have different opinions about their exact reduction sites. Nitrogenases were purified from the wild type (WT) and five mutants of Azotobacter vinelandii (Av),including Qα191K,Hα195Q,nifV-,Qα191K/nifV- and Hα195Q/nifV-; and the activities of these en-zymes for N2 and H reduction were analyzed. Our results suggest that the Fe2 and Fe6,atoms closed to the central sulfur atom (S2B) within FeMo-co,are sites for N2 binding and reduction and the Mo atom of FeMo-co is the site for H reduction. Combining these data with further bioinformatical analysis,we propose that two parallel electron channels may exist between the 8Fe7S cluster and FeMo-co.     

Mineral-phase evolution and sintering behavior of MO-SiO2-Al2O3-B2O3 (M=Ca,Ba) glass-ceramics by low-temperature liquid-phase sintering

In this work, network former SiO₂ and network intermediate Al₂O₃ were introduced into typical low-melting binary compositions CaO·B₂O₃, CaO·2B₂O₃, and BaO·B₂O₃ via an aqueous solid-state suspension milling route. Accordingly, multiple-phase aluminosilicate glass-ceramics were directly obtained via liquid-phase sintering at temperatures below 950℃. On the basis of liquid-phase sintering theory, mineral-phase evolutions and glass-phase formations were systematically investigated in a wide MO-SiO₂-Al₂O₃-B₂O₃ (M=Ca, Ba) composition range. The results indicate that major mineral phases of the aluminosilicate glass-ceramics are Al₂₀B₄O₃₆, CaAl₂Si₂O₈, and BaAl₂Si₂O₈ and that the glass-ceramic materials are characterized by dense microstructures and excellent dielectric properties.     

ENSO frequency change in coupled climate models as response to the increasing CO<Subscript>2</Subscript> concentration

The response of ENSO frequency to the increasing CO2 concentration and associated mechanism are examined with outputs of four coupled climate models (GFDL/CM2.0,CNRM/CM3,IPSL/CM4 and INM/CM3.0) submitted to the IPCC Fourth Assessment Report (IPCC AR4).Results reveal a significant change of ENSO frequency as response to the increasing CO2 concentration.However,such a change exhibits an evident model dependence.The ENSO frequency tends to increase in GFDL/CM2.0 and CNRM/CM3 models and decreases in IPSL/CM4 an...